- Computers & electronics
- Computer components
- Chassis components
- Mounting kits
- Havis
- C-TMW-GMC-02
- Manual
advertisement
INSTALL INSTRUCTIONS C-TMW-GMC-02
HEAVY DUTY TUNNEL PLATE
2010-2013 CHEVROLET/GMC SUBURBAN/TAHOE,
YUKON XL/YUKON, SILVERADO/SIERRA
2
8
8
8
TOOLS REQUIRED:
Ratchet wrench
Sockets- 7/16”, 11 mm, 15 mm
HARDWARE:
QTY DESCRIPTION
1 Front transmission hump bracket
1
1
Rear transmission hump bracket
28” x 8” Tunnel Plate
Extrusion plastic end caps
¼” Flat Washers
¼” Lock Washers
¼” Serrated nut GSM30023
Open End Wrench- 7/16”
PART #
C-B57
C-B58
C-TMW-28E
CM002527A
GSM31005
GSM31026
Always
!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit.
C-TMW-GMC-02 Assembly
C-B57
CM002527A
One each end
C-TMW-28E
C-B58
Remove OEM trim panel covering front inner seat bolts on driver and passenger sides.
Remove seat bolt nuts. (15 mm socket required.)
Slide seat forward and remove OEM trim panel covering rear inner seat bolts on driver and passenger sides.
Remove seat bolt studs. (11 mm socket required)
Loosely pre assemble front hump bracket with 1/4” x 3/4” bolts and flat washers, then position it under the OEM front seat brackets.
Determine the desired position of the Tunnel plate and mark location with a pencil on the hump brackets. Remove the front and rear hump bracket cross supports.
Loosely pre assemble rear hump bracket with
1/4” x 3/4” bolts and flat washers, then position it under the OEM rear seat brackets.
Insert 1/4” x 3/4” bolts into the bottom of Tunnel plate.
Line up Tunnel plate on cross supports where previously marked.
Use 1/4” serrated nuts to attach.
Reattach Tunnel with cross supports back onto seat brackets.
2 C-TMW-GMC-02_INST_3-10
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project