null null

APEX BENCH
TM
SURFACE MOUNT INSTALLATION INSTRUCTIONS FOR BENCHES WITH ADD-ON SECTIONS
MATERIALS INCLUDED
a
5/16" hex bit for
tamper-resistant
screws
b
steel
wire brush
pencil
c
d
epoxy
TOOLS NEEDED
e
1/4", 1/2" & 7/8" drill
bits for concrete
hammer drill
epoxy gun
STEP BY STEP
dc b
Connect add-on sections
Mark hole locations
Drill holes
• Position sections so end-to-end
connection holes line up.
• Place bench in desired location. Mark
center of each hole location with a
pencil.
• Use hammer drill to drill 5" deep x 7/8"
diameter anchor hole at each marked
location using a 7/8" drill bit suitable for
concrete drilling.
• Slide 1/2" stainless steel lock washer (c)
and 1/2" stainless steel flat washer (d)
onto each 1/2"-13 x 1-1/2" socket head
cap screw (b).
• Thread into end-to-end connection holes
in sections and tighten using provided
5/16" hex bit.
NOTE: Bench is not freestanding and
must be supported during this step.
NOTE: Bench is not freestanding and
must be supported during this step.
NOTE: Forms+Surfaces recommends
starting holes with 1/4" diameter drill
bit followed by 1/2" and finally 7/8" for
maximum accuracy.
T 800.451.0410 | www.forms-surfaces.com
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
page 1 of 2 | Rev. 12-17-12
APEX BENCH
TM
SURFACE MOUNT INSTALLATION INSTRUCTIONS FOR BENCHES WITH ADD-ON SECTIONS
STEP BY STEP
b
c
d
e
a
a
Fill holes & insert anchors
Position bench
Attach bench
• Use compressed air and steel wire brush
to clean each anchor hole in accordance
with epoxy instructions.
• Position bench so that mounting holes
line up with anchors.
• Slide 1/2" stainless steel lock washer (c),
1/2" stainless steel flat washer (d), and
1/2" nylon flat washer (e) onto each
1/2"-13 x 1-1/2" tamper-resistant button
head cap screw (b).
• Use epoxy in epoxy gun to fill each
anchor hole 5/8 of the hole depth in
accordance with epoxy instructions.
• Insert 1/2"-13 x 5" epoxy anchor (a) into
each anchor hole so anchor top is flush
with ground. Allow proper curing
time according to cure schedule on
epoxy instructions before moving on to
step 5.
NOTE: Bench is not freestanding and
must be supported until steps 5 and 6
are complete.
• Insert screws into mounting holes in
bench and thread into anchors using
provided 5/16" hex bit for tamperresistant screws.
• Tighten screws until snug.
T 800.451.0410 | www.forms-surfaces.com
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
page 2 of 2 | Rev. 12-17-12

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project