MODEL PV2000 Nominal Power 2000W AC Input Phase

MODEL PV2000 Nominal Power 2000W AC Input Phase
MODEL
PV2000
Nominal Power
2000W
AC Input
Phase &
waveform
Single phase & Pure Sine Wave
Voltage
120VAC
Acceptable Voltage
95-126VAC
Low Line Disconnect
85VAC±4%
Low Line Re-connect
95VAC±4%
High Line Disconnect
136VAC±4%
High Line Re-connect
126VAC±4%
Frequency
60Hz
AC Output
Phase & waveform
Voltage
Frequency
Single phase & Pure Sine Wave (bypass mode sync to input)
120VAC 10%rms (bypass mode sync to input)
60Hz±0.3Hz (bypass mode sync to input)
Peak Power
3 times of rating power
Short Circuit
Yes, shutdown after 10ms
Protection
Power Factor
0.9-1.0
DC Input
Battery Voltage
12VDC
Minimum Start
Voltage
10VDC
Low Battery Alarm
10.5±0.3vdc
Low DC input
10±0.3vdc
Shut-down
High DC input Alarm &
Fault
16±0.3vdc
High DC input
15.5±0.3vdc
Recovery
MAX Charger
Current
70 AMP
System parameter
Battery Mode
>85%
Efficiency
Line Mode
Efficiency
>96%
power saver
Load <=25W (Enabled on “P/S auto” setting of Remote control)
Audible Alarm
Sounding when the heat sink’s tem is over 100℃ and shutdown after 30 seconds.
Over Load
110%<load<="" font=""></load
Protection
Load>150%, beeps 0.5s every 1s, and Fault after 20s.
Protections
low battery、over charging、over temp、over load
Communications
RS-232/USB/SNMP(custom-made)
Operating Environment
0-40℃,0-90%RH(non-condensing)
Audible Noise
Net Weight(KG)
Dimension L X W X H
<60dB
20kg
470 X223 X185mm
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising