HP SNMP / Serial Port Card Installation Instructions

HP SNMP / Serial Port Card Installation Instructions
HP SNMP / Serial Port
Card
Installation Instructions
NOTE: This document is an update to Chapter 2,
"Installation," in the HP SNMP / Serial Port Card
Reference Guide.
Overview
A UPS with an installed HP SNMP / Serial Port Card provides
a power management solution for workstations and other
peripheral equipment.
Precautions
See the Important Safety Information guide (included in the
UPS kit) before installing this product.
Save these instructions. This document contains important
safety instructions that should be followed during the
installation of this option card.
WARNING: A risk of personal injury from
electric shock and hazardous energy levels
exists. The installation of options and routine
maintenance and service of this product
must be performed by individuals who are
knowledgeable about the procedures,
precautions, and hazards associated with AC
power products.
NOTE: The rating label on the device provides the
class (A or B) of the equipment. Class B devices have
a Federal Communications Commission (FCC) logo or
FCC ID on the label. Class A devices do not have an
FCC logo or FCC ID on the label. After determining
the class of the device, refer to the user guide for
complete regulatory compliance notices.
Kit contents
© Copyright 2006 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
May 2006 (Fourth Edition)
Part Number 201544-004
•
This document and documentation CD
•
HP Enterprise Infrastructure Solutions Management Pack
CD
•
Warranty information
•
SNMP / Serial Port Card
•
Configuration cable
Required tools
No. 2 Phillips screwdriver
Installing the SNMP / Serial
Port Card
1.
6.
Install the SNMP / Serial Port Card. Be sure to seat it
properly.
7.
Power up the UPS.
8.
Connect the network cable to the RJ-45 connector on the
SNMP / Serial Port Card.
Install HP Power Manager agents on every server or
workstation protected by the host UPS.
To download the latest software version, see the HP
website (http://www.hp.com/go/rackandpower).
2.
Perform a normal system shutdown on all devices
connected to the host UPS.
3.
Place the UPS in Standby mode (from Operate mode or
Configure mode) by pressing the Standby button (1).
Configuring the SNMP / Serial
Port Card
4.
Unplug the UPS.
WARNING: To reduce the risk of personal
injury from electric shock, avoid operating
the UPS while it is disconnected from the
source of electrical power.
5.
Remove the Serial Port Card located on the rear of the
UPS.
For configuration instructions, see the HP SNMP / Serial Port
Card Reference Guide located on the documentation CD or
HP website (http://www.hp.com/go/rackandpower).
Updating the firmware
To update the option card firmware, see the HP website
(http://www.hp.com/go/rackandpower).
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising