Panasonic C-HDM-133 Installation guide

Panasonic C-HDM-133 Installation guide
8
6
7
5
4
3
2
1
INSTALLATION INSTRUCTIONS:
1. PLACE LOWER BRACKET ONTO DESIRED
MOUNTING SURFACE. USING THE (4X) HOLES ON THE
BOTTOM FACE OF THE LOWER BRACKET, DRILL 4
HOLES INTO THE MOUNTING SURFACE WITH A 9/32"
DRILL BIT (OR ANY OTHER DRILL BIT WHICH GIVES A
HOLE DIAMETER BETWEEN 0.26" AND 0.28").
UPPER BRACKET
D
D
2. PLACE THE PINCH BARS UNDERNEATH THE
MOUNTING SURFACE. FASTEN THE LOWER BRACKET,
MOUNTING SURFACE, AND PINCH PLATES TOGETHER
USING (4X) 1/4-20 X 3/4" HEX BOLTS AND #12 FLAT
WASHERS.
3. PLACE THE UPPER BRACKET OVER THE LOWER
BRACKET, AND FASTEN TOGETHER USING (4X) 1/4-20
X 3/4" HEX BOLTS, #12 FLAT WASHERS, AND 1/4-20
NYLON-INSERT NUTS.
C
NOTE: WHEN FASTENING UPPER BRACKET TO
LOWER BRACKET, USE (2X) BOLTS IN REAR OF
BRACKET FIRST, THEN ADJUST UPPER BRACKET TO
DESIRED ANGLE AND FASTEN TOGETHER USING THE
OTHER (2X) BOLTS IN THE ANGLE ADJUSTMENT
HOLES.
LOWER BRACKET
C
4. TIGHTEN ALL FASTENERS TO THE APPROPRIATE
INDUSTRY STANDARD.
1/4-20 X 3/4" HEX BOLT
#12 FLAT WASHER
(ANGLE ADJUSTMENT HOLES)
B
B
PINCH PLATE
1/4-20 X 3/4" HEX BOLT
#12 FLAT WASHER
1/4-20 NYLON-INSERT NUT
HARDWARE KIT CONTENTS:
DATE
PRODUCT I.D.
C-HDM-133
10-30-09
PRODUCT NAME
A
WARNING: ALL HAVIS INC. PRODUCTS ARE DESIGNED WITH SAFETY OF USE AND INSTALLATION IN MIND. HOWEVER,
IT IS THE SOLE RESPONSIBILITY OF THE OWNER/OPERATOR OF A VEHICLE USING HAVIS INC. MOUNTING AND
DOCKING EQUIPMENT, TO INSURE THAT THE EQUIPMENT IS INSTALLED SO THAT IT WILL NOT INTERFERE WITH VEHICLE
OPERATION, INTERFERE WITH SAFETY DEVICES, OBSTRUCT VIEW OF DRIVING CONDITIONS, OR IN ANY WAY
DEGRADE OCCUPANT SAFETY. IMPROPER INSTALLATION CAN CAUSE SERIOUS INJURY IN THE EVENT OF AN
ACCIDENT. INSTALLATION SHOULD ONLY BE PERFORMED BY QUALIFIED PROFESSIONALS. COMPUTERS AND
MOTION DEVICES MUST BE MOVED TO AND STOWED/SECURED IN THEIR SAFE DRIVING POSITIONS BEFORE
OPERATING VEHICLE.
DRAWING NUMBER:
C-HDM-133-INST
8
7
6
5
4
ANGLE MOUNTING
BRACKET
PRODUCT DESCRIPTION
WEIGHT: (LBS)
USED TO MOUNT OTHER HAVIS PRODUCTS
ON AN ANGLE SURFACE BETWEEN 5 AND 45
DEGREES (IN INCRIMENTS OF 5 DEGREES).
6.78
REV. DATE
1-800-524-9900
WWW.HAVIS.COM
3
2
1
F-730-019 REV A
A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement