Aluratek ABH02F User guide

Aluratek ABH02F User guide
On Ear Controls
Bluetooth Wireless Stereo Headphones
Quick Start Guide
Operation
Charging the battery
The battery is not fully charged and it is highly recommended that you charge ABH02F
before you begin using it.
Microphone
Note: Using ABH02F “out of the box” will not harm the device. You will experience reduced battery life as the
unit will not be fully charged.
Answer Call / End Call /
Power ON / Power OFF /
Pair Bluetooth Device
Connect the USB end of the cable provided to your PC / power adapter. Connect the
other end to the charging port of ABH02F. Please charge the battery for a minimum of
(4) hours. The Red LED will be on while charging. When charging is complete, the
red LED will turn Blue.
Next Track
Previous Track
Play / Pause
Volume Control
aluratek.com
Operation
LED Indicator
Enter Pairing
Mode
Ensure ABH02F is turned OFF. Press and
hold
button for 8 seconds.
Red and Blue LED
flashes rapidly
Power Off
Press and hold the
LED flashes 3 times.
LED OFF
button until the blue
Charging Jack
ABH02F
qsg Q10254
Function
Copyright © 2012 Aluratek, Inc. All Rights Reserved.
Operation
Tech Support & Warranty Information
Note: The pairing mode will last 2 minutes. ABH02F will switch to the standby mode
automatically if no devices can be connected within 2 minutes.
If you need further assistance, please contact the Aluratek support department for
troubleshooting prior to returning this device.
Pairing with the transmitter such as iPhone, smart phone, and tablet:
The pairing procedure will vary depending on the actual device. Please refer to the
user guide of your device for detail instruction. The general pairing procedures are
as follows:
E-mail: [email protected]
Web: www.aluratek.com/support
Local (Tustin, CA): 714-586-8730
Toll free: 1-866-580-1978
1. Activate ABH02F pairing mode by press and hold the
button for 8 seconds.
(Red and Blue LED will flash rapidly)
2. Activate your device’s Bluetooth function and set your device to search for Bluetooth
devices. Select ABH02F when it is found.
3. For transmitter with Bluetooth version 2.1, you will not need to input a code. If you
are prompted for PIN, please enter “0000”.
4. If prompted by your device to connect, please select “Yes”.
5. After connecting successfully, the blue LED will flash every 6 seconds.
Note: Please make sure the audio output is set to Bluetooth / ABH02F for audio
streaming from the device.
Aluratek warrants this product against defect in material or workmanship for
1 Year from the date of purchase.
For more information, please visit: http://aluratek.com/warranty-return-policy
You can register your product online at: http://aluratek.com/product-registration
Radio and TV Interference Statement
WARNING!!! This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by whatever measures may be
required to correct the interference.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement