FLYING TIPS

• It is recommended that you operate the helicopter in a wide indoor space. You should allow at least a 10-foot radius

range.

• The helicopter is designed for INDOOR USE ONLY. Never pilot the helicopter near buildings, power lines, people,

animals, vehicles, homes, trees or other large objects nearby.

• Make sure you are not wearing any loose or long hanging clothing.

• Parental guidance or adult supervision is suggested at all times.

• If you are flying the helicopter with others, make sure all spectators are behind you.

• For best performance, it is recommended that you operate the helicopter in zero wind conditions. Close all open doors

or windows, and turn off any nearby fans. Wind can greatly affect the performance of the helicopter.

HELICOPTER FLIGHT ADJUSTMENTS

If your helicopter rotates uncontrollably, you may need to utilize the TRIM button. If your helicopter over rotates

CLOCKWISE (to the right), push and release the LEFT side of Trim button rapidly and repeatedly until the turning stops and proper flight is maintained. If your helicopter over rotates COUNTER-CLOCKWISE (to the left), push and release the

RIGHT side of Trim button in the same manner until the problem is resolved.

CHARGE

If over rotates to the right...

L R

Push left trim.

L

TRIM

R

Trim Controls

If over rotates to the left...

L R

Push right trim.

SAFETY PRECAUTIONS

IMPORTANT: ALWAYS DISCONNECT CHARGER CORD AFTER CHARGING. NEVER LEAVE

CHARGER CONNECTED TO HELICOPTER OVERNIGHT OR FOR EXTENDED PERIODS OF TIME.

INFRARED MULTI CHANNEL CONTROL SYSTEM

Your Chrome Flyer™ utilizes an automatic multi-channel selection system that allows up to

3 people to fly side by side in the same wireless range.

FOR ONE PERSON PLAY:

1. Before starting, make sure that both your controller and helicopter are in the power off position.

D.

2. Select the desired flight channel (a, b or c) from the controller and turn the controller on (see diagram D).

3. Next, turn on the helicopter and set it on a table or hold it in your hand from underneath. Make sure your hands and body are

away from the helicopter blades.

4. Move the left throttle stick all the way up and back down again one time to pair the helicopter to the controller. NOTE: The

helicopter blades will NOT spin.

5. Lift the left throttle stick slowly one more time. Now your blades should spin and you are ready to play!

6. Note if you turn your helicopter off or the battery runs out, you will need to re”pair” the helicopter and controller.

FOR TWO OR THREE PERSON PLAY:

7. Before starting, make sure that ALL the helicopters and controllers are in the power off position.

8. Each individual player must select a different flight channel (a, b or c) on his/her own controller. If more than one person is on

the same flight channel, there will be interference.

9. Only one person at a time should pair their helicopter by following steps 3 thru 5 above.

10. When a player’s helicopter is paired and working it should be left on while the next player/s pair their helicopters.

11. Note if you turn your helicopter off or the battery runs out, you will need to re “pair” the helicopter and controller.

HELICOPTER WARNING:

The helicopter blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the helicopter to reduce the risk of getting into the flight path. Warn spectators that you will be flying your helicopter so that they are aware of its position. Before flight, inspect the rotor blades to make certain that the blades are securely fastened to the helicopter.

WARNING!

• Choking/Cutting Hazard. Small Parts/Sharp Rotor Blades.

• Keep hands, hair and loose clothing away from the propeller when the power switch is turned to the ON position.

• Turn off the transmitter and helicopter power switches when not in use.

• The remote control charger is built specifically for the helicopters Li-Poly battery. Do not use it to charge any other battery.

• New alkaline batteries are recommended for maximum performance.

• Parental supervision recommended when flying helicopter.

BATTERY WARNINGS

RECHARGEABLE BATTERY:

This helicopter uses an internal Li-Poly rechargeable battery and is not replaceable. If battery no longer stays charged, dispose of battery properly according to local disposal requirements.

CONTROLLER BATTERIES:

Remote control requires 6 “AA” batteries (not included). Please read the important battery safety warning below.

• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (Nickel Metal Hydride).

• Do not mix old and new batteries.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the item before being charged (if removable).

• Rechargeable batteries are only to be charged under adult supervision.

• Exhausted batteries should be removed immediately and must be recycled or disposed of properly according to state or local

government ordinances and regulations.

• The supply terminals are not to be short-circuited.

• Only batteries of the same or equivalent type as recommended are to be used.

• Batteries are to be inserted with the correct polarity (see inside booklet for diagram).

• Do not dispose batteries in a fire - batteries may leak or explode.

CARE AND MAINTENANCE

• Always remove the batteries from the wireless infrared remote control when it is not being used for an extended period of time.

• To clean, gently wipe the remote control and helicopter with a clean damp cloth.

• Keep the toy away from direct heat or sunlight.

• Do not submerge the toy into water. This can damage the unit beyond repair.

• Parental guidance recommended when installing or replacing the batteries.

FCC Part 15 B Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Conforms to safety requirements of ASTM, CPSIA and FCC.

CHOKING HAZARD - Small parts.

Not suitable for children under 3 years.

Made in China

CHROME FLYER

TM

FLIGHT INSTRUCTION MANUAL

Thank you for purchasing the Chrome Flyer™ Wireless Indoor Helicopter. Please read this instruction booklet as it contains valuable information on how to properly fly and care for your helicopter.

WARNING: Never leave product charging unattended for extended periods of time. Always disconnect helicopter from charger immediately after the helicopter is fully charged. Please refer to enclosed safety instructions.

PACKAGE CONTAINS:

Indoor Helicopter Wireless Infrared Controller Spare Propellers

Colors and styles may slightly vary.

Instruction Booklet

FEATURES

• Wide range infrared remote control specifically designed for indoor flight.

• Built-in Li-Poly rechargeable battery that connects to the transmitter for quick and easy charging (helicopter only).

• Wireless infrared remote control features 3 selectable channels that prevent signal interference when flying more

than one helicopter at a time. See back panel for additional flight precautions.

• Charging indicator light turns OFF when the helicopter is fully charged.

REMOTE CONTROL BATTERY INSTALLATION

1. Pull the battery cover off of the remote control.

2. Install 6 “AA” alkaline batteries as shown in the diagram.

3. Replace the battery cover.

Battery Cover

CHARGING THE HELICOPTER

1. Slide down the charger cover to the open position on the

front of remote control (see diagram below).

2. Make sure the helicopter power switch is set to the OFF (up) position

(see illustration and photos below). All lights and propellers should

be off.

3. Connect the charging plug on the remote control to the charging

socket on the underside of the helicopter (see diagram B).

4. Turn the controller power switch to the ON position (see

diagram C). The indicator light will illuminate to indicate

charging in progress.

5. Length of charging time will vary depending on percentage of

battery already charged and strength and condition of “AA”

batteries in the charger. Average charging time is

approximately 20 - 30 minutes. The helicopter operates

for approximately 6 - 8 minutes per charge.

6. The charging indicator light will shut-off when the

helicopter has been completely charged.

Battery Compartment

(6 “AA” batteries)

IMPORTANT: ALWAYS DISCONNECT CHARGER CORD AFTER

CHARGING. NEVER LEAVE CHARGER CONNECTED TO HELICOPTER

OVERNIGHT OR FOR EXTENDED PERIODS OF TIME.

A.

CHARGE

TRIM

L R

B.

C.

Charging socket is located on the underside of the helicopter next to the power switch. Charging cord connects as indicated.

Indicator light on charger stays on until charging is complete.

HELICOPTER DIAGRAM

Below is a basic list of features and parts on the helicopter.

Main Rotor Blade

Landing Gear

REMOTE DIAGRAM

Below is a basic list of features on the infrared wireless remote control.

Power Indicator

Throttle Control

Power ON/OFF

Channel Selector

Charging Light

Stabilizer

Power Switch

Charging Socket

Infrared Transmitter

Direction Control

CHARGE

L

TRIM

R

Trim Controls

Charging Cord Inside

NOTE: When flying your Chrome Flyer

™

with other infrared helicopters, make sure that each helicopter is set to operate on a different infrared channel to avoid interference when flying. See back panel for additional precautions.

FLIGHT AND CONTROLS

Below is a list of basic flight functions on your wireless infrared remote control and how they will affect your helicopter.

While learning to fly your helicopter, it is best to start with a large room until you get used to the basic controls. As you master flying the helicopter you can move to more advanced maneuvering through your home.

Move the throttle control up to increase the speed of the main rotor and the helicopter will rise up.

Move the throttle control down to decrease the speed of the main rotor and the helicopter will descend.

Move the direction control left and right to change the helicopters direction from left to right.

FLIGHT PREPARATION

• Verify that there are 6 “AA” batteries inside the infrared remote control unit, and the helicopter has been fully charged.

• Set the channel selector to your helicopter. Turn the infrared remote control unit’s power switch to the ON position.

• Move helicopter’s power switch to the ON position.

• Place helicopter on open floor away from spectators and breakable items.