User manual | OPERATOR`S MANUAL CORDLESS FLASHLIGHT MODEL NO

OPERATOR`S MANUAL CORDLESS FLASHLIGHT MODEL NO
OPERATOR'S MANUAL
CORDLESS FLASHLIGHT
MODEL NO. FL1200 (12 VOLT)
MODEL NO. FL1400 (14.4 VOLT)
Use only with recommended battery pack
and charger (both sold separately)
■
USE ONLY BATTERY PACK PART NUMBER
1311148 or 130147008 WITH FLASHLIGHT MODEL
FL1200 AND PART NUMBER 1314702, 130224011
or 130224010 WITH MODEL FL1400. Any attempt to
use another battery pack will cause damage to your
flashlight and could possibly explode, cause a fire, or
personal injury.
■
REMOVE BATTERY PACK FROM FLASHLIGHT
BEFORE REPLACING BULB OR PERFORMING ANY
ROUTINE MAINTENANCE OR CLEANING.
■
DO NOT DISASSEMBLE YOUR FLASHLIGHT.
■
DO NOT PLACE FLASHLIGHT OR BATTERY PACK
NEAR FIRE OR HEAT. They may explode. Also, DO
NOT dispose of a worn out battery pack by incinerating.
Do not incinerate the battery, even if it is severely
damaged or completely worn out. The battery may
explode in fire.
■
DO NOT STORE YOUR FLASHLIGHT IN A DAMP OR
WET LOCATION. DO NOT STORE IN LOCATIONS
WHERE THE TEMPERATURE IS LESS THAN 50°F
OR MORE THAN 100°F. Do not store in outside or in
vehicles.
■
DO NOT PERMIT CHILDREN TO USE FLASHLIGHT
UNSUPERVISED. It is not a toy. The temperature of
the bulb will become hot after being on for only a short
period of time. This hot temperature can cause burn
injury if touched and can create sufficient heat to melt
some fabrics.
WARNING:
If wrapped or in contact with fabric, the flashlight lens can
produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the flashlight lens to
come in contact with anything.
WARNING:
Do not connect your flashlight to a battery until you have
read and understood all precautions and operating
instructions in the manual and printed on battery and
charger.
■
KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
■
AVOID DANGEROUS ENVIRONMENT.
■
KEEP LIGHT DRY, CLEAN, AND FREE FROM OIL
AND GREASE. Always use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based
products or any strong solvent to clean your flashlight.
■
STAY ALERT. Watch what you are doing and use
common sense. Do not rush.
■
CHECK DAMAGED PARTS. Before further use of this
flashlight, a part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function. Do not use flashlight if it
does not function properly.
RULES FOR SAFE OPERATION
READ ALL INSTRUCTIONS
■
KNOW YOUR FLASHLIGHT. Read operator's manual
carefully. Learn its applications and limitations as
well as the specific potential hazards related to this
flashlight.
IMPORTANT SAFETY RULES FOR BATTERY
TOOLS
■
USE ONLY THE CHARGER RECOMMENDED FOR
USE WITH YOUR FLASHLIGHT. Do not substitute
any other charger. Use of another charger could cause
batteries to explode causing possible serious injury.
RULES FOR SAFE OPERATION (Continued)
■
Your battery tool should be charged in a location where
the temperature is more than 50°F but less than
100°F.
■
Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with
your skin, wash immediately with soap and water, then
neutralize with lemon juice or vinegar. If liquid gets in
your eyes, flush them with clean water for at least 10
minutes, then seek immediate medical attention.
c.
That wire size is large enough for AC ampere rating
of charger as specified below:
Cord Length (Feet) 25
50
100
Cord Size (AWG) 16
16
16
Note: AWG = American Wire Gage
■
DO NOT OPERATE CHARGER WITH A DAMAGED
CORD OR PLUG. If damaged, have replaced at your
nearest Ryobi Authorized Service Center.
■
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way; take
it to your nearest Ryobi Authorized Service Center.
■
Do not disassemble charger; take it to your nearest
Ryobi Authorized Service Center when service or repair is required. Incorrect reassembly may result in a
risk of electric shock or fire.
■
To reduce the risk of electric shock, unplug charger
from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.
■
Do not use charger in wet or damp conditions.
■
Disconnect charger from power supply when not in use.
■
SAVE THESE INSTRUCTIONS. Review them frequently and use them to instruct others who may use
this light. If you loan someone this flashlight, loan them
these instructions also.
WARNING:
Batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light. To
reduce the risk of serious personal injury, never use any
cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.
WARNING:
Never use a battery that has been dropped or received a
sharp blow. A damaged battery is subject to explosion.
Properly dispose of a dropped battery immediately. Failure
to heed this warning can result in serious personal injury.
SAFETY RULES FOR FLASHLIGHT
IMPORTANT SAFETY INSTRUCTIONS FOR
CHARGER
■
Before using battery charger, read all instructions and
cautionary markings in this manual, on battery charger,
on battery and on and product using battery.
WARNING:
Do not operate flashlight or charger near flammable
liquids or in gaseous or explosive atmosphere. Internal
sparks may ignite fumes.
WARNING:
To reduce the risk of injury, charge only nickel-cadmium
type rechargeable batteries. Other types of batteries
may burst causing personal injury and damage.
Lens and bulb become hot during use.
• During or immediately after use, don't lay
flashlight flat on lens surface or place lens area in
contact with a plastic or fabric covered surface.
■
Do not expose to wet or damp conditions.
■
To reduce the risk of damage to electric plug and cord,
pull by the plug rather than the cord when disconnecting
charger.
■
WARNING:
An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could
result in a risk of fire and electric shock. If extension
cord must be used, make sure:
a. That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
b. That extension cord is properly wired and in good
electrical condition; and
Page 2
• Handle flashlight with care around any
flammable surface.
• Let flashlight cool for several minutes after use
before changing bulb.
• Do not use or permit use of flashlight in bed
or sleeping bags. This flashlight lens can melt
fabric and a burn injury could result.
OPERATION
CHARGING YOUR FLASHLIGHT
The battery pack and charger are not included with this
flashlight. They are both sold separately. If you decide to
purchase a battery pack and charger, request recommended
battery pack part number 1311148 or 130147008 for Model
FL1200 and battery pack part number 1314702, 130224010
or 130224011 for Model FL1400. Request one of the following chargers: charger part number 1411141 or 140120005
for Model FL1200. Request charger part number 1412001
for Model FL1400.
TO CHARGE BATTERY PACK:
■ Charge battery pack only with the charger recommended.
■ Make sure power supply is normal house voltage,
120 Volts, 60 Hz, AC only.
■ Connect charger to power supply.
■ Place battery pack in charger then press down on
battery pack to be sure contacts on battery pack engage properly with charger contacts.
■ Red light should turn on.
CHARGING WITH CHARGER PART NUMBER 1412001,
1400656, 1400677 or 140120005.
■
■
CAUTION:
When placing battery pack in your flashlight, be sure raised
ribs on battery pack aligns with groove inside flashlight
handle and latches snap in place properly. Improper
assembly of battery pack can cause damage to internal
components.
■
When battery pack is fully charged, the red light will
turn off and the green light will turn on.
After normal usage, 1 hour of charging time is required
to be fully charged. A minimum charge time of 1-1/2
hours is required to recharge a completely discharged
battery pack.
CHARGING WITH CHARGER PART NUMBER 1411141.
■
To remove battery pack, locate latches on end of battery pack and depress to release battery pack from
your flashlight.
After normal usage, 3 hours of charging time is required to be fully charged. A minimum charge time of 6
hours is required to recharge a completely discharged
battery pack.
TO INSTALL/REMOVE BATTERY PACK
See Figure 1.
■ Begin with a fully charged battery pack.
■ Orient battery pack so that raised rib on battery pack
aligns with groove inside flashlight. Battery pack is
designed to fit only one way in flashlight handle.
■ Insert battery pack, making sure latches on each side
of battery pack snap in place and battery pack is secure in flashlight before use.
Page 3
LATCH
BATTERY
PACK
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 1
OPERATION
SWITCH
See Figure 2.
To turn your flashlight on and off, depress switch trigger.
180° ROTATING HEAD
See Figure 2.
Your flashlight has the feature of rotating the head 180°
back and forth.
BULB REPLACEMENT
See Figure 3.
When purchasing replacement bulb, request recommended
part number 973638-001 for Model FL1200 and part number
981258-003 for Model FL1400.
SWITCH
TRIGGER
180° ROTATING HEAD
TO REPLACE BULB:
■ Remove battery pack from flashlight.
■ Remove lens cover by turning cover in counterclockwise
direction, then remove cover.
■ Remove old bulb from spring.
■ Position new bulb in spring.
■ Replace lens cover.
Fig. 2
■ Replace battery pack.
Note: For your convenience, your flashlight has a spare
bulb storage area. It is located behind the lens cover.
See Figure 3.
BULB STORAGE
AREA
BULB
LENS COVER
Fig. 3
Page 4
MAINTENANCE
DO NOT abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part may create a hazard or cause
product damage.
WARNING:
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
BATTERIES
DISPOSAL OF THE EXHAUSTED BATTERY
Your flashlight's battery pack is equipped with nickelcadmium rechargeable batteries. Length of service from
each charging will depend on the type of work you are
doing.
The batteries in this tool have been designed to provide
maximum trouble free life. However, like all batteries, they
will eventually wear out. DO NOT disassemble battery
pack and attempt to replace the batteries. Handling of
these batteries, especially when wearing rings and jewelry,
could result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
■ Store and charge your batteries in a cool area.
Temperatures above or below normal room
temperature will shorten battery life.
■ Never store batteries in a discharged condition.
Recharge them immediately after they are discharged.
■ All batteries gradually lose their charge. The higher
the temperature the quicker they lose their charge. If
you store your tool for long periods of time without
using it, recharge the batteries every month or two.
This practice will prolong battery life.
To preserve natural resources, please
recycle or dispose of properly.
This product uses nickel-cadmium
batteries. Local, state or federal laws may
prohibit disposal of nickel-cadmium
batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
For more information on battery recycling call 1-8008BATTERY.
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Nickel-cadmium batteries must be
recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children.
Failure to comply with these warnings could result in
fire and/or serious injury.
WARNING:
Do not attempt to disassemble the battery pack. Fire or
injury may result.
Page 5
OPERATOR'S MANUAL
CORDLESS FLASHLIGHT
MODEL NO. FL1200 (12 Volt)
MODEL NO. FL1400 (14.4 Volt)
• SERVICE
Now that you have purchased your tool, should a need ever exist for repair parts or service,
simply contact your nearest Ryobi Authorized Service Center. Be sure to provide all
pertinent facts when you call or visit. Please call 1-800-525-2579 for your nearest Ryobi
Authorized Service Center. You can also check our web site at www.ryobitools.com for a
complete list of Authorized Service Centers.
• MODEL NO. AND SERIAL NO.
The model number of this tool will be found on a plate attached to the motor housing.
Please record the model number and serial number in the space provided below.
• HOW TO ORDER REPAIR PARTS
WHEN ORDERING REPAIR PARTS,
ALWAYS GIVE THE FOLLOWING INFORMATION:
•
MODEL NUMBERS FL1200 / FL1400
•
SERIAL NUMBER
RYOBI TECHNOLOGIES, INC.
1428 Pearman Dairy Road, Anderson, SC 29625
Post Office Box 1207, Anderson, SC 29622-1207
Phone 1-800-525-2579
www.ryobitools.com
972000-696
9-03
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising