PRODUCT MODEL NUMBER MFT2778EE PRODUCT DIMENSIONS French Door w/Ice Dispenser Refrigerator Mount Refrigerator Electrical: A 115-volt, 60-Hz, AC-only,Bottom 15- or H 20-amp fused, grounded electrical supply is required. It is recommended that a separate PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS G DIMENSIONS circuit serving only your refrigerator be PRODUCT MODEL NUMBERS PRODUCT cabinet provided. Use an outlet that cannot be turned WRF555SDF I off by a switch. Do not useMFF2055YE an extension MFF2055DR F cord. MFF2055FR C not incl. NOTE: Before performing any type of 15- or handle Electrical: A 115-volt, 60 Hz, AC-only Electrical: A 115-volt, 60-Hz, AC-only, 15- or H installation, cleaning, or removing a light 20-amp fused, grounded 20-amp fused, grounded electrical electrical supply supplyisis bulb, turn Ittheis control (Thermostat, a separate 90˚ 90˚ E required. required. It is recommended recommendedthat that a separate A Gincl. Refrigerator or Freezer Control depending on circuit serving only your refrigerator and overall circuit serving only your refrigerator be handle cabinet the model)accessories to OFF and thenprovided. disconnect thean approved provided. Use an outletbethat cannotUse be turned B refrigerator from the electrical source. When outlet cannot turned off extension by a switch. off by athat switch. Dobenot use an top of F younot areuse finished, reconnectcord. the refrigerator to Do an extension cabinet not incl. cord. the electrical source and reset the control handle Water: A cold water supply with water NOTE: Before performing any type of (Thermostat, Refrigerator or Freezer Control pressure between 35 and 120 psi (241 installation, cleaning, or removing a light depending on the model) to the desired E and 827 kPa) is required to operate the bulb, turn the control A setting. See “Using the (Thermostat, Controls.” incl. overall water dispenser and iceControl maker. depending If you have on Refrigerator or Freezer handle Water: A cold water supply with water D questions your callthe the model)about to OFF andwater then pressure, disconnect B pressure between 30 and 120 psi (207 and refrigerator from theplumber. electrical source. When a827 licensed, qualified top of kPa) is required to operate ice maker D cabinet you are Iffinished, reconnect the refrigerator NOTE: the water pressure is less than to and water dispenser. If you have questions the electrical source and reset the control what required, the flow of from the aboutisyour water pressure, callwater a licensed, (Thermostat, Refrigerator or Freezer Control water dispenser qualified plumber.could decrease or ice cubes depending on the model) to the desired could be hollowThe or irregular shaped. IMPORTANT: of the water setting. See “Usingpressure the Controls.” coming outOsmosis of a reverse osmosis system Reverse Water Supply: Water: A cold water supply with water going to the water inlet valve of the IMPORTANT: The pressure of the waterand pressure between 30 and 120 psi (207 refrigerator needs 30 and supply coming outtoofbeto a between reverse Width Height Depth Depth Depth - Depth Depth 827 kPa) is required operateosmosis ice maker 120 psi going (207 and 827water kPa). inlet valve of system to the Top of Doors Drawer With Without Cabinet Width - Door Open Height and water dispenser. If you have questions 90° Cabinet Open 90° Open Handles Handles Only Cabinet Overall Model Model the refrigerator needs to beSupply: between Reverse Water If35 a about yourOsmosis water pressure, call a licensed, Depth “I” “B” “C” “D” “E” Depth - “F” “G” “H” “A” Number Size and 120osmosis psi (241water and 827 kPa). reverse filtration system is Depth Depth Depth Depth Depth qualified plumber. Height Doors Open Depth With Depth Depth Width 7 connected to your cold water supply, the Height Height Door Open Drawer With Without Cabinet Width 7 If a reverse osmosis water filtration system 48"90° 47³⁄₄" 28 ⁄₈" Cabinet Model Height -70" Overall Top68⁵⁄₈" of Cabinet Drawer Open 35⁵⁄₈"Handles 33¹⁄₈"Without Handles Cabinet 35Only ⁄₈" 38³⁄₁₆" IMPORTANT: The pressure of the water MFT2778EE 26.8cu.ft. Model Model Cabinet Open(90.5 cm) “E” Handles Handles Only (97.0 Cabinet water pressuretotoyour the reverse osmosis Number SizeOverall(177.8cm) “A” Top of(174.3 “B”cm) (121.990°cm) “C” (121.3 cm) “D” “F” “G” cm) “H”cm) (73.3 cm) (91.1 (84.1 cm) is connected cold water supply, coming out of a reverse osmosis system Size “A” “B” “C” “D” “E” “F” “G” “H” system needs to be atominimum of 40 to the water pressure thevalve reverse osmosis MFF2055YE 19.6 cu. ft. 68Z\x" 66C\v" 43B\," 5115\16" 34C\v" 3111\16" 27M\," 29Z\x" going to the water inlet of the 1 5 1 7 /8" cm) 48" cm) 35 /4" 32 /8" 355/8" 70 /8"(174 cm) 68 (169.5 60 psi (276 to 414 kPa). (110.8 (131.954" cm) (88.3 cm) (80.5 cm) (70.8 cm)29" (74.9 cm) system needs to be minimum 40and to 24.7 cu. ft refrigerator needs toabe betweenof30 (178.1 cm) (174.3 cm) (121.9 cm) (137.2 cm) (89.5 cm) (83.5 cm) (73.7 cm) (90.5 cm) 60 psi 414827 kPa). MFF2055DR 19.7 cu. ft 28" 68C\," 67Z\x" 441\," 52Z\x" 34C\v" 321\4" 301\," 120 psi(276 (207toand kPa). (71.1 cm) (173.7 cm) (171.5 cm) (112.1 cm) (133.4 cm) (88.3 cm) (81.9 cm) (76.5 cm) Reverse Osmosis Water Supply: If a MFB2055FR 20 cu. ft 28" 68C\," 67Z\x" 441\," 52Z\x" 34C\," 321\4" 301\," reverse osmosis water filtration system is LOCATION REQUIREMENTS (71.1 cm) (173.7 cm) (171.5 cm) (112.1 cm) (133.4 cm) (87.3 cm) (81.9 cm) (76.5 cm) connected to your cold water supply, the LOCATION REQUIREMENTS water pressure to the reverse osmosis IMPORTANT: This refrigerator is designed for indoor, household use only. system needs to be a minimum of 40 to 60 psi (276 to 414 kPa). To ensure proper ventilation for your refrigerator, allow for a ½" (1.25 cm) of space on each side and at the top. Allow for a 1" (2.54 cm) space behind the proper ventilation your allow for a 1⁄2"space (1.25 cm) on refrigerator.ToIfensure your refrigerator hasforan icerefrigerator, maker, allow extra at space the back for the water line your refrigerator to a fixed each sideconnections. and at the top. When Allow forinstalling 1" (2.54 cm) of space behind thenext refrigerator. If wall, leave your a 3¾" (9.5 cm) space the some refrigerator andatwall LOCATION REQUIREMENTS refrigerator hasminimum an ice maker, makebetween sure you leave extra space the to allow the door back to for swing the wateropen. line connections. NOTE: ThisIf you refrigerator is intended for use location where are installing your refrigerator next in to a a fixed wall, leave 3 3⁄4the " (9.5temperature cm) ranges from a minimum of 55°F (13°C) to a maximum of 110°F ¹⁄₂" (1.25 cm) minimum on the hinge side (depending on your model) to allow for(43°C). the doorThe to preferred room temperature range for optimum performance, which reduces 1 swing open.proper ventilation To ensure for your refrigerator, allow for a ⁄ 2" (1.25 cm) space on electricity usage and provides superior cooling, is between 60°F (15°C) and NOTE: This refrigerator is intended use in acm) location where the temperature each side and at the top. Allow forfor1"do (2.54 of space behind the refrigerator. If 90°F (32°C). It is recommended that you not install the refrigerator near a ranges from minimum ofice 55°F (13°C) to a sure maximum of 110°F (43°C). your refrigerator has anor maker, make you leave some extraThe space at the heat source, such asaan oven radiator. preferred room temperature range for optimum performance, which reduces back for the water line connections. and your provides superior cooling, between (15°C) and 90°F Ifelectricity you are usage installing refrigerator next to is a fixed wall,60°F leave 2" (5.08 cm) (32°C). It isonrecommended that(depending you do not on install themodel) refrigerator near for a heat ¹⁄₂" (1.25 cm) minimum the hinge side your to allow the source, door to such asopen. an oven or radiator. swing 3³⁄₄" (9.5 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. NOTE: This refrigerator is intended for use in a location where the temperature ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The preferred room temperature range for optimum performance, which reduces Ref. W10739699A Dimensions are for planning purposes only. For complete details, see Installation electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F 05/15 Instructions packed with product. Specifications subject to change without notice. (32°C). It is recommended that you do not install the refrigerator near a heat source, such as an oven or radiator. 2" (5.08 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. W10405120B 5/16 Ref. W10855069A 5/16
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021