Cigarette Lighter

Cigarette Lighter
INSTALLATION
INSTRUCTIONS
Accessory
Application
CIGARETTE LIGHTER
P/N 08U96-S9A-100
2005 CR-V
PARTS LIST
Publications No.
All 27169
Issue Date
SEP 2004
3.
Remove the driver’s dashboard under cover by
turning the knob clockwise, and releasing one clip.
Cigarette lighter
HOLDER
DRIVER’S
DASHBOARD
UNDER
COVER
KNOB
Turn
clockwise
90°.
CLIP
Fuse label
4.
TOOLS AND SUPPLIES REQUIRED
#2 Phillips screwdriver
Shop towel
Small flat-tip screwdriver
INSTALLATION
Remove the driver’s dashboard lower cover:
•
Remove the fuse box lid, and open the pocket.
•
Remove the two self-tapping screws.
•
Gently pull out on the driver’s dashboard lower
cover to release the eight clips. If equipped,
unplug the vehicle connector and remove the
lower cover.
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
VEHICLE
CONNECTOR
(If equipped.)
DRIVER’S
DASHBOARD
LOWER
COVER
VEHICLE
CONNECTOR
(If equipped.)
HOOKS (2)
FUSE
BOX
LID
POCKET
SELFTAPPING
SCREW
CLIPS (8)
RETAINING
TABS (2)
CLIP
4130110H
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27169 (0409)
08U96-S9A-1001-91
1 of 5
5.
Remove the passenger’s dashboard under cover
(release the three clips and two pins).
7.
CLIPS (3)
Remove two self-tapping screws that fasten the
heater A/C control panel to the dashboard. Pull
the heater A/C control panel out toward you to
release the four clips. Unplug the vehicle
connector, and remove the heater A/C control
panel.
SELFTAPPING
SCREW
PASSENGER’S
DASHBOARD
UNDER
COVER
HEATER A/C
CONTROL
PANEL
PINS (2)
6.
Open the dashboard pocket lid. Remove the screw
cover by releasing the two retaining clips and two
retaining tabs, and remove the dashboard pocket
(one self-tapping screw, then pull out to release
the one clip and three retaining tabs). Unplug the
vehicle connector.
VEHICLE
CONNECTOR
CLIPS (4)
4130130H
8.
RETAINING TAB
CLIP
DASHBOARD
POCKET
On A/T vehicles only, remove the two clips and
six self-tapping screws, and pull the dashboard
center lower cover out toward you to release the
six clips. Unplug the vehicle 2-pin connector from
the accessory socket, and remove the cover.
SELFTAPPING
SCREWS (6)
VEHICLE 2-PIN
CONNECTOR
SELFTAPPING
SCREW
SCREW
COVER
RETAINING
CLIPS (2)
4130121H
RETAINING
TABS (2)
VEHICLE
CONNECTOR
DASHBOARD
POCKET LID
RETAINING
TABS (2)
DASHBOARD
CENTER
LOWER
COVER
Pull
CLIPS (2)
CLIPS (4)
4404301T
CLIP
2 of 5
AII 27169 (0409)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
9.
On M/T vehicles only, remove the four seat track
end covers from the driver’s seat, then remove
the four bolts that secure the seat.
11. On M/T vehicle only, remove the two side covers
(four tabs) from the center console.
VEHICLE 2-PIN
CONNECTOR
SEAT TRACK
END COVERS
(4)
CLIP
DRIVER’S
SIDE SEAT
ILLUMINATION
BULB
Pull
SIDE COVER
BOLTS (4)
TABS (4)
10. On M/T vehicle only, pull the shift boot down
while holding the plastic clip. Remove the shift
knob from the shift lever by turning it
counterclockwise.
CLIPS (2)
FRONT
CONSOLE
TABS (4)
SIDE
COVER
CLIPS (2)
SELF-TAPPING
SCREWS (7)
PLASTIC
CLIP
SHIFT BOOT
Pull down
SHIFT KNOB
Turn
counterclockwise
to remove.
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
4404311T
12. On M/T vehicle only, remove the two clips and
seven self-tapping screws, and pull the front
console out toward you to release four clips.
Unplug the 2-pin connector from the accessory
socket, and remove the front console.
AII 27169 (0409)
3 of 5
13. Open the lid on the cigarette lighter. Using a shop
towel around a flat-tip screwdriver, gently pry on
the socket, and remove the case.
16. Connect the vehicle 2-pin connector to the socket
of the cigarette lighter assembly.
VEHICLE 2-PIN
CONNECTOR
RETAINING
TABS
CIGARETTE
LIGHTER
LID
SOCKET
CASE
SOCKET
SHOP
TOWEL
FLAT-TIP
SCREW
DRIVER
DASHBOARD
CENTER LOWER
COVER
17. Reinstall the cigarette lighter into the socket.
14. Slide the ring into the hole in the dashboard
center lower cover in the direction shown.
18. Attach the cigarette lighter fuse label (15A) over
the No. 18 spot on the back of the fuse box cover.
FUSE LABEL
LOCATING
TAB
No. 18
CUTOUT
SOCKET
RING
BACK OF
THE FUSE
BOX COVER
LOCATING
TAB
4629020H
CUTOUT
15. Align the locating tab of the socket with the
cutout in the ring, and slide the socket of the
cigarette lighter into the ring.
4 of 5
AII 27169 (0409)
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
19. Reinstall the dashboard center lower cover and
push the cigarette lighter into the socket.
20. Reinstall all removed parts. Be sure that all
retaining clips and tabs are securely fastened.
21. Check that all connectors are plugged in.
22. Reconnect the negative cable to the battery.
23. Reset the clock and the radio station presets.
24. Test the cigarette lighter.
NOTE: Whenever the battery is disconnected, the
driver’s AUTO function is disabled.
25. Start the engine. Push down on the driver’s
window switch until the window is fully open.
26. Pull up on the driver’s window switch to close the
window completely, then hold the switch for a
second or two more.
27. Test the AUTO window function.
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
AII 27169 (0409)
5 of 5
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement