ESET NOD32 Antivirus for IBM Lotus Domino

ESET NOD32 Antivirus for IBM Lotus Domino
ESET NOD32 Antivirus
for IBM Lotus Domino
Installation
Copyright © ESET, spol. s r. o.
All rights reserved.
No part of this document may be reproduced or transmitted
in any form or by any means electronic or mechanical, for
any purpose without the express written permission of
ESET, spol. s r. o. Information in this document is subject to
change without prior notice.
Certain names of program products and company names
used in this document might be registered trademarks or
trademarks owned by other entities.
ESET, NOD32 and AMON are trademarks of ESET, spol. s r. o.
Microsoft and Windows are registered trademarks of Microsoft
Corporation.
ESET, spol. s r. o.
Einsteinova 24, 851 01 Bratislava, Slovak Republic
http://www.eset.eu
Customer Care Worldwide: www.eset.eu/support
Customer Care North America: www.eset.com/support
REV.20100927-006
2
ESET NOD32 Antivirus for IBM Lotus Domino
1. Introduction
ESET NOD32 Antivirus for Lotus Domino (AMFE) is a
Lotus Domino server addin, built upon the state-of-theart NOD32 scanning engine. It was designed to protect email communication from virus infiltrations propagating
by e-mail, and to lower the e-mail traffic by filtering out
undesired e-mail attachments.
ESET NOD32 Antivirus for Lotus Domino utilizes the
same engine as NOD32 2.7, including archive scanning,
advanced heuristics, adware/spyware/riskware detection, etc.
2. Quick Installation
System requirements
Supported operating systems
Microsoft Windows NT 4.0
Microsoft Windows Server 2000
Microsoft Windows Server 2003
Supported versions of IBM Lotus
Domino:
IBM Lotus Domino R5 (5.0.9a & higher)
IBM Lotus Domino R6
IBM Lotus Domino R6.5
IBM Lotus Domino R7
IBM Lotus Domino R8
IBM Lotus Domino R8.5
Supported ESET product:
ESET NOD32 for Windows version 2.7
NOTE: ESET NOD32 Antivirus 2.7 does not support 64-bit
installations of IBM Lotus Domino.
Before you install
Prior to installing ESET NOD32 Antivirus for Lotus Domino, make sure that NOD32 2.7 is already installed on
the Lotus Domino server.
NOD32 2.7 as well as ESET NOD32 Antivirus for Lotus Domino is available for download from Eset’s website http://www.eset.com/download/ using your username and password. For more information about installing
NOD32, read the quick installation guide available at
http://www.eset.com/download/manual.htm.
After NOD32 installation set in the AMON module in
Extension Editor the TMP files not to be checked.
Before you start the installation (uninstallation) of
ESET NOD32 Antivirus for Lotus Domino, quit the Lotus
Domino Server.
Installing ESET NOD32 Antivirus for
Lotus Domino
Installation process:
1. extract the installation package downloaded from
Eset’s website or shipped on a CD
2. navigate to the temporary folder, and run the appropriate setup file for your oper. system:
– setup2k.exe – for Windows 2000 / 2003 server
– setupnt.exe – for Windows NT server
3. the installer will search for the current Lotus Domino
notes.ini file and will offer to use the first file found.
After the file has been found, confirm it by typing y
and pressing ENTER to go ahead with the installation
(img. 1)
4. if the found notes.ini file is not the right file, then type
n and press ENTER to continue
5. type the path to the correct notes.ini and press ENTER
(img. 2)
6. enter the name of a new subdirectory in the Lotus Domino data folder where you want the file to be cre-
(img. 1)
(img. 2)
ESET NOD32 Antivirus for IBM Lotus Domino
3
(img. 3)
(img. 4)
(img. 5)
(img. 6)
ated, and where the ESET NOD32 Antivirus for Lotus
Domino databases will be copied to, and press ENTER
(img. 3)
7. wait for the installation to complete
8. after the installation has completed, press any key to
exit the installation dialog (img. 4)
After installation, before Lotus Domino server startup, enter a license key for ESET NOD32 Antivirus for Lotus
Domino product to NOD32 Control Center (NOD32 Control
Center > NOD32 system tools > Settings > License Keys).
The license key is sent to your contact address together
with authorization data by ESET spol. s r. o. After entering
the license key, start Lotus Domino server. At the server
startup, ESET NOD32 Antivirus for Lotus Domino (AMFE)
will be loaded. (img. 6)
After a successful installation, the following files will
be created in the specified folder (i.e. in the Lotus Domino data subfolder):
Uninstalling ESET NOD32 Antivirus for
Lotus Domino
The steps 1 to 5 are identical with those for installation.
6. after the installer has recognized a previous installation of ESET NOD32 Antivirus for Lotus Domino, it
will offer you to uninstall it from the computer. Type
y and press ENTER (img. 5)
7. wait for the uninstallation to complete
8. after the uninstallation has completed, press any key
to close the installation dialog
AMFE help.nsf
AMFE log.nsf
AMFE Mail Review.nsf
AMFE Quarantine.nsf
AMFE Setup.nsf
4
ESET NOD32 Antivirus for IBM Lotus Domino
3. Setup
ESET NOD32 Antivirus for Lotus
Domino Setup (AMFE Setup)
To configure ESET NOD32 Antivirus for Lotus Domino, open Domino Administrator or your Lotus Notes client (Workspace).
To launch ESET NOD32 Antivirus for Lotus Domino,
click the Enable button in the upper part of the AMFE Setup (Service status:). After ESET NOD32 Antivirus for Lotus Domino starts, Lotus Domino Server must be restarted (img. 7).
The settings are divided into two groups:
Antiviral Engine Setup:
To display the Engine settings, double click on the setup document. By default, the settings are displayed in
view mode. To edit the settings, click the Edit button.
Settings:
• Status (Enabled/Disabled) – toggles the checking
on/off
• Text to append to bottom of message: - the text
message appended at the end of infected e-mails.
Setting up actions that are applied after successful or
unsuccessful cleaning:
• Replace file in message – cleans infected files (cleanable)
• Delete file from message – deletes infected files
(regardless of whether they are cleanable or non-cleanable)
• Place text into file body – replaces the body of infected files with a text message (the text of the e-mail
will be replaced with the text you enter here)
• Make log entry –enables logging
• Append virus info to message – adds information
about detected threat to email
• Place infected file into quarantine database –
moves infected files to quarantine (img. 8).
Mail Filter Setup:
ESET NOD32 Antivirus for Lotus Domino enables email filtering based on specified criteria. The filtering can
be accomplished by applying various rules. By adjusting
the filters the proper way, it is possible to filter out spam
effectively.
To create a new filter, click the New Mail Filter button.
To assign different priorities to the filters, move them up
and down using the arrow keys. The higher a filter is listed, the higher priority it has. To switch a filter on/off, select a filter and click the Enable / Disable button.
The Filter Settings are displayed after double-clicking
(img. 7)
ESET NOD32 Antivirus for IBM Lotus Domino
5
(img. 8)
the filter. By default, the settings are displayed in view
mode. To edit them, click the Edit Button.
Settings
• Status (Enabled/Disabled) – enables/disables the
filter
• Description – name of the filter.
Filter settings
From contains – filters by sender
To contains – filters by addressee
Subject contains – filters by subject
Body contains – filters by text in the e-mail body
Attachments size – filters by the size of attachment
• Action to take – actions applicable to e-mail messages
– Delete (reject) message – deletes filtered
messages
– Move message to mail review database –
moves messages to the review database
– Log Message to mail review database and
•
•
•
•
•
deliver the message – delivers messages to
their addressees and places a copy of the messages to the review database
– Remove attachments and deliver – deletes
attachments and delivers messages subsequently.
Strings used for filtering email must commence and
end with an asterisk (e.g. *viagra*). Wildcards can also be
used. A question mark (?) substitutes any one character,
while an asterisk (*) substitutes zero or more arbitrary
characters. Use a semicolon (;) to delimit multiple strings,
if necessary.
Example:
To filter out email from the hotmail.com and yahoo.com
domains, enter **@hotmail.com*;**@yahoo.com* to
the „From contains“ field.
4. Log, Mail Review and
Quarantine database maintenance
AMFE Log Database
contains a review of all infected e-mails detected. The
database also provides information about the time an incident occurred, the name of the threat as well as the re6
ESET NOD32 Antivirus for IBM Lotus Domino
cipient. The information in the database can be sorted by
date or the name of the threats. To enable database logging, select Make log entry, which is located in the Mail
Filter setup.
Quarantine Database
the Quarantine database keeps track of all infected files detected. If needed, the files can be recovered. As in
the previous case, items in quarantine can be arranged
by date or name of infiltration. To store infected files in
quarantine, select Place infected file into quarantine database, found in the Mail Filter Setup.
Mail Review Database
contains all e-mails that have been filtered. Messages are divided into ‘delivered’ and ‘undelivered’. E-mail
messages delivered to their respective addressees are indicated by this icon (when displaying all messages).
Undelivered e-mails can be sent back to their addressees
– to do so, select messages and click on the Deliver button.
7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising