Rear Door Trim Panel Bolster - Removal REMOVAL 1. Disconnect

Rear Door Trim Panel Bolster - Removal REMOVAL 1. Disconnect
ALLDATA Online - 2008 Jeep Truck Compass 2WD L4-2.4L - Rear Door Trim Panel B... Page 1 of 2
PAUL REDEHOFT
Home | Account | Contact ALLDATA | Log Out | Help
Select Vehicle | New TSBs | Technician's Reference
OK
Component Search:
Conversion Calculator
2008 Jeep Truck Compass 2WD L4-2.4L
Vehicle Level Body and Frame Doors, Hood and Trunk
Rear Door Trim Panel Bolster - Removal
Rear Door Panel
Service and Repair
Rear Door Trim Panel Bolster - Removal
Notes
REMOVAL
Zoom
Sized for Print
1. Disconnect and isolate battery negative cable.
2. Remove the screw (1) from the pull handle.
3. Using a trim stick C-4755 or equivalent, separate the bolster (3) from the
door module (2).
http://www.alldatapro.com/alldata/PRO~V166859891~C44396~R0~OD~N/0/128809663/1...
6/2/2010
ALLDATA Online - 2008 Jeep Truck Compass 2WD L4-2.4L - Rear Door Trim Panel B... Page 2 of 2
Zoom
Sized for Print
4. Disconnect the electrical connectors (2), if equipped.
5. Disconnect the tethers (1) and remove the bolster (3).
© 2010 ALLDATA LLC. All rights reserved.
Terms of Use
http://www.alldatapro.com/alldata/PRO~V166859891~C44396~R0~OD~N/0/128809663/1...
6/2/2010
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising