Scosche Stereo Dash Kits Installation Instructions

Scosche Stereo Dash Kits Installation Instructions
KA2071B
IN-DASH INSTALLATION KIT FOR
2001-2005 KIA DOUBLE DIN
KIA
MOUNTING THE RADIO
DIN RADIO INSTALLATION
1. Snap the 6223L/R brackets to the 6222 kit panel.
2. Align, position and bolt the aftermarket two ISODIN or one Double DIN head unit to the 6222
brackets.Use hardware supplied with radio to secure the mounting brackets.
6223L
LEFT
BRACKET
2003-2005 SORRENTO LX
(Excluding sport models)
2002-2005 SEDONA
2002-2005 RIO
2001-2005 SPECTRA
6223L
MOUNTING
BRACKET
DIN RADIO
6223R
MOUNTING
BRACKET
6222
KIT PANEL
6223R
RIGHT
BRACKET
RADIO REMOVAL
6222
KIT PANEL
2003-2005 SORRENTO LX
RADIO REMOVAL:
INTRODUCTION / PRELIMINARY
This premium installation kit is for 2001-2005 Kia Double DIN vehicles. Included are all the parts you need to
mount your car stereo/cassette or CD player into your vehicle's dash. Refer to the individual instruction in this
manual to remove your vehicle's factory radio and assemble the kit.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP PREVENT
ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHN METER OVER A TEST LIGHT TO CHECK WIRING.
A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S COMPUTER AND/OR
DIAGNOSTIC SYSTEMS. AVOID ALL FACTORY AIRBAG WIRING - AIRBAGS CAN ACCIDENTALLY DEPLOY CAUSING
SERIOUS INJURY OR DEATH.
NOTES:
• See your vehicle's instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
1. Open ashtray and unclip and remove side panels.
2. Extract (8) Philips screws from the radio trim panel the remove the panel.
3. Extract (4) Philips screws securing radio.
2002-2005 SEDONA
RADIO REMOVAL:
1.
2.
3.
4.
Pull out ash try and extract (1) Philips head screw from underneath.
Carefully pry out wood trim bezel, disconnect and remove.
Extract (4) Philips head screws securing radio bezel, disconnect and remove.
Extract (4) Philips head screws securing radio, Disconnect and remove.
2002-2005 RIO
RADIO REMOVAL:
1. Remove the ashtray and extract (1) Philips screw exposed in the ashtray cavity.
(Philips screw only in 2002 models)
2. Unclip and remove entire panel surrounding radio and climate controls.
(2002 models remove the knob from fresh air/recirculate control).
3. Remove (4) Philips screws securing radio.
2001-2003 SPECTRA
RADIO REMOVAL:
1. Extract (2) Philips screws in an upward angle above instrument cluster.
2. Vehicles without tilt steering only. Extract (3) Philips screws from under steering column on steering
column housing. Pop out steering column housing and remove. Remove 213mm bolts from steering
column support. [One on each side of column] lower down column out of dashes way.
3. With tilt steering. Lower down steering weal and using panel removal tool pop out dash bezel that
surrounds instrument cluster, ac controls and radio. Disconnect and remove.
4. Extract (4) Philips screws from radio disconnect and remove.
2004-2005 SPECTRA
RADIO REMOVAL:
1. Using a panel removal tool remove the dash panel surrounding the radio. Disconnect and remove.
2. Extract (4) Philips head screw securing the radio to the dash. Disconnect and remove.
TAB REMOVAL INSTRUCTIONS
TAB REMOVAL:
Cut and Remove the tabs according to the chart and referring to illustration below:
1
2
3
3
2
1
1
2
3
3
2
1
6223L LEFT
BRACKET
1
2
3
3
2
1
2002-2005 Kia Sedona and 2001-2003 Kia Spectra use tabs marked number two(2) on the brackets.
(Note: For 2001-2003 Kia Spectra final assembly please refer to 2001-2003 Kia Spectra final assembly below.)
2002-2005 Kia Rio use tabs marked number three (3) on the brackets.
2003-2005 Kia Sorrento LX and 2004-2005 Kia Spectra use tabs marked by number one (1) on the brackets
2001-2003 KIA SPECTRA ASSEMBLY
2001-2003 SPECTRA
FINAL ASSEMBLY:
1. Place assembled radio, panel and brackets into dash opening, DO NOT bolt in.
2. Snap the trim bezel back into place and pressure fit kit into final position
3. Finish dash reassembly in reverse order of dash disassembly.
SCOSCHE STEREO INSTALLATION COMPONENTS
STEREO DASH KITS
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising