Fireplace Model # 1800

®

Instruction Manual

®

Instructions and warnings for use

Welcome to the Real Flame® family of gel fuel products. If you have any questions please call customer service at

1-800-654-1704

or log on to www.REALFLAME.com.

STOP!

If parts are missing or damaged, call 1-800-654-1704 for assistance

!

WARNINGS

!

1. Fireplace is designed to be used with Real Flame

®

gel fuel only. Do not use with any other gel fuel or any other flammable

liquid or gel.

2. Read entire label and instructions before using Real Flame gel fuel.

3. Make sure fireplace is set on a flat, level and stable surface. Keep fireplace stable at all times.

4. Make sure fireplace and gel fuel are burned on a flat and level surface.

5. Never leave a burning fire unattended, especially around children or pets.

6. Fireplace is not to be operated by children. Keep away from children and pets.

7. Exercise the same precautions as you would with any open fire.

8. When in use some surfaces will be hot, use caution.

9. Never touch logs, gel fuel cans or any other metal surfaces during or immediately after burning gel fuel. They will be extremely

HOT. Allow them to cool for 60 minutes before touching.

10. Do not burn more than three cans of fuel at once.

11. Do not place more than 15 lbs. of weight on the top of the fireplace at anytime.

12. Do not alter fireplace, metal firebox or log set in any manner.

13. Keep fireplace and gel fuel cans away from flammable materials at all times.

14. Do not store or use gasoline or any other flammable vapors, liquids, or materials in the vicinity of fireplace and gel fuel.

15. Do not wear flammable or loose clothing when operating the fireplace.

16. Do not move fireplace while in use. Do not attempt to move or store the fireplace until 60 minutes after gel fuel cans have

been extinguished.

17. Do not burn trash, paper, or wood in the fireplace. Burn only Real Flame

®

gel fuel in the fireplace.

18. Do not burn gel fuel outside designated burn areas on the metal grate.

19. Do not put fireplace in an area with lots of traffic, such as a hallway or entryway.

20. In case of an emergency use a CO2 extinguisher to extinguish the fire.

21. Death, serious injury or damage to property may occur if the warnings above are not followed.

22. If for any reason you cannot follow these warnings please call us at 1-800-654-1704.

NOTICE: Buyer assumes all responsibility for safety and use that is not in accordance with instructions and warnings.

Using your Fireplace

- Follow all instructions included with gel fuel before use.

- Before using Fireplace make sure you have read and understand the step-by-step instructions.

-

During the initial burn you may experience a slight odor. This odor is temporary and will be absent on following burns.

®

Rev. 06/04/07

1800 Pillar Instructions

®

5

6

7

3

4

1

2

Number Description

Parts List

Part Number Quantity

Base

Left Side

Right Side

Left Trim Panel

Right Trim Panel

Center Panel

Mantel Top not shown

1" Screws

Firebox Clips

1801

1802

1803

1804

1805

1806

1807

9713

1075

1

1

1

1

1

1

1

Bag

2

Before assembly, locate instructions and hardware. Take out all parts and compare them to the photograph and the assembly illustrations. Be sure you have all parts identified.

Check for screws that are wrapped in the packaging to be sure you don't discard them.

You may have extra screws.

A helping hand is always good. Assemble fireplace with an adult assistant if possible.

The cement log is heavy. Put the fireplace in the desired location before inserting cement log.

Use caution not to over tighten screws.

2

1

3

Step One

Figure 1

Set the Base (1) on a flat, carpeted surface.

Insert the Left Side Panel (2 ) into the left

end of the slot in the Base. Wood

mounting blocks and tongue edge

will be at the front edge of the Side Panel.

Screw Side Panel to Base through holes at

the bottom of the Panel.

Repeat with Right Side Panel (3) at the

right end of the slot in the Base. Screw

Right Side Panel to Base through holes at

the bottom of the Panel.

Figure 1

Rev. 06/04/07

4

Figure 2

6

7

8

10

Figure 3

9

5

Step Two

Figure 2

- Attach Left Trim Panel (4) to the Left Side

Panel at the tongue and groove on the edges. Screw the Left Trim Panel into the

Left Side Panel through the mounting blocks attached to the Side Panel.

- Repeat with Right Trim Panel (5) and

Right Side Panel and screw together through the mounting blocks attached to the Side Panel.

- Hold Center Panel (6) so arched side of panel is up. Slide the mounting strips at the outer edges of the Center Penel behind the Right and Left Trim Panels so that top edges of Center and Trim Panels align.

- Screw Center Panel to Trim Panels through holes in mounting strips.

Hint: if working alone, carefully place unit face down on a carpeted surface to insert the

Center Panel.

Step Three

figure 3

Slide Mantel Top (7) onto top of unit.

Screw Mantel Top to unit through

mounting blocks, screw into Trim

Panels and Center Panel followed by the

two sides.

You are now ready for the firebox installation. Please refer to the instructions that are included with your firebox.

Rev 6/04/07