advertisement
INSTALL INSTRUCTIONS C-TTB-CV-F
FULL SIZE TRUNK TRAY
1995-2009 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, #10, #8
2
4
4
HARDWARE:
QTY DESCRIPTION
2 Front mounting bracket (item 2)
6
¼” x ¾” Hex head bolt (item 4)
18
¼” Flat washer (item 5)
10
¼” Nylock nut (item 6)
Driver/Pass side mounting bracket (item 7)
¼” x 1” Hex head bolt (item 14)
¼” x 1” Fender washers (item 16)
Screwdriver set
Wrench – 7/16”
PART #
S-1-TA001HBS2-004
GSM33001
GSM31005
GSM30016
CM000701
GSM33002
GSM31014
Always
!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
Ford Crown Victoria Police
Interceptor trunk
Remove spare tire and tire jack from trunk
Position trunk tray on top of trunk deck
Loosely attach front mounting bracket to trunk tray assembly using
¼” x ¾” Hex bolt and serrated nut.
Loosely attach front mounting brackets to vehicle using ¼” x ¾”
Hex bolts, washer and serrated nut.
Center and lower tray to maximize height for equipment
Tighten all hardware
Loosely attach Driver/Pass side mounting brackets to trunk tray using ¼” x ¾” Hex bolts, washers and serrated nuts.
Loosely attach Driver/Pass side mounting brackets to vehicle as shown in photo above using ¼” x ¾” Hex bolts, washers and serrated nuts.
Center and lower tray to maximize height for equipment
Tighten all hardware.
C-TTB-CV-F_INST_6-096-09
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project