Removing the Cisco Cisco 3640 Router Cover

Removing the Cisco Cisco 3640 Router Cover
Cisco On-line Maintenance Procedures and Support System
Removing the Cisco Cisco 3640 Router Cover
Go Back
Removing the Cisco Cisco 3640 Router Cover
Use the following procedure to remove the cover:
Step 1
Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power
cable.
Warning Before opening the chassis, disconnect the telephone-network cables to
avoid contact with telephone-network voltages.
Step 2
Remove all network interface cables from the rear panel.
Step 3
Place the router so that the front panel is facing you. Remove the three screws located on
top of the cover near the front edge. (See Figure 1.) Set the screws aside in a safe place.
Problem? Call Cisco GOSS at +1 800 829 2447.
All contents are copyright © 1992–2002 Cisco Systems, Inc. All rights reserved.
Cisco On-line Maintenance Procedures and Support System
Figure 1
Removing the Cisco Cisco 3640 Router Cover
Go Back
Removing the Cisco 3640 Router Cover
Screw
SY
ST
EM
RP
H7043
S
CO
N
AU
X
AC
TIV 0 1
2
RE E
3
AD
Y
1
PC
MC
IA
0
Step 4
Lift the front edge of the cover until it clears the front of the chassis. (See Figure 1.)
Step 5
Pull the cover toward you until the metal tabs on the rear edge separate from the chassis
bottom.
Problem? Call Cisco GOSS at +1 800 829 2447.
All contents are copyright © 1992–2002 Cisco Systems, Inc. All rights reserved.
Cisco On-line Maintenance Procedures and Support System
Step 6
Removing the Cisco Cisco 3640 Router Cover
Go Back
Lift the cover until it is free from the chassis and set it aside.
Problem? Call Cisco GOSS at +1 800 829 2447.
All contents are copyright © 1992–2002 Cisco Systems, Inc. All rights reserved.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising