Lighting System Tester

Lighting System Tester
Lighting System Tester
One man
remote l ighting
system tester
Checking trailer lighting systems has never been easier. Now, just one person can
test all trailer lighting circuits fast and accurately. Just plug in the tester to trailer
nose box and walk around the trailer and visually check each circuit as
you select them on the hand held remote control. Stop, turn, tail
and clearance/markers can be checked out in minutes. Any lamp
or function not operating correctly can be noted for repair.
■ Easy to Use
■ Portable ■ Cuts Costs
■ Compact ■ Fast & Accurate
TESTING
PROCEDURE
Before testing,
see note below
1 Connect 7 conductor cable to
tester and to trailer nose box
2 Open receiver case and remove
remote control transmitter
3 Move receiver toggle switch to
its ON position. The power on,
light emitting diode (L.E.D.)
near the handle will illuminate.
This L.E.D. also serves as a
battery charge indicator
4 Press power button on the
remote control transmitter unit
to turn it on. The transmitter
ON/OFF L.E.D. will light. The
receiver L.E.D. in the slot on
the face plate should also light,
showing the signal is being
received.
5 Close cover on receiver and
secure
6 Check circuits by depressing the
Index Button on the remote
control transmitter. The unit will
progress through each circuit.
Continue until all circuits are tested. Note lamps or functions not
working.
7 When testing is completed, turn
off the receiver toggle switch and
the Power ON/OFF transmitter
button. Recharge if needed.
HEAVY DUTY PLASTIC
CASE HOUSES
RECEIVER
ELECTRONICS
AC BATTERY
CHARGER
DIP SWITCH
OVERLOAD 10 A.
RESETTABLE FUSE
RECEIVER
ON/OFF TOGGLE
SWITCH
POWER “ON”
L.E.D.
POWER
BUTTON
NOTE: A red dip switch is located in the slot on the receiver face plate. All of the white
switches are inactive when the unit is purchased. To activate and override a particular function take a pencil, pen, or pointed object and move the required white switch to its opposite
position. See label on face plate for switch function.
PART NO.
920485
Complete
PART NO.
REPLACEMENTS
920507
920508
920509
Remote control transmitter
AC battery charger
14ft. 7 conductor cable with plugs
14 FT. 7 CONDUCTOR
CABLE WITH PLUGS
CAUTION: Do not attempt to replace
the tester battery. When battery fails to
recharge, return tester to Betts
Industries for service
REMOTE
CONTROL
TRANSMITTER
A one man circuit checker for 7 way plugs. Simply plug
checker into 7 way cable and bring into cab. Activate switches
for all circuits, the light emitting diode will illuminate when
circuit is in proper working order. Faulty wiring, shorts, etc.
will be indicated if diodes are dimmer then usual, fail to light
or if more than one diode is illuminated simultaneously.
PART NO.
920273
Plug checker (TC2)
Solid Brass
Pins
Functions
Labeled and
Numbered
LED
Light Source
Plastic Housing
71
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising