Schwinn IC Pro, IC Elite IC Bike Assembly Manual

Below you will find brief information for IC Bike IC Pro, IC Bike IC Elite. The assembly manual contains step-by-step instructions on how to assemble the bike. The manual also includes information on how to adjust the bike's seat and handlebars, as well as how to lubricate the brake pads.

PDF Download
Document
Schwinn IC Pro, IC Elite Assembly Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Adjustable seat and handlebars
  • Resistance adjustment knob
  • Transport wheels
  • Water bottle cages
  • Toe clips and straps

Frequently asked questions

To adjust the resistance, turn the resistance adjustment knob clockwise to increase resistance and counterclockwise to decrease resistance.

To adjust the seat height, loosen the 14mm nuts on either side of the saddle mounting bracket using the combination wrench. Once loose, you can adjust the tilt angle and fore/aft position of the saddle. Once in the correct position, tighten both 14mm nuts on the saddle mounting bracket with the combination wrench.

To adjust the handlebar height, pull the pop pin out, then adjust the handlebar to the desired height and release the pop pin.

It is recommended that you soak the brake pads with Schwinn Fit-Tech Lube. This will extend the life of the brake pads and ensure a smooth resistance interface with the flywheel.

The pedals are marked with an “R” or an “L” on the very end of the spindle. Attach the “R” pedal to the right crank arm and the “L” pedal to the left crank arm. It is a good idea to apply grease to the threads before attaching them to the crank.
ALP:
Preparing document for printing…
0%