EasyVPN client Application note 20141007 (1 485 kB, PDF)

EasyVPN client Application note 20141007 (1 485 kB, PDF)
User module
Easy VPN client
APPLICATION NOTE
USED SYMBOLS
Used Symbols
Danger – important notice, which may have an influence on the user’s safety or the function
of the device.
Attention – notice on possible problems, which can arise in specific cases.
Information, notice – information, which contains useful advice or special interest.
GPL License
Source codes under GPL license are available free of charge by sending an email to:
info@conel.cz.
Conel s.r.o., Sokolska 71, 562 04 Usti nad Orlici, Czech Republic
Manual issued in CZ, October 7, 2014
i
CONTENTS
Contents
1 Description of user module
1
2 Configuration of user module
2
3 Recommended literature
3
ii
LIST OF FIGURES
List of Figures
1
2
Model diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Configuration form . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
iii
1
2
LIST OF TABLES
List of Tables
1
Description of items in configuration form . . . . . . . . . . . . . . . . . . . . .
iv
2
1. DESCRIPTION OF USER MODULE
1. Description of user module
User module Easy VPN client is not contained in the standard router firmware. Uploading
of this user module is described in the Configuration manual (see [1, 2]).
The user module is v2 and v3 router platforms compatible.
This module allows to establish a secure (encrypted) connection between LAN network
behind Conel router and LAN network behind CISCO router.
Figure 1: Model diagram
For configuration Easy VPN client user module is available web interface, which is invoked
by pressing the module name on the User modules page of the router web interface. The left
part of the web interface (ie. menu) contains only the Return item, which switches this web
interface to the interface of the router.
1
2. CONFIGURATION OF USER MODULE
2. Configuration of user module
The actual configuration of this user module is performed via the form on the right side.
The first item in this form – Enable Easy VPN client – is used to activate these user module,
ie. the creation of the tunnel. Meaning of other items is described in the table below:
Item
Gateway Address
ID
Secret
Username
Password
Description
IP address of CISCO router
Group ID in CISCO router
Password of group in CISCO router
Username of user founded in CISCO router
Password of user founded in CISCO router
Table 1: Description of items in configuration form
At the bottom of the configuration form is also available the Masquerade outgoing packets
item which turns on system of address translation NAT (basically, this is an alternative name
for the address translation system – NAT).
All changes will take effect after pressing the Apply button.
Figure 2: Configuration form
The moment the tunnel is established, a new interface tun0 is displayed on the Network
status page of the router web interface.
2
3. RECOMMENDED LITERATURE
3. Recommended literature
[1]
[2]
Conel:
Conel:
Configuration manual for v2 routers
Configuration manual for v3 routers
3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising