2002-2004 HONDA CBR 919 Hornet 900
2002-2004 HONDA CBR 919
Hornet 900
Installation Instructions
Parts List
Power Commander
CD-ROM
Installation Guide
Wire Tap
Adapter Wire
Power Commander Decals
Dynojet Decals
Velcro® Strip
Alcohol Swab
1
1
1
1
1
2
2
1
1
The ignition MUST be turned OFF before installation!
You can also download the Power Commander software
and latest maps from our web site at:
www.powercommander.com
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 (800) 992-4993 www.powercommander.com
i112-211
2002-2004 Honda CBR 919 Hornet
(European Models Only)-
PCIII - 1
Fig. A
Remove these 6 bolts
1
Remove the seat.
2
Remove the grab rail and tail
section by removing the 6 bolts
shown in Fig. A.
3
Remove the two pushpins in the
front of the tail section. Squeeze
the inside of the pushpin to
remove.
4
Remove the two bolts that hold
the inner fender to the frame
(Fig. B). There should now be
ample room to slide the ECU
out from under the frame.
5
Unplug the black connector
from the ECU (Fig. C).
Fig. B
Wire cluster
Remove these bolts
Fig. C
Black connector
ECU
i112-211
www.powercommander.com
2002-2004 Honda CBR 919 Hornet
(European Models Only)-
PCIII - 2
Connect the PCIII in-line of the
stock harness and ECU (Fig. D).
7
Locate the red wire with a yellow tracer on the grey connector
of the ECU. Crimp the supplied
wire tap to this wire (Fig. E). It
is recommended to use dialectric
grease.
8
Connect the grey wire from the
PCIII to the wire tap (Fig. E).
9
Connect the red auxilary wire to
the red wire of the PCIII. It is
not necessary to connect anything to the other connector.
PCIII connectors
Fig. D
Stock connector
6
Fig. E
Wire tap
Red/yellow
wire
Gray wire
from PCIII
Fig. F
This end to
ECU
Connection
from PCIII
Supplied auxiliary
wire
i112-211
www.powercommander.com
2002-2004 Honda CBR 919 Hornet
(European Models Only)-
PCIII - 3
10
Attach the supplied wire tap to
the black wire with a white
stripe off of the grey ECU connector. Connect the red wire
from the PCIII to the wire tap
(Fig. G).
11
Route the ground wire from the
PCIII to the negative side of the
battery (Fig. H).
12
Slide the ECU back under the
frame.
13
Using the supplied velcro install
the PCIII onto the frame rail
(Fig. J). Make sure to clean
both surfaces with the alcohol
swab before adhering the unit to
the frame. You can check the
placement of the unit by
installing the seat for proper fitment.
14
Make sure all wires are routed
so they will not become pinched
when the tail section and seat
are reinstalled.
15
Install tail section and seat.
Fig. G
Red wire
from PCIII
Fig. H
Wire tap
Fig. J
Ground wire from PCIII
i112-211
www.powercommander.com
2002-2004 Honda CBR 919 Hornet
(European Models Only)-
PCIII - 4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising