Combo External enclosure Installation Manual

Combo External enclosure Installation Manual
MBT-32U-BK
User’s Manual
WWW.KINGWIN.COM
3.
Hardware Installation Guide
Please follow the instructions and make sure the
hard drives are successfully installed to the Dual
Bay external enclosure!
1.
Push the button and pull out the tray.
2.
Place the HDD into each of the tray.
1
Screw the HDD onto both sides of the tray.
4. Push the tray to the end until the HDD is
connected with SATA connector.
2
Note: Push in the front panel, make sure all
connectors are connected well.
3
HDD Formatting Guide
This device can support JBOD & BIG mode.
- JBOD: It enables each hard drive to be seen separately as
single drive, showing 2 HDD capacities.
- Backup before formatting your HDD.
• Please switch to
NORMAL mode on
rear panel for JBOD
function.
BIG : It combine a series of physical hard drives as a single
large volume.
• Please switch
to BIG mode on
rear panel.
Step 3:
Two brand new HDDs
- Select “Disk Management” and you will see your External
HDD shows “Not Initialized”.
Step 1:
Right -click “
My Computer”
icon and select the
“Manage” column.
Two formatted HDDs
(These two HDDs have to be combined into
one disk.)
- Select “Disk Management” and you will see your External
HDD only shows one HDD, another shows “Unallocated”.
Select “Disk
Management” and you
will see your hard drives show “Unallocated.”
Step 2: Please refer to Step 4
4
- Right-click the red-squared block and select
“Delete Partition”.
- Delete both HDDs’ partition then start to format
two HDDs into one.
- You will see your External HDD shows “Not
Initialized”.
Step 4: Right-click the red-squared block and
select “Initialize Disk”.
6
5
Step 5: Press “OK” button to initialize HDD.
Step 6: The external HDD will be showed “Online”.
Right-click the “Unallocated” block and select
“New Partition”.
7
Step 7: The “New Partition Wizard” will appear.
Please follow the instruction of the wizard to
complete the partition.
Step 8: When new partition is completed, the
- If youHDD
divided
into two aspartitions,
external
will HDD
be recognized
a “New format
two
partitions
separately.
Volume”.
- If you divided HDD into two partitions, format two
partitions separately.
- After two partitions are formatted completely,
you will see two healthy HDDs.
8
- After two partitions are formatted completely, you will see
two healthy HDDs.
M0-90-367G
9
8
9
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising