Laptop-ready MLS 014 Project Rm

Laptop-ready MLS 014 Project Rm
!
Laptop-ready TEC
MLS 014 Project Room
General Instructions
1. Press the red power button on the remote to turn on the NEC Plasma screen.
The red light on the bottom left side of the Plasma screen will start to flash then no light.
2. Select your source on the NEC remote HDMI1 or PC by pressing the HDMI/PC button.
3. Contol the Volume using the VOL +/- buttons on the Plasma remote.
4. Press the PRESS button in the tabletop cubby to extend or to retract the cables. Always
detach the cables from your laptop/HDMI device before retracting, and guide them home.
Display a Laptop
1. Attach your laptop to the provided VGA cable (located in the tabletop cubby).
Attach the audio cable and/or ethernet cable if you wish.
2. Press the HDMI/PC button on the remote until PC appears.
3. Turn on your laptop.
Play an HDMI Source
1. Attach your HDMI device to the provided HDMI cable (located in the tabletop cubby)
2. Press the HDMI/PC button on the remote until HDMI1 appears.
3. Operate using the controls on the HDMI device.
Shutdown
1. Detach any laptop or HDMI device.
2. Press the red power button on the remote to turn off the NEC Plasma screen.
3. A red light will appear on the bottom left of the Plasma screen.
For Assistance, Call:
291-4279 TEC Assistance Hotline, OR
358-4467 Wendy Baker Davis
Laptop-ready TEC MLS 014 Project Rm
ITS - Media Services
7/8/14
Wendy Baker Davis
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising