ATN Cougar Night Vision Binocular User Guide

ATN Cougar Night Vision Binocular User Guide
TROUBLESHOUTINGS
Q: Flashes, flickers or clicking occur while
operating
S: If it occurs within the first five minutes of
inserting new batteries, it is normal and the
device will resume normal operation soon
thereafter. If it occurs for more than 10 minutes, contact for service instructions.
Q: Dark spots on screen.
S: These are either cosme tic blemishes in
the intensifier tube or dust particles.
Q: Screen becomes darker than at previous
use.
S: Replace batteries. If problem persists, contact your dealer or other authorized service
representative for service instructions.
Q: Image not clear.
S: Adjust objective lens, and/or the eyepiece.
2 YEAR PRODUCT WARRANTY
This product is guaranteed to be free from manufacturing defects in material and workmanship
under normal use for a period of 2 (two) years
from the date of purchase. In the event a defect
that is covered by the foregoing warranty occurs
during the applicable period stated above, ATN, at
its option, will either repair or replace the product,
and such action on the part of ATN shall be the full
extent of ATN’s liability, and the Customer’s sole
and exclusive remedy. This warranty does not
cover a product (a) used in other than its normal
and customary manner; (b) subjected to misuse;
(c) subjected to alterations, modifications or
repairs by the Customer of by any party other than
ATN without prior written consent of ATN; (d) special order or “close-out” merchandise or merchandise sold “as-is” by either ATN or the ATN dealer;
or (e) merchandise that has been discontinued by
the manufacturer and either parts or replacement
units are not available due to reasons beyond the
control of ATN. ATN shall not be responsible for
any defects or damage that in ATN’s opinion is
a result from the mishandling, abuse, misuse,
improper storage or improper operation, including use in conjunction with equipment which is
electrically or mechanically incompatible with
or of inferior quality to the product, as well as
failure to maintain the environmental conditions
specified by the manufacturer. CUSTOMER IS
HEREBY NOTIFIED THAT OPERATION OF THE
EQUIPMENT DURING DAYLIGHT HOURS OR
UNDER ANY EXCESSIVE LIGHT CONDITIONS
MAY PERMANENTLY DAMAGE THE INTERNAL COMPONENTS OF THE UNIT AND SAID
DAMAGE WILL NOT BE COVERED UNDER
THIS WARRANTY. This warranty is extended only
to the original purchaser. Any breach of this warranty shall be waived unless the customer notifies
ATN at the address noted below within the applicable warranty period.
The customer understands and agrees that except
for the foregoing warranty, no other warranties written or oral, statutory, expressed or implied, including
any implied warranty of merchantability or fitness for
a particular purpose, shall apply to the product. All
such implied warranties are hereby and expressly
disclaimed.
LIMITATION OF LIABILITY
ATN will not be liable for any claims, actions,
suits, proceedings, costs, expenses, damages
or liabilities arising out of the use of this product.
Operation and use of the product are the sole
responsibility of the Customer. ATN’s sole undertaking is limited to providing the products and
services outlined herein in accordance with the
terms and conditions of this Agreement. The provision of products sold and services performed by
ATN to the Customer shall not be interpreted, construed or regarded, either expressly or implied, as
being for the benefit of or creating any obligation
toward any third party of legal entity outside ATN
and the Customer; ATN’s obligations under this
Agreement extend solely to the Customer. ATN’s
liability hereunder for damages, regardless of
the form or action, shall not exceed the fees or
other charges paid to ATN by the customer or
customer’s dealer. ATN shall not, in any event,
be liable for special, indirect, incidental or
consequential damages, including, but not
limited to, lost income, lost revenue or lost
profit, whether such damages were foreseeable or not at the time of purchase, and whether
or not such damages arise out of a breach of
warranty, a breach of agreement, negligence,
strict liability or any other theory of liability.
Night Cougar
PRODUCT WARRANTY REGISTRATION
In order to validate the warranty on your product,
ATN must receive a completed Product Warranty
Registration Card for each unit. Please complete the form below and immediately mail it to
our Service Center: ATN Corporation, 20 South
Linden Ave., Suite 1B, South San Francisco CA
94080. Products qualifying for warranty repair will
be either repaired or replaced within 10 business
days of receipt of merchandise unless the customer is notified otherwise.
OBTAINING WARRANTY SERVICE
To obtain warranty service on your unit, take
or send the product, postage paid, with a copy
of your sales receipt to our service center, ATN
Corporation at the address noted above. All merchandise must be fully insured with the correct
postage; ATN will not be responsible for improper
postage or, missing or damaged merchandise
during shipment.
For customer service and technical support,
please contact
American Technologies Network Corp.
North American Office
20 S. Linden Ave. Suite 1B,
South San Francisco, CA 94080
phone: 800-910-2862, 650-875-0130;
fax: 650-875-0129
European Office
phone: 44(0)870-0111286,
fax: 44(0) 845-3349142
The following countries can use our
toll free number 00 800 9102-8620
Austria, France, Germany, Holland, Italy,
Spain, Sweden, Switzerland
www.atncorp.com
u s e r ` s
g u i d e
AMERICAN
TECHNOLOGIES
NETWORK
CORP.
IR illuminator
5 Diopter
F1:1.4, f35mm
front lens
system
Power button
IR illuminator
power button
Battery
housing
FEATURES
• Rugged fiberglass reinforced plastic construction.
• All glass multi-coated lenses for superb clarity
and brightness.
• Revolutionary F1.4 lens with amazing light
transmission.
• Manual focus.
• Adjustable eyepiece.
• The Night Cougar infra-red illuminator was
designed to let you see even in total darkness.
• Light weight and comfortable.
• Weather Resistant.
• Two year warranty (optional extended warranty).
SPECIFICATIONS
Total Darkness Technology ............... Standard
Magnification ................................................1X
Intensifier Tube ................. High Res. 1st Gen +
Detection Range ........................... 150 m/yards
Recognition Range ....................... 100 m/yards
Lens System ........... 6 elements, F1:1.4, 35 mm
FOV............................................................. 30°
Diopter Adjustment .......................................±5
Resolution.......................................... 40 lp/mm
Power Supply.......................One 3 Volt Lithium
Range Of Focus ............................1m to Infinity
Controls ..................................................Digital
Battery Life.................................... 10-20 Hours
Operating Temperature ........... -40°C to +40°C
Dimensions...........137 mm X 125 mm X 50 mm
..................................................... 5.5” X 5” X 2”
Weight........................................ 0.8 kg/1.75 lbs
APPLICATION
The Night Cougar is a light weight dual
eye/tube goggle system that is comfortable to wear and easy to use. Powered by
two high quality 1st. gen+ light intensifier
tubes and using fast precision optics the
Night Cougar has one of the clearest and
brightest images available in a 1st gen
goggle.
Combine all of the above with a built in
infrared illuminator that lets you see in
total darkness and you will be on your way
to exploring even the darkest of places.
The Night Cougar goggle system is a complex opticoelectronic system for individual
use. The device consists of an objective
lens assembly, eyepieces and a body. The
body contains two 1st Gen.+ image intensifier tubes assembly with an integrated high
voltage power source and the three volt battery housing.
Objective lens protective covers are
intended to protect objective lens from
dust and scratches. It also will act as a
daylight filter, allowing you to test the
scope in daylight or other bright light situations.
NOTE: Do not test the scope in daylight
conditions even with the daylight filter/lens
cap on for more than ten (10) minutes.
NOTE: We suggest that you focus the diopter
during daylight with the filter on.
NOTE: The front lenses should be readjusted
as you view objects at different distances.
INFRA-RED ILLUMINATOR
Infra-red (IR) illuminators, are common to
night vision. The IR light greatly enhances
the performance of the Night Cougar while
remaining almost totally invisible to the
naked eye. The IR illuminator on the Night
Cougar is located next to the front lenses.
To turn the IR on or off push the button
marked “IR”. It is important to remember
that the IR illuminator is simply an infra
red light source, and like any light source,
it may loose its effectiveness over a great
distance.
NOTE: The IR will automatically turn off when
the unit’s power is turned off.
HEADGEAR
PART I
Figure H1
OPERATION
• Take the Night Cougar out of the case.
• Install the battery into the housing with the
polarity order as shown on the scope. Battery Type: 3 Volt Lithium, #CR123A .
• Push the button marked “I/O” to turn the
unit on with the protective lens cover still
attached to the lens. Do not turn the unit
on in the daytime without the protective lens cap on. You should see green
glow in the eyepiece. You may notice a
persistent green glow for up to five (5)
minutes after you have turned the unit
off. This is normal for the 1st Gen Light
intensifier tube.
• Observe the scene and adjust the diopter
for optimal image clarity. Focus the front
lenses until the image and the grain are
both sharp.
• You may now enter a dark environment or
simply shut the lights off in order to darken
the room.
• Next, remove the lens cap/daylight filters.
Adjust the front lenses for distance of the
focus. You should not have to readjust the
diopter.
The information in this manual furnished for information use only, is subject to change without notice,
is not to be construed as a commitment by ATN Corp.
ATN Corp. assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.
©2002 ATN Corp. All right reserved.
Figure H2
Figure H3
1) The first step that
you want to take
in mounting Night
Cougar on your head
is to fit the headgear
to your size. Adjust the
headgear fist befor
attaching the Night
Cougar to it.
2) Loosen all the
straps and plase the
headgear on your
head.
3) You will want to
tighten the side straps
(Figure 1) fist.
4) Then secure the
top strep (Figure 2).
This one is rather tight
so you might need to
remove it from your
head, when you are
adjusting the strap.
5) And last you will
want to adjust your
chin strap (Figure 3).
PART II
Now you are ready to mount the Night
Cougar on to your headgear.
1) Remove the
already adjausted
headgear
from
your head.
2) Slide the Night
Cougar on to the
rail (Figure 4).
Figure H4
Loosen the tightening knob (on the rail) to
enable you to easily slide the unit on. Don’t
retighten the knob just yet.
3) Push the button and move the Night
Cougar up to the vertical position if you
need. (Figure 4).
STORAGE AND CARE
• If the device is not to be us d for extended
period of time (more than 10 days) remove
the battery.
• Avoid touching lenses. If fingerprints or
traces of dirt or dust appear, clean their
surface with a Photographic lens cleaning
tissue.
• Keep lens cap/daylight filters on when not
in use.
• The Night Cougar is not harmful to the user
or the environment.
• Do not disassemble except to clean the front
lenses and eyepieces: it will void your warranty.
• Evaluate the device function by looking
through it in a lit environment with the daylight filter lens cap on. Never use in daylight
without the daylight filter lens cap on.
• Never point the Night Cougar at a bright light
source.
• Adverse atmospheric conditions such as
fog, smog or haze and a lack of ambient
light (moon or starlight) may diminish the
effective viewing distance.
CLEANING THE EYEPIECE
You may need to clean the eyepiece of the
Night Cougar from time to time in order to
guarantee top performance. When you
receive your Night Cougar you should check
for dust on the eyepiece of the unit.
First you will need to remove the eyepiece.
To do that you will need to initially loosen the
2 set screws that can be found on the base.
Then unscrew the eyepiece counter-clockwise to remove it.
NOTE: You do not have to remove the set
screws completely, they are very small and
easy to misplace.
CAUTION: Use only Photographic lens cleaning tissue on these surfaces. Be careful not
to scratch or smudge any of these surfaces.
When using compressed air to blow dust
away, make sure to avoid inverting the can
while spraying. This can cause frozen propellant to exit the can, which can cause serious problems with the glass and phosphor
screen.
2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising