Gamber-Johnson Upper Pole

Gamber-Johnson Upper Pole
INSTALLATION INSTRUCTIONS
Product
7160-0177, 7160-0178
Center Upper Pole Assemblies - 5" & 7"
Revision
REV. A
Form
INST-412
The Center Upper Pole Assemblies are
used with any DS Lower Tubes or DS
Vehicle Bases with an integral lower tube.
Remove the (4) .25-20 x .75 Hex Head
Screws holding the upper bracket to the
tube.
Assemble the Motion Attachment device
being used to the upper bracket as shown,
using the hardware and bearing plates
supplied with the Motion Attachment
device.
Adjust the drag on the swivel motion by
tightening the (3) .25 lock nuts as
required.
Reattach the upper bracket to the tube
with (4) .25-20 x .75 Hex Head Screws
and .25 Flat Washers.
Insert Center Upper Pole Assembly the
into Lower Tube or Vehicle Base being
used .
While holding the Center Upper Pole
Assembly at the desired position, tighten
the center bolt securely with a 9/16"
open-end wrench.
Motion Attachment
(DS-Clevis)
Upper Bracket
Plastic Bearing
Plastic Bearing
Steel Backup
Plate
Tube
Two .3/8" dia holes, are provided as a
strain relief tie down points or for use
with a security cable.
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement