driftwood log set installation instructions for driftwood log set hearth

driftwood log set installation instructions for driftwood log set hearth
P900428-00
HEARTH PRODUCTS
KITS AND ACCESSORIES
9000428-00 REV. NC 05/2015
DRIFTWOOD LOG SET
INSTALLATION INSTRUCTIONS FOR DRIFTWOOD LOG SET
FOR USE IN ASTRIA GEMINI CD AND SUPERIOR DRC3000 CONTEMPORARY FIREPLACES
Table Of Contemporary Media
Catalog
Number
Model
Number
Contemporary Media Name
H2487
DRFTWD-GS
Driftwood Lot Set – Gulf Shores
WARNING: Only use materials listed here. Only
contemporary media authorized have been tested
for use within the firebox and its environment. Do
not attempt to use any different materials in the
fireplace. Doing so may be dangerous and will
void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
PREPARING THE FIREPLACE FOR DRIFTWOOD LOG SET
INSTALLATION
1. To access the glass door securing latches, first remove facade
assembly from fireplace.
TOOLS REQUIRED - None.
GENERAL INFORMATION
The Driftwood Log Set is to be used as a decorative addition in contemporary fireplaces. Please read this instruction sheet in its entirety
before applying this Contemporary Media.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
Refer to the appliance Installation Instructions and Care And Operations
manual (IICO) for detailed instructions.
TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
CAUTION: TURN OF GAS TO THE APPLIANCE AND LOCK OUT ANY
ELECTRICAL SWITCHES.
WARNING: If contemporary media are not installed
according to the installation instructions, flame
impingement and improper combustion could occur
and result in soot and/or excessive production
of carbon monoxide (CO), a colorless, odorless,
toxic gas.
2. Lift the barrier to clear the brackets and swing the bottom of the
barrier out. Then lower the barrier to clear the top channel.
3. Detach the two (2) door latches beneath the firebox floor.
4. Swing the bottom of the glass door away from the fireplace to a
45° angle.
5. Carefully grip the door at the top and bottom, and remove it from
the fireplace. Place the door in a safe location for later reinstallation.
INSTALLING THE CONTEMPORARY MEDIA
Install Driftwood Log Set (DRFTWD-GS)
IMPORTANT: Refractory panels should be installed before any of the
contemporary media are installed.
1. Install the Driftwood Log Set as shown in Figure 1. Media should
be clear of burner and air holes.
2. Insure that glass media remains spread in a thin layer, evenly
over the burner. Leave the pilot area open and take care to not allow
crushed glass to fall into the pilot.
NOTE: When installing Driftwood Log Set, take care to NOT mound
glass media.
IMPORTANT: Be sure that neither Driftwood media nor glass media
impinge on the burner outlet.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Air
Holes
Air
Holes
Pilot
Burner Holes - covered by glass media but unobstructed by logs
Figure 1: 35” and 40” Driftwood Log Set Placement
Re-Installing the Glass Door, Barrier, and Facade
1. Retrieve the glass door. Visually inspect the gasket on the backside of the frame. Gasket surface must be clean, free of irregularities and seated firmly.
2. Position the door in front of the firebox opening with the bottom of the door held away from the fireplace at a 45° angle. Hook the top flange of
the door frame over the top of the firebox frame.
NOTE: Ensure the glass door is centered—with even spacing on each side.
3. Let the bottom of the glass door swing gently in towards the fireplace ensuring that the gasket seats evenly as the door draws shut. Securely
fasten the two (2) latches beneath the firebox floor to the door V-flange.
4. Install the barrier by sliding in into the top channel with the flat side toward the fireplace, then swinging the base of the barrier into the brackets
and lowering it into place.
5. Install the facade assembly to the front of the fireplace.
P900428-00
IHP.us.com
Innovative Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
Printed in U.S.A. © 2015 Innovative Hearth Products LLC
P/N 9000428-00 Rev. NC 05/2015
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising