48V Phantom Power Supply
48V Phantom
Power Supply
Model #35-1825
Tightly regulated power supply is highly filtered to provide clean, consistent 48V phantom power
to condenser microphones. Steel housing utilizes rugged metal frame locking XLR connectors,
and is designed for rough stage use. Non–skid rubber feet reliably hold the unit in place.
Directions for Use
Be sure that the Phantom Power Supply is not
connected to a power source prior to connecting to
equipment. The input device, such as amplifier, mixing
console or recording equipment, should also be
powered off. In cases where this is impractical, the
input level (gain) control should be set to minimum
prior to connecting the Phantom Power Supply
phone jack) microphone inputs. When connecting to
such equipment, use a high quality audio adaptor
cable, with a 3-conductor female XLR type connector,
and male 2-conductor 1/4” phone plug, such as MCM
#24-2360 (not included). Connect this cable to the
male XLR connector on the Power Supply marked
(OUT), and to the appropriate input on the recording
equipment, mixer or amplifier.
Connecting to Balanced Inputs
Connecting the Microphone
Connecting to Unbalanced Inputs
Connect the Phantom Power Supply to an appropriate
110~120VAC, 60Hz power source
Turn power on to the connected mixer, recorder or
amplifier, and adjust input gain on that equipment to
the desired level
The Phantom Power Supply is designed to
accommodate balanced microphones and inputs (3-Pin
XLR) on mixing equipment. When connecting to such
equipment, use a high quality balanced, 3-conductor
XLR type cable, such as MCM #24-2300 (not included).
Connect this cable to the male XLR connector on the
Power Supply marked (OUT), and to the appropriate
input on the recording equipment, mixer or amplifier.
The Phantom Power Supply is also suitable for use with
equipment that utilizes unbalanced (2-conductor 1/4”
Specifications
▪Supply voltage: 48VDC
▪Input connection: Female XLR
▪Output connections Male XLR
Use only balanced 3-Pin XLR cable from the
microphone to the Phantom Power Supply. Most high
quality condenser microphones will include the proper
cable for this connection. Connect the microphone to
the 3-pin XLR female connection on the Phantom
Power Supply.
▪Power requirements: 110VAC, 60Hz
▪Dimensions: 1.9" (H) x 3" (W) x 5.5" (D)
MCM an InOne company
650 Congress Park Drive
Centerville, Ohio 45459
www.mcminone.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement