C130 Overnight Exchange Procedures

C130 Overnight Exchange Procedures
C130 Overnight Exchange Procedures
This booklet explains how to remove your consumables (1 Drum Cartridge and 4 toners)
from your C130 and install them in the replacement C130.
Page 2: Outlines how to remove your consumables if your C130 powers up and allows
you to remove the 4 toner cartridges.
Page 3: Describes how to remove your consumables if your C130 will not power on and
you have to manually spin the toner cartridge carousel.
Page 4: Describes how to reinstall your consumables into the replacement C130 printer
that you have received.
After you have setup your replacement C130 and confirmed its operation, you will
repack your original printer in the box Oki Data shipped to you, seal the box and apply
the pre-paid & pre-addressed mailing label. Then call the carrier and request a pickup
of this box.
Important Note: Please remove the Paper Tray Dust Cover from your
original unit, and install on the replacement unit.
59404801
Rev 1
C130 Overnight Exchange
Page 1
Your Printer Powers On
Removing All Consumables from Your Oki Data C130
Perform this operation and immediately install the consumables in the replacement printer
CAUTION
Do Not Touch The Toner Roller When Performing These Actions!
Be careful not to spill toner while replacing a toner cartridge. If toner
spills, immediately wipe it off with a soft, dry cloth.
Make sure the C130 printer is powered on
Step
1
2
3
4
5
6
7
8
9
Press Key
Menu Displays
ACTION
MENU
MAIN MENU
MAIN MENU
PRINT MENU
MAIN MENU
QUALITY MENU
QUALITY MENU
REPLACE TONER
REPLACE TONER
BLACK
REPLACE TONER
REMOVE ALL
REMOVE ALL
*NO
REMOVE ALL
YES
*YES
IS SELECTED
After a few seconds, the menu then changes to:
10
11
12
OPEN DOOR AND
REMOVE M TONER
OPEN DOOR AND
REMOVE M TONER
CHECKING TONER
PLEASE WAIT
OPEN DOOR AND
REMOVE C TONER
13
14
CHECKING TONER
PLEASE WAIT
Pull down the handle on the toner cartridge
until the toner cartridge is unlocked and moves
out slightly toward you
Close Door
Pull down the handle on the toner cartridge
until the toner cartridge is unlocked and moves
out slightly toward you
Repeat this procedure for the remaining toner
cartridges (K & Y)
Open the top cover and remove the drum
cartridge
After a few seconds, the menu then changes to:
15
16
Page 2
Power the printer off
QUALITY MENU
REPLACE TONER
Open the top cover and remove the drum cartridge
Install the consumables in the replacement printer following the instructions on page 4 of this
sheet.
C130 Overnight Exchange
Rev 1
Your Printer Does Not Power On
Removing All Consumables from Your Oki Data C130
Perform this operation and immediately install the consumables in the replacement printer
CAUTION
Do Not Touch The Toner Roller When Performing These Actions!
Be careful not to spill toner while replacing a toner cartridge. If toner
spills, immediately wipe it off with a soft, dry cloth.
Make sure the C130 printer is unplugged from the wall outlet
Step
Action
Open
the
printer’s front cover
1
CAUTION:
CAUTION:
2
3
Do not touch the toner cartridge rollers as you are rotating / removing /
replacing them. Place the toner cartridges on a clean piece of paper with the
toner rollers facing up.
Pull down the handle on the toner cartridge until the toner cartridge is unlocked and moves out
slightly toward you and remove the toner cartridge. If the toner cartridge cannot be removed, go to
step 3
Using a pen or other small object, press and
hold the interlock mechanism.
Do not touch the toner cartridge rollers
as you are rotating / removing / replacing
them.
Pull down the handle on the toner cartridge
until the toner cartridge is unlocked and
moves out slightly toward you and remove the
toner cartridge.
4
As you hold the interlock mechanism, place
your fingers as shown and gently push up to
rotate the carousel and remove the remaining
3 toner cartridges, 1 at a time.
Do not touch the toner cartridge rollers
as you are rotating / removing / replacing
them.
5
6
7
8
Close the front cover.
Open the top cover and remove the drum cartridge.
Close the top cover.
Install the consumables in the replacement printer following the instructions on page 4 of this sheet.
Rev 1
C130 Overnight Exchange
Page 3
Installing Your Consumables in the
replacement Oki Data C130
With The Power Off
Step
1
Press Key
Menu Displays
2
3
ACTION
Open the replacement printer’s top
cover and install the drum cartridge
from your C110 and close the top
cover.
Plug the replacement C130 into the
power cord from your original C130
and power the replacement C130
printer on.
STARTING PRINTER
INITIALIZING
4
5
“X”* TONER MISSING
“X” represents a specific toner color
that may vary by printer.
“X” TONER MISSING
6
“X” TONER MISSING
7
“X” TONER MISSING
8
9
10
11
12
13
14
15
Open the front cover and install the toner
cartridge matching the color label on the toner
cartridge carousel. Close the front cover.
Open the front cover and install the toner
cartridge matching the color label on the toner
cartridge carousel. Close the front cover.
Open the front cover and install the toner
cartridge matching the color label on the toner
cartridge carousel. Close the front cover.
Open the front cover and install the toner
cartridge matching the color label on the toner
cartridge carousel. Close the front cover.
CALIBRATING
IDLE
Print a Configuration Page
MENU
MAIN MENU
MAIN MENU
PRINT MENU
PRINT MENU
MENU MAP
PRINT MENU
CONFIGURATION
CONFIGURATION
YES
IDLE
The Configuration Page prints and the printer
goes back to IDLE
Attach the pre-addressed, pre-paid shipping label that accompanied the replacement printer on the box
and contact the shipping service for a package pick-up.
Page 4
C130 Overnight Exchange
Rev 1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising