Newborn Puppy
AGES 4+
Newborn Puppy
CARE
GUIDE
Puppy colors and accessory may vary.
x3
BATTERIES INCLUDED
Replace with 3 x 1.5V “AAA” or LR03 size alkaline
batteries. Phillips/cross head screwdriver (not included)
needed to replace batteries.
Getting to
Know Your Pet
Back sensor
When you pet
your toy puppy
on its back,
it will lift its
head and blink
its eyes!
ON/OFF
Switch and battery
door on tummy.
1
rt of the toy
A sensor is a pa
your touch!
to
ds
on
sp
that re
How to Play
To activate your toy
puppy, slide the OFF/ON
switch on puppy’s belly to
the ON position.
F
OF
ON
Once turned on, your “sleepy” puppy toy will
slowly “wake up.” It will move its head to an
upright position and open its eyes.
There are two ways to interact with
your toy puppy:
1.Pet your puppy’s
back every few
seconds — it
will stay “awake”
and continue to
move its head
and open
its eyes.
2
2.Constantly pet your toy puppy’s back — it
will relax, put its head down, close its eyes
and go to “sleep.” If you stop petting it,
your puppy will “wake up” and look for
more attention. If you don’t pet it again
after that, it will go back to “sleep.”
NOTE: This toy uses battery power whenever its
switch is in the “ON” position. When you’re not
playing with the toy, move its switch to the “OFF”
position to help conserve battery life.
TROUBLESHOOTING
If your pet doesn’t seem to respond properly,
first try sliding the OFF/ON switch to OFF, then
back to ON. If that doesn’t work, you may need
to replace the batteries.
CLEANING & CARE
3
To clean your pet, gently brush its fur with a
cloth or soft brush to loosen any dirt. Then use a
slightly damp cloth to remove stains.
• Do not put in washing machine.
• Do not submerge in water.
• Do not use detergent or stain removers on fur.
• Do not get wet; to remove stains, use only a
slightly damp cloth on the fur.
• To prevent staining fur, wipe off dirt
immediately.
• If toy gets wet, remove batteries and dry fur;
once fur is completely dry, replace batteries.
• Avoid spilling food or beverages on toy.
• Do not throw or kick toy, and do not push
sharp objects through speaker openings.
• Do not leave toy in direct sunlight: high
temperatures will destroy the mechanism.
To Replace
Batteries
1.Locate battery compartment
on puppy’s tummy.
2.Loosen screw on battery door.
3.Remove and discard old
batteries.
4.Replace with fresh 3 x 1.5V
“AAA” or LR03 size
alkaline batteries.
5.Replace door and
tighten screw.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. As with all small batteries, the batteries
used with this toy should be kept away
from small children who still put things
in their mouths. If they are swallowed,
promptly see a doctor and have the doctor
phone (202) 625-3333 collect. If you reside
outside the United States, have the doctor
call your local poison control center.
4
2.Always follow the instructions carefully.
Use only batteries specified and be sure
to insert them correctly by matching the
+ and – polarity markings.
3.Do not mix old batteries and new
batteries or standard (carbon-zinc) with
alkaline batteries.
4.Remove exhausted or dead batteries
from the product.
5.Remove batteries if product is not to be
played with for a long time.
6.Do not short-circuit the supply terminals.
7.Should this product cause, or be affected
by, local electrical interference, move it
away from other electrical equipment.
Reset (switching off and back on again
or removing and re-inserting batteries) if
necessary.
8.RECHARGEABLE BATTERIES: Do not mix
these with any other types of batteries.
Always remove from the product before
recharging. Recharge batteries under
adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
5
NOTE TO UK CONSUMERS: This product and its batteries
must be disposed of separately at your local waste
recycling centre. Do not dispose of in your household
waste bin.
FCC STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy, and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
6
Product and colors may vary.
© 2009 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
U.S. Pat. Nos. 6811461, 7207859 and 7234989.
Questions? Call 1-800-844-3733
93966 Asst.
PN 6993700000
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising