Muse M-15 CR

Muse M-15 CR
LOCATION OF CONTROLS
M-15CR
Digital Alarm Clock Radio
User Manual
1. SET (TIME/ WAKE 1/ WAKE 2/
2.
REV button
3.
FWD button
4. ON/OFF button
5. SNOOZE button
6. NAP button
7. SLEEP button
8. WAKE 1 button
9. WAKE 2 button
10.BAND selector : MW/ FM
11.TUNING knob
12.VOLUME control
13.Digital Display
14.Alarm ON indicators :
1.
wake 1 to tone
1.
wake 1 to music
2.
wake 2 to tone
2.
wake 2 to tone
15.NAP indicator
16.Dial scale and pointer
17.AC Power cord
18.FM wire antenna
19.Battery backup compartment
) switch
POWERSUPPLY
AC power :230-240V ~ 50 Hz (CE standard)
DC power :9V battery type 006P (not provided) for clock back-up system only.
An alkaline type battery is recommended. For optimum performance, this
battery should be replaced every 6 months.
1. Insert the AC power cord (17) into a convenient standard AC wall outlet.
2. Connect the 9V battery inside the compartment at the bottom of the unit (19).
BACK-UP SYSTEM : Ensures that the unit will continue to operate as normal during an
AC power disruption (in order to preserve the battery life the display will not light ). All
clock settings will be kept in the memory, however, the clock time may require adjustment
for exact accuracy. If this battery is not installed, the display will blink
to indicate
that you have to redo the time and alarm settings.
Note: When the battery backup functions, the digital display will not light, however, the
wake function still occurs during the power interruption if remaining battery power is
adequate.
SETTING THE TIME
PLEASE READ THE INSTRUCTION CAREFULLY
BEFORE OPERATING THE UNIT.
1. Slide the SET(1) switch to TIME to enter clock setting mode.
2. Press REV(2) or FWD (3) to set the time.
3. Slide the SET (1) switch to lock
.
GB - 1
MOREINFORMATION
LISTENING TO THE RADIO
1.
2.
3.
4.
5.
6.
Press ON/OFF (4) button to turn on the radio.
Switch to FM or MW position with the BAND (10) selector.
For a better reception in FM, extend the antenna (18). In MW rotate the unit.
Adjust the volume (12) to the desired level.
Select your desired radio station with (11) and (16).
To stop listening to the radio, press ON/OFF (4) again.
SETTING THE ALARM AND WAKE-UP MODE
1. Slide the SET (1) switch to select WAKE 1 or WAKE 2 setting mode.
2. Press REV (2) or FWD (3) to set wake time.
3. Slide the SET (1) switch to lock
.
4. To wake up to radio follow 1 to 6 in “ LISTENTING TO THE RADIO “. Press Wake 1 (8)
or Wake 2 (9) repeatedly to select wake source for the corresponding wake setting.
When wake to radio is selected, the
indicator lights.
5. To wake up to the alarm sound, press Wake 1 (8) or Wake 2 (9) repeatedly to select
wake source for the corresponding wake setting. When wake to tone is selected, the
indicator lights.
TURNING OFF ALARM
* Silence the alarm momentarily
Press SNOOZE (5), NAP (6), SLEEP (7), REV (2) or FWD (3) to turn the alarm off
temporarily. The alarm will sound again when the snooze period is over.
Note: The “quiet” period is from 1minute to 30 minutes (the default time is 9 minutes).
Set “quiet” period as follow:
1. Press and hold SNOOZE (5).
2. Press REV (2) or FWD (3) to adjust snooze time. Release button, then the “quiet”
period is set.
* Stop the alarm
Press ON/OFF (4). Then, the alarm will be on the following day at the same time.
* Cancel Wake Settings
Press the Wake 1 (8) or Wake 2 (9) to cancel the corresponding wake function permanently.
Corresponding wake indicator turns off.
SLEEP TO MUSIC
Select FM or MW (10) then press SLEEP (7), the sound will come on for 59 min. If you
want to change this sleep time, press and hold SLEEP (7), and use REV (2) or FWD (3)
to adjust to the desired time. If you want to turn off the music earlier, press SNOOZE
(5) or ON/OFF.(4).
NAPFUNCTION
This function wakes you up after a short period of time. Only alarm sound can be
selected for Nap.
1. Press and release the NAP (6) button. The Nap indicator flashes.
2. During this period, adjust nap time by pressing REV (2) or FWD (3).
Note: The nap range is from 10 minutes to 2 hours. (the default time is 20 minutes)
3. Press NAP (6) to confirm nap time or if no button is pressed after 5 seconds, the
clock will be shown. The Nap indicator lights.
4. To stop the Nap alarm, press NAP (6) or follow “Turning off Alarm”.
5. To cancel NAP function, press and hold NAP (6) until the Nap indicator turns off.
GB - 2
ATTENTION : To reduce the risk of electric shock, do not remove
the cover. There are no user serviceable parts inside the unit.
Refer all servicing to qualified personnel.
The lightening flash with arrowhead symbol within the triangle is a warning sign
alerting the user of "dangerous voltage" inside the unit.
The exclamation point within the triangle is a warning sign alerting the user of
important instructions accompanying the product.
WARNING
- The ventilation should not be impeded by covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc.
- No naked flame sources, such as lighted candles, should be placed on the apparatus.
- Attention should be drawn to the environmental aspects of battery disposal.
IMPORTANT
- DO NOT THROW BATTERIES IN FIRE !
- THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING.
- ENSURE A MINIMUM DISTANCE OF 5CM AROUND THE APPARATUS FOR
SUFFICIENT VENTILATION.
- ENSURE THAT THE VENTILATION IS NOT IMPEDED BY COVERING THE
VENTILATION OPENINGS WITH ITEMS, SUCH AS NEWSPAPERS, TABLE-CLOTHS,
CURTAINS, ETC.
- DO NOT PLACE NAKED FLAME SOURCES, SUCH AS LIGHTED CANDLES ON THE
APPARATUS.
- TAKE ATTANTION TO THE ENVIRONMENTAL ASPECTS OF BATTERY DISPOSAL.
- USE THE APPARATUS ONLY IN MODERATE CLIMATES (NOT IN TROPICAL
CLIMATES).
- DO NOT EXPOSE THE APPARATUS TO DRIPPING OR SPLASHING.
- DO NOT PLACE OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, ON THE
APPARATUS.
- BATTERIES SHALL NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE,
FIRE OR THE LIKE.
- THE MARKING PLATE IS LOCATED ON THE BACK ENCLOSURE.
- MAINS PLUG IS USED AS THE DISCONNECT DEVICE AND IT SHALL REMAIN
READILY OPERABLE. TO BE COMPLETELY DISCONNECTED THE POWER INPUT,
THE MAINS PLUG OF THE APPARATUS SHALL BE DISCONNECTED FROM THE
MAINS COMPLETELY. THE MAINS PLUG SHOULD NOT BE OBSTRUCTED OR
SHOULD BE EASILY ACCESSED DURING INTENDED USE.
- UNDER THE INFLUENCE OF ELECTRICAL FAST TRANSIENT OR/AND
ELECTROSTATIC PHENOMENON, THE PRODUCT MAY MALFUNCTION AND
REQUIRE USER TO POWER RESET.
If at any time in the future you should need to dispose of this product please
note that Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority
or retailer for recycling advice.(Waste Electrical and Electronic Equipment
Directive)
GB - 3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement