detailed features

detailed features
SPECIFICATIONS
Model: BZCAP30
3 Farad TRIANGLE Hybrid Super Capacitor
With Red Digital Voltage Display, Blue Flash LED, Blue Led Ring
Capacitance .................................……......3,000,000 micro farad
Working Voltage ...............................…….….. 21DC
Surge Voltage .......................................……… 24DC
E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25°C
Capacitance Tolerance------------------------ ± 10%
DETAILED FEATURES:
a) 4 digits hi-end red light display DC voltage meter that can measure 0.1 DCV range.
b) Reverse pole connecting PCB buzz warning function. If the capacitor is connected
incorrectly by reversing the positive and negative wires during the installation
process the PCB will issue a 45 second noise to warn you.
c) Hi-end platinum plated 100% brass solid parts and chrome plated metal cover
d) Over voltage limit and low battery voltage limit warning. When the system voltage
peeks over 17.5 DCV or LESS than 10 DCV. The buzzer on the PCB will issue an
audible noise warning.
e) Multiple small capacitance capacitors linked to provide the lowest inner E.S.R. and
largest moment discharge power.
1
INSTALLATION AND MOUNTING:
You must first attach the mounting tabs to the capacitor before mounting it. Use the
supplied hardware shown in the picture to the right. Notice the small mounting screw
hole in the capacitor chassis.
CHARGING THE CAPACITOR AND WIRING:
The capacitor must be charged before connecting the Power and Ground cables to the
capacitor. Failure to charge the capacitor will result in a large spark generated from the
rapid inflow of current.
2
C H AR G IN G
B U LB
(
--
)
+
(
)
B ATTER Y
To Charge the capacitor:
1. Make Capacitor positive terminal connections with amplifier and tighten the
bolt. Do not over-tighten the bolts!
Caution: Stripped terminals are not covered under the capacitor’s warranty.
2. Connect the ground cable with battery, amplifier, then refer to the attached
drawing.
3. Place the supplied charging bulb between positive terminal of the capacitor and
the battery’s positive terminal. Do this for 2 ~ 3 minutes or until the charging
bulb goes out.
Caution: The charging bulb will get hot!
4. Immediately take out the charging bulb from the connecting wire after the
charging process. And connect the positive cable of the battery directly to the
positive terminal on the capacitor.
DISCHARGING THE CAPACITOR:
When you want to take out the capacitor after you finish the installation process from
original car audio system. You must do discharge process when you want to move the
capacitor. It will be safe to release the power of the capacitor.
3
D IS C H AR G IN G
B U LB
To Discharge the capacitor: With battery power disconnected, place the light bulb or
resistor across the capacitor’s positive and negative terminals until light goes out or for
three minutes if using a resistor.
Multiple Capacitor Wiring Diagram:‫ٻ‬
LIMITED WARRANTY
One Year Warranty from the date of purchase.
WARNING!!
THIS POWER CAPACITOR MAY EXPLODE AND CAUSE SERIOUS INJURY IF ABUSED OR CONNECTED
IMPROPERLY. PLEASE REFER TO THE INSTRUCTIONS CONTAINED IN THIS MANUAL FOR CORRECT OUNTING,
CHARGING/DISCHARGING AND WIRING CONNECTION FOR THIS CAPAPCITOR PRIOR TO INSTALLATION.
4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising