Interior LED Lighting System

Interior LED Lighting System
Page 1/3
Part # 11250.09
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com
Interior LED Lighting System
CONTENTS:
• 9” LED Tube
(4)
• 15” LED Tube
(2)
• Remote (1)
• Connector Block
(1)
• Mounting Tab
(12)
• Hook and Loop Tape (1)
Remote x 1
Connector Block x 1
Mounting Tab x 12
9” LED Tube x 4
Hook and Loop Tape x 1
15” LED Tube x 2
! WARNING A hazardous situation which, if not avoided, could result in serious injury or death.
You can be killed or seriously hurt if you do not follow instructions.
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Copyright © 2016 Omix-Ada ®, Inc.
Page 2/3
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com
Interior LED Lighting System
1. Disconnect battery, removing negative cable first.
Connect red wire lead to positive terminal of battery
by routing wire through rubber grommet in firewall.
Connect black wire lead to 10 mm ground stud in
driver side footwell. Reconnect battery.
When removing battery cables do
! WARNING not touch positive and negative
terminals together.
2. Place one 9” LED Tube under dashboard on each
side. Attach two Mounting Tabs to each LED Tube
and remove red tape backing. Press and hold each
Mounting Tab to metal bar underneath dashboard
for 30 seconds.
3. Place one 9” LED Tube under each front seat. Attach
two Mounting Tabs to each LED Tube and remove
red tape backing. Press and hold each Mounting Tab
to bottom of seat for 30 seconds.
Copyright © 2016 Omix-Ada ®, Inc.
Page 3/3
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix-ada.com
Interior LED Lighting System
4. Attach two Mounting Tabs to each 15” LED Tube
and remove red tape backing. Place one LED Tube
under body tub lip on each side of rear cargo area.
Press and hold for 30 seconds.
5. Plug all wires into Connector Block and power on
Interior LED Lighting System by pressing “POWER” on
supplied Remote. Switch between all lighting modes
using “MODE” buton. “PAUSE” keeps color from
changing or pulsing. To resume, press “PAUSE” button
again. Align all LED Tubes to properly light each area.
6. Run all wires under carpet and tuck underneath
edge of center console. Hide Connector Block
behind dashboard as shown on right. If desired,
attach Hook and Loop tape to back of Remote and
front of lower console panel.
Copyright © 2016 Omix-Ada ®, Inc.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising