TOA TZ-105 EU manual

INSTRUCTION MANUAL
COLUMN SPEAKERS
TZ-105, TZ-205
Thank you for purchasing TOA's COLUMN SPEAKER.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAFETY PRECAUTIONS
3. INSTALLATION PRECAUTIONS
• Be sure to read the instructions in this section carefully before
This column speaker features a drain
hole built into same panel that holds
the speaker cord. For proper
drainage, during installation please
ensure that this panel faces down
toward the ground.
use.
• Make sure to observe the instructions in this manual as the
conventions of safety symbols and messages regarded as
very important precautions are included.
• We also recommend you keep this instruction manual handy
for future reference.
WARNING
Indicates a potentially hazardous situation which, if
mishandled, could result in death or serious personal
injury.
• Install the speaker only in a location that can structurally
support the weight of the speaker and the mounting
bracket. Doing otherwise may result in the unit falling
down and causing personal injury and/or property
damage.
(This figure shows the TZ-105.)
4. INSTALLATION
Step 1. Mount the supplied top and bottom mounting brackets
to the mounting surface.
Note
No hardware has been provided
for installation of the mounting
brackets. Therefore, please
prepare the necessary nuts, bolts
and washers before beginning
installation.
CAUTION
• Do not stand or sit on, nor hang down from the speaker
as this may cause it to fall down or drop, resulting in
personal injury and/or property damage.
ø9 (0.35") holes
50 (1.97")
25 (0.98")
Indicates a potentially hazardous situation which, if
mishandled, could result in moderate or minor
personal injury, and/or property damage.
• Do not place heavy objects on the speaker as this may
cause it to fall or break which may result in personal
injury and/or property damage. In addition, the object
itself may fall off and cause injury and/or damage.
Speaker cord
390 (15.35") (TZ-105)
635 (25") (TZ-205)
Mounting bracket
(accessory)
Unit: mm
25(0.98")
Step 2. Using the supplied hexagon bolt, washer, and
mounting gasket, fix the speaker to the top bracket.
• Do not operate the speaker for an extended period of
time with the sound distorting. Doing so may cause the
connected speakers to heat, resulting in a fire.
Hexagon bolt M8 x 15
Plain washer (for M8)
2. FEATURES
The TZ-105 and TZ-205 are column speakers with built-in
identical cone speakers (2 for TZ-105, 4 for TZ-205) vertically
arranged on the baffle boards. They present sound pressure
characteristics in an extremely narrow angle in a vertical plane
and in a wide angle in a horizontal plane.
Mounting gasket
Step 3. Similarly, fix the speaker to the bottom bracket.
Note
When adjusting the speaker angle, use the optional YS-301
Speaker mounting kit.
5. SPEAKER CORD COLOR CODING
Speaker cord
For connections,
refer to the table at right.
Model No.
Rated input
Impedance
Cord color coding
HOT
COM
TZ-105
10 W
5W
1 kΩ
2 kΩ
Black
Blue
White
White
TZ-205
20 W
10 W
500 Ω
1 kΩ
Black
Blue
White
White
6. WIRING DIAGRAM
[TZ-205]
[TZ-105]
8Ω
2 kΩ
4Ω
8Ω
1 kΩ
0
670 Ω
Blue
Black
White
8Ω
5W
8Ω
2 kΩ
4Ω
10 W
1 kΩ
COM
8Ω
Blue
0
670 Ω
8Ω
Black
White
500 Ω
8Ω
COM
10 W
20 W
COM
500 Ω
COM
8Ω
7. SPECIFICATIONS
Model No.
Rated Input
Rated Impedance
Sound Pressure Level
Frequency Response
Speaker Component
Water Resistance
Finish
Dimensions
Weight
Speaker only
Including mounting
bracket
TZ-105
TZ-205
10 W (Max. 15 W)
20 W (Max. 30 W)
100 V line: 1 kΩ (10 W), 2 kΩ (5 W)
100 V line: 500 Ω (20 W), 1 kΩ (10 W)
90 dB (1 W, 1 m)
93 dB (1 W, 1 m)
150 Hz – 10 kHz
12 cm (5") cone-type x 2
12 cm (5") cone-type x 4
IP-X3 equivalent
Enclosure:
Extruded aluminum, silver gray, fully-glazed, baked paint
Grille:
Punched aluminum net, black, matte, baked paint
Mounting bracket: Steel plate, silver gray, fully-glazed, baked paint
167 (w) x 335 (h) x 141 (d) mm
167 (w) x 580 (h) x 141 (d) mm
(6.57" x 13.19" x 5.55")
(6.57" x 22.83" x 5.55")
3.4 kg (7.5 lb)
5.1 kg (11.24 lb)
4 kg (8.82 lb)
5.7 kg (12.57 lb)
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Mounting bracket ................................................ 2
Mounting gasket ................................................. 2
Hexagon bolt M8 x 15......................................... 2
Plain washer (for M8).......................................... 2
Traceability Information for Europe (EMC directive 2004/108/EC)
Manufacturer:
TOA Corporation
7-2-1, Minatojima Nakamachi, Chuo-ku, Kobe, Hyogo,
Japan
Authorized representative:
TOA Electronics Europe GmbH
Suederstrasse 282, 20537 Hamburg,
Germany
URL: http://www.toa.jp/
533-06-016-2C