Bluetooth Virtual keyboard (VKB) Quick Start Guide

Bluetooth Virtual keyboard (VKB)
Quick Start Guide
For the full User Guide please refer to the CD menu or to our website.
http://www.itechdynamic.com/html/user_corner.htm
6. At the prompt from the device and/or following the “beep” prompt
from the VKB, key in the same passkey on both the host device
and the VKB. (NOTE: The VKB can only be paired with one
Bluetooth device at a time).
The pairing procedure is completed.
Before using your VKB Virtual Keyboard:
•
•
Your Virtual Keyboard will need to be charged for at least 2
hours.
Ensure that you remove all protective materials including the
protection sheet on the laser windows.
A summary of the set-up procedure:
•
•
•
•
•
•
Insert CD.
Choose device from screen.
Transfer driver file to the device using chosen method: cable,
infra-red, Bluetooth, memory card, etc.
Pair VKB with device.
Run driver program.
Use keyboard.
Installing the software driver on your device
1. Insert the CD to a CD-ROM drive on your computer; this should
run automatically however if it does not start by itself, please
open the CD and run setup.exe.
2. Follow the on-screen instructions and transfer the driver file to
your device using the appropriate method.
Running the VKB Software Driver
7. Locate and click on the VKB icon ( ) which can be
found in the following locations:
• PalmOS5 – under Systems
• PocketPC2003 – under Programs
• SmartPhone2003 – in the Main Menu
• Windows – on the Desktop, Launch Bar or System Tray
• Symbian Series60 – in the Main Menu
• Symbian UIQ2.x - in the Main Menu
8. On the Connection page select the Bluetooth connection for the
VKB.
9. On the VKB page, ensure that the 5 Enable Keyboard
box is checked. At the prompt, "Is the first time
connecting to this keyboard?”, select YES.
Your Bluetooth device is now ready to work with the Virtual Keyboard.
Changing the Settings on your VKB
Pairing the Virtual Keyboard (VKB)
3. Place the VKB on a solid, flat surface and turn on using the
button located on the upper left side of the unit. (NOTE: a microswitch built into the bottom of the VKB will automatically turn it off
when lifted).
4. Begin the Bluetooth pairing process on the device (host) with
which you wish to use your VKB. (If necessary, refer to the
instructions for the host device).
5. Locate and select “VKB Keyboard”.
Please refer to the full VKB User Guide for guidance on how to:
• modify the sensitivity of the keyboard
• adjust the brightness of the keyboard
• set the repeat key delay and frequency
• use shortcut keys on the keyboard
• troubleshoot any issues with use
Ver. 1.1
Preparing the VKB to be paired with a different device
Once the keyboard has been paired and connected to a host
device, to pair the keyboard with a different host device, turn the
keyboard on, and on the projected image press the keys
×+Fn+B simultaneously for 3 seconds. The keyboard will emit a
short beep and the LED will flash blue to indicate it is ready for
pairing with another device.
Ver. 1.1
Ver. 1.1