Installation and Operation
O900
Passive Studio Subwoofer
Operating Instructions
Safety Instructions
It is absolutely essential that you read these safety instructions carefully before connecting and
using this K+H product. Your safety depends on it. Failure to follow these instructions voids the
warranty.
To ensure safe operation for years to come, keep these instructions in a safe place for future reference. K+H has
manufactured this product in accordance with IEC 92 (SEC) 39 standards, then tested and delivered it in safe operating
condition. To maintain it in this condition, you must:
•
•
•
•
observe all safety instructions
use the product only as described herein
have any maintenance, repairs, or modifications performed only by K+H or other authorized personnel
ensure that the room in which you use this product is wired in accordance with the local electrical code
Warning!
•
When the interior of the cabinet is exposed, touching some parts can lead to an electric shock.
•
If you need to gain access to the interior electronics of the unit, always disconnect the unit from any and all power
sources first.
•
Any repairs, maintenance, or other service of the unit when its interior compartment is exposed may only be performed
safely (in accordance with VBG 4) by authorized technicians familiar with all the risks involved. Even in an unplugged
state, a risk of electric shock is possible.
If you need to replace any fuses, ensure that the replacements are of exactly the same type, value and voltage as the
•
originals, as spelled out in the technical specifications at the rear of this manual.
•
Do not use "repaired" fuses.
•
If you do not have fuses of the specified size, type and value, do not hot-wire the contacts in the holder by shortcircuiting them.
•
Certain areas of the cabinet, cover, and rear panel can achieve extreme temperatures and are therefore marked with a
"HOT" label (Fig. B). Refrain from touching any heat sink or ventilation grille.
•
High volume levels are known to cause permanent - i.e. irreversible - hearing damage, especially when listened to
without sufficient breaks. The higher the levels, the more frequent and extended must be the breaks. Avoid standing too
close to loudspeakers that are being driven at high levels. If you must be exposed to high sound pressure levels over an
extended period of time, use hearing protection.
Fig. A
Fig. B
Mains Connection:
•
This unit is designed for continuous operation.
•
Ensure that the operating voltage of the unit matches that of the local mains current (AC line voltage).
•
Always check before connecting the power cable to the mains socket that the power switch on the unit itself is set to off
("O").
•
Use the power cable or power supply that came with the unit to connect to the mains socket (wall outlet).
•
Power supply: a damaged power cable may not be repaired. Use a new cable.
•
Avoid plugging the mains cable into a power strip that already has several other power-consuming devices connected to
it.
•
Avoid using extension cables. The unit must be connected to a mains socket close to it, and that socket should be freely
accessible.
Installation:
•
Installation and overhead rigging of this product must be conducted by a qualified professional according to applicable
local, national and international codes and standards. Mounting brackets supplied by the manufacturer must be
attached to appropriate hardware and attachment points rated and intended for such use.
•
Do not expose this product to vibration.
•
Do not operate this product anywhere near water or other liquids. Do not use it near a sink, swimming pool, bathtub, or
in any damp room or area. Electrical shocks carried through water can kill. Do not place any beverages whatsoever on or
near this product, as liquids can kill electronic components.
•
Ensure sufficient ventilation around the product to allow for adequate heat dissipation, especially near the rear panel
and the sides of the cabinet (minimum of 8 inches from the nearest wall). The unit may only be installed in a rack if
measures are taken to ensure sufficient ventilation and if the mounting instructions of the manufacturer are followed.
Do not block or cover any heat sink, fan, or vent.
•
Keep this product a safe distance away from radiators and other heaters of any kind.
•
If you bring this product from a cold environment into a warm one, it is quite possible that condensation will form inside
the cabinet. Please allow the unit sufficient time for acclimation to room temperature (minimum thirty minutes) before
connecting and powering up.
•
To avoid accidents, do not use any accessory equipment with this product that is not approved by the manufacturer,
particularly mounting accessories.
•
Do not place this unit on any unstable platform, cart, stand or table. If the unit falls, it can cause bodily injury to persons,
or can be damaged itself.
•
To protect this product from lightning damage during a thunderstorm or from power surges during an extended
absence, disconnect the power cable from the wall outlet.
O900 Manual
Page 2 of 6
Rev. 070707
Table of Contents
Safety Instructions ................................................................................................................................................. 2
Introduction............................................................................................................................................................ 4
Connection ............................................................................................................................................................. 4
Warranty ................................................................................................................................................................. 4
Technical Specifications......................................................................................................................................... 5
O900 Subwoofer
with O500C Main Monitor
O900 Manual
Page 3 of 6
Rev. 070707
Introduction
The O900 is a dual 12” subwoofer designed to extend the low frequency system response down to 17 Hz.
It is a passive unit and requires an external audio power amplifier for operation.
Connection
When using the O900 with an O500C main monitor system connect the speaker as follows:
ANALOGUE OR DIGITAL INPUTS
SEE O500C MANUAL
O500C
SUB OUT
LINE LEVEL
(XLR MALE BALANCED)
Power Amp
O 900
STEREO CONFIGURATION
WITH O500C
For other bass managed configurations the power amplifier driving the O900 would be connected to the
subwoofer out connection of the bass manager or monitor switching electronics.
The rear panel connectors on the O900 are two Speakon NL4 for Input and Through wired in parallel. Pins
1+ /1- are connected to both drivers in parallel. The pins 2+/2- are not used and are not wired through.
Warranty
Please store the original carton in a safe, dry place. If you should ever need warranty service, put the unit
in its original packing material and carton together with a detailed description of the problem, and ship it
(freight prepaid) to the dealer where the unit was purchased.
K+H warrants that the product is free from any defects in both material and workmanship and that it
meets the specifications published at the time of manufacture. A warranty case can only be
acknowledged under condition that the complaint is filed to our distributor in writing within 8 days after
delivery or detection of the fault. Not covered under this warranty are damages due to non-professional
packing and shipment, wear and tear, improper handling, improper installation, improper operation or
improper maintenance.
The limitation period for warranty claims is described in the terms and conditions of K+H mBH. It is our
choice to repair, to supply a new product or to withdraw from the contract.
In the event warranty service is requested, presentation of a warranty card is not necessary. Proof of
purchase date can be made by filing copies of appropriate documents (i.e. invoice or delivery notice).
O900 Manual
Page 4 of 6
Rev. 070707
Technical Specifications
Acoustical and Electrical
Frequency Response
17Hz – 200Hz
15Hz – 220 Hz
+/- 1.5 dB, free field, controlled by O500C or Pro C28
+/- 3 dB, free field, controlled by O500C or Pro C28
Power Handling
300 Watts
1200 Watts
continuous
peak
Peak Sound Level
116.4 dB-SPL
averaged between 40 Hz and 6kHz
Internal Volume
120 Litres
net
Magnetically Shielded
Yes
Driver Size
Dual 12”
Impedance
4 Ohms
(dual 8 Ohm drivers in parallel)
Connections
Input, Through
(2) Speakon NL4 connectors wired in parallel 1+, 1-
Mechanical
Cabinet Surface
Painted Finish
Color
Anthracite (RAL 7021)
Silver, white, RAL custom
Grill
Removable metal
Mounting
Support stand socket on bottom
Height x Width x Depth
15.8” x 37.4” x 20.2”
Weight
114.5 pounds
Mounting Hardware
LH 37 tripod stand adaptor
O900 Manual
Page 5 of 6
standard
by special order
Rev. 070707
K+H Vertriebs- und Entwicklungsgesellschaft mBH
#521265
Auf dem Kessellande 4a
30900 Wedemark
Germany
www.klein-hummel.com
O900 Manual
Page 6 of 6
Rev. 070707
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising