6150RFAPX2 USER GUIDE

6150RFAPX2 USER GUIDE
K4461-11 10/08 Rev. A
6150RFAPX2
Keypad/Transceiver
USER GUIDE
Keypad Features
DISPLAY
The keypad features a three-digit numeric display for zone identification and pre-designated Englishlanguage prompts (e.g., “ALARM,” “AWAY,” “STAY,” “CHECK,” etc.) for indicating system status. (Refer to
Figure 1.)
FUNCTION KEYS
The function keys are continuously backlit for ease in use. (Refer to the User’s Guide provided with the
control panel for detailed instructions on the use of these keys.)
The function keys include keys for panic alarm activation. The panic alarms are activated by pressing key
pairs [1] & [*], [3] & [#], or [*] & [#], or a Special Function Key (see below). Whether these panic keys
function and the type of panic alarms they produce is determined by the control panel’s capability and
programming. (Check with your installer for the further information regarding these keys.)
SOUNDER
The sounder is a piezo-electric sounder that pulses for fire alarms and generates a two-tone sound for
burglary and audible panic alarms.
KEYPAD LEDS
The keypad contains two LEDs that indicate the status of the system as follows:
LED
Function
Green (Ready)
Lights when the system is ready to arm (no zone faults are present).
Red (Armed)
Lights when the system is armed.
SPECIAL FUNCTION KEYS
These are four keys located to the left of the numeric keys (refer to Figure 1). The keys may be programmed
by your installer for panic alarms or other special functions such as macros (a frequently used series of key
entries). Function keys must be held down for at least 2 seconds to activate an alarm. (Check with
your installer for the programmed function of these keys.)
ARMED
READY
WW W.APX A LARM.CO M
6150APX-002-V0
Figure 1 - 6150RFAPX2 Keypad/Transceiver
User Mode
This mode gives you the capability of enabling and disabling individual wireless keys that have been directly
programmed into the 6150RFAPX2. This is particularly useful if a user loses a wireless key.
This mode may only be accessed if the 6150RFAPX2 is powered up for at least 1 minute. Only wireless keys
programmed directly into the 6150RFAPX2 may be enabled and disabled using this mode.
ENTER THE USER MODE
Press the [1] and [3] keys simultaneously for a few seconds (make sure the unit has been powered for at least
1 minute prior).
CHANGING THE STATUS OF A TRANSMITTER
On the display, “dE” and “-” flashes alternately. Enter the number of the wireless key transmitter (1-8).
Then “d” and the wireless key number you entered flash alternately with “1” or “0” on the display. A “1”
indicates the wireless key is enabled, a “0” indicates it is disabled. Enter [1] to enable or [0] to disable the
wireless key. All wireless keys are defaulted to 1 (enabled).
Press the [✻] to accept the entry.
Repeat the procedure for all the wireless keys whose status you want to change.
EXITING THE USER MODE
To exit the User mode press [✻] when “dE” and “–” flash alternately on the display.
5132 North 300 West
Provo, Utah 84604
(800) 216-5232
www.apxalarm.com
ÊK4461-11@Š
K4461-11 10/08 Rev. A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising