Timex T110T Operating instructions

Timex T110T Operating instructions
Model T110
Super Loud
Alarm Clock
For additional information, online registration,
and exclusive special offers visit our website:
For questions or comments regarding this or other products,
please call our toll-free number 1-800-888-4491.
Para instruccionese en Espanol, llame al 1-800-888-4491.
Controls and Indicators
Minute Button
Snooze Button
Time Set Button
Hour Button
Alarm Set/Reset Button
Dimmer Switch
Loudness Switch
PM Indicator
Alarm Mode Switch
Alarm lcon
Battery Backup Indicator
1
Battery Backup Installation
It is strongly recommended that a 9-Volt battery be installed into
the unit, as directed below, in order to activate this product’s
Battery Backup feature. In the event that the AC power cord is
disconnected or a power failure or other interruption occurs, the
Battery Backup will maintain clock and alarm settings for the life
of the battery. During any interruptions the clock display will be
blank, but time and alarm settings will be saved and automatically
restored when AC power is again active.
To install the battery:
1. Open the battery compartment
cover.
2. Install one 9-Volt battery
(alkaline is recommended for
longer life), making sure that the
large terminal matches to the
large outlet.
Battery Compartment
The Battery Backup Indicator LED is located in the
lower-right-hand corner of the display. The LED will light when
no battery is installed, or when the installed battery is low on
power.
After installing the battery and reading the Maintenance notes,
plug the AC power cord into an outlet, being sure to match the
wide blade of the plug to the wide slot of the outlet. Never force
the plug into an outlet. When the unit is connected to AC power
for the first time, the display may blink until the time is set.
Note: You should replace the battery every six months, or after
any extended power outage that could drain the battery power.
2
Maintenance
• Place the unit on a level surface away from direct sunlight or
sources of excessive heat.
• Protect your furniture when placing the unit on natural wood
or wood with a lacquered finish. A cloth or other protective
material should be placed between the unit and the furniture.
• Clean the casing with a soft cloth moistened only with mild
soap and water. Stronger cleaning agents, such as thinner,
benzine, or similar materials are not recommended, as they
may damage the surface of the case.
Setting Clock Time and Alarm Time
Setting Clock Time
1. Press and hold the Time Set Button while pressing the Hour
Button until the current hour is displayed. Remember to set
the correct AM or PM setting. A small dot in the
upper-left-hand corner of the display is the PM Indicator.
2. Press and hold the Time Set Button while pressing the
Minute Button until the current time is displayed.
Setting Alarm Time
1. Press and hold the Alarm Set/Reset Button while pressing
the Hour Button until the desired alarm hour is displayed.
Again, remember to set the correct AM or PM setting.
2. Press and hold the Alarm Set/Reset Button while pressing
the Minute Button until the desired alarm time is displayed.
Selecting the Alarm Volume
Set the Loudness Switch to “Loud” or “Gentle” to choose the
alarm buzzer volume.
3
Operating the Alarm and Snooze Features
1. Set the alarm time and volume as described on Page 3.
2. Set the Alarm Mode Switch to “On.” The Alarm Icon will
appear in the lower-left-hand corner of the clock display,
indicating that the alarm has been set and will sound at the
time selected.
Note: The alarm will continue to sound until it is shut off, or for
a maximum of two hours. As long as the Alarm Mode Switch
is set to “On,” the alarm will sound at the set time every 24 hours.
3. After the alarm sounds, press the Alarm Set/Reset Button
to turn off the alarm while automatically resetting it for the
following day.
4. To turn off the alarm without automatically setting it for the
following day, slide the Alarm Mode switch to “Off.” Even
if the Alarm Set/Reset Button was pressed, setting the
Alarm Mode Switch to “Off” will turn off the alarm.
5. To use the snooze feature, press the Snooze Button. The
alarm will turn off for approximately nine minutes before
sounding again. You may repeat this process several times
during the two-hour alarm cycle.
Operating the Dimmer
Use the Dimmer Switch to set the display to either a High or
Low brightness setting.
4
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
The lightning flash with arrowhead in an equilateral triangle is
intended to alert the user of the presence of uninsulated
“dangerous voltage” within the product’s enclosure that may
be of sufficient magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended
to alert the user of the presence of important operating and
maintenance (servicing) instructions in the literature
accompanying the appliance.
The symbols above are located at the bottom of the cabinet.
CAUTION: To prevent electric shock, do not use this (polarized)
plug with an extension cord receptacle, or other outlets unless the
blades can be fully inserted to prevent blade exposure.
ATTENTION: Pour prévenir les chocs électriques ne pas utiliser
cette fiche polarisée avec un prolongateur. Une prise de courant,
ou une autre sortie de courant sauf si les lames peuvent étre
insérées à fond sans en laisser aucune partie à decouvert.
A Consumer Guide to Product Safety
IMPORTANT SAFETY INSTRUCTIONS
When used in the directed manner, this unit has been designed and manufactured to
ensure your personal safety. However, improper use can result in potential electrical
shock or fire hazards. Please read all safety and operating instructions carefully before
installation and use, and keep these instructions handy for future reference. Take special
note of all warnings listed in these instructions and printed on the product.
1. Water and Moisture — The unit should be kept dry and away from water or other
liquids. If liquid is spilled on the unit, or if the unit should fall or be accidentally placed
in or on a wet or damp area, immediately unplug the unit.
2. Ventilation — The unit should be set up in an area and position that does not
interfere with its proper ventilation. Check to see where the ventilation opening is on
the product. Do not set up the unit on a bed, sofa, rug, or similar surface that may
block the opening. Do not keep the unit in a tight-fitting installation, such as a
bookcase or cabinet, which impedes the flow of air through the ventilation openings.
3. Heat — The unit should be situated away from heat sources such as radiators, space
heaters, stoves, or other appliances (including amplifiers) that produce or emit heat.
4. Power Sources — The unit should be connected to a power supply only of the type
described in the operating instructions, or as marked on the appliance.
5. Grounding or Polarization — This unit is equipped with a two-pronged, polarized
alternating-current line plug (a plug having one blade wider than the other). This plug
only fits into your power outlet in one direction. This is a safety feature. If you are
having difficulty inserting the plug fully into your outlet, try reversing the plug blades;
do not force the plug into the outlet. If you are still having difficulty, contact your
electrician to replace your obsolete outlet.
6. Power-Supply Cord Protection — Power-supply cords should be routed so that
they are not likely to be walked on or pinched by items placed upon or against them,
paying particular attention to areas at the outlet and where they exit from the unit.
7. Overloading — Do not overload wall outlets, extension cords, or integral
convenience receptacles as this can result in a risk of fire or electric shock.
8. Cleaning — The unit should be cleaned only as recommended by the manufacturer.
See the Maintenance section of this manual for cleaning instructions.
9. Periods of Nonuse — If the unit is to be left unused for an extensive period of time,
such as longer than a month, the power cord should be unplugged from the outlet.
10. Object and Liquid Entry — Care should be taken so that objects do not fall and/or
liquids do not spill into any openings or vents located on the product.
11. Damage Requiring Service — The appliance should be serviced by qualified service
personnel when:
A. the power-supply cord or plug has been damaged.
B. objects have fallen and/or liquid has been spilled into openings or vents.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
E. the unit exhibits a marked change in performance or does not operate normally.
12. Antenna — The user should not connect an external antenna to the unit.
13. Servicing — The user should not attempt to service the unit beyond those methods
described in the operating instructions. Any servicing not covered in the instructions
should be left to qualified service personnel. Please also see the Warranty Information
for more information on product servicing.
For questions or comments regarding this or other products, please
call our toll-free number: 1-800-888-4491.
Limited 90-Day Warranty Information
Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to
as SDI Technologies), warrants this product to be free from defects in workmanship
and materials, under normal use and conditions, for a period of 90 days from the
date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it
to the store where it was originally purchased. Should this fail to resolve the matter
and service still be required by reason of any defect or malfunction during the warranty
period, SDI Technologies will repair or, at its discretion, replace this product without
charge (except for a $3.00 charge for handling, packing, return UPS/postage, and
insurance). This decision is subject to verification of the defect or malfunction upon
delivery of this product to the Factory Service Center listed below. The product
must include proof of purchase, including date of purchase. The fee for service
after the warranty period or without proof of purchase is $6.00.
Before returning this product for service, please first replace the batteries (if
applicable) with fresh ones, as exhausted or defective batteries are the most
common cause of problems encountered.
If service is still required:
1. Remove batteries (if applicable) and pack the unit in a well-padded,heavy
corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof
of the date of purchase.
3. Enclose a check or money order payable to the order of Soundesign, for the
sum of $3.00 (or $6.00 if after the warranty period or without proof of purchase).
4. Send the unit prepaid to the Factory Service Center listed below:
Consumer Repair Department
SDI Technologies Inc.
Timex Audio Products Division
1401 Pullman Drive, Suite A
El Paso, TX 79936-7726
NOTE: This warranty is valid only if the product is used for the purpose for which
it was designed. It does not cover (i) products which have been damaged by
negligence, misuse or accident, or which have been modified or repaired by
unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive
heat; (iii) damage to CD’s or tape cassettes (if applicable); (iv) the cost of shipping
this product to the Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to
owners of the product subsequent to the original purchaser. Any applicable implied
warranties are also limited to 90 days, and SDI Technologies will not be liable for
consequential damages. (Some states do not allow limitations on implied warranties
or exclusion of consequential damages, so these restrictions may not apply to you.)
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
For questions or comments regarding this or other products, please
call our toll-free number: 1-800-888-4491.
TIMEX is a registered trademark of Timex Corporation in the
United States and other countries.
T110-040503-0
Printed in China
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement