portable cd system - VOXX International

portable cd system - VOXX International
CARE & MAINTENANCE
GENERAL GUIDELINES
• Do not touch the laser lens on the CD player.
• Temperature changes can cause condensation to form on the laser
lens. If condensation forms on the lens, leave the disc compartment
door open (without disc) for an hour to remove condensation.
• Exposure to direct sunlight or extreme heat (such as inside a car
parked in the sun) can cause damage or malfunction.
• To prevent dust from reaching internal parts, keep the compartment
door closed when not using (except when necessary to remove
condensation).
HANDLING THE COMPACT DISC
It's important that you periodically clean the laser
lens:
1. Turn off the unit's power and disconnect the AC
power.
2. Open the CD door and remove the disc.
3. Clean the lens with a soft cloth or use an air
blower brush designed for cameras.
4. If you still are not able to remove dirt particles,
moisten a cotton swab with isopropyl alcohol
and gently apply to the face of the laser lens,
rubbing gently until all traces of dirt are removed.
Although the music tracks in the disc are covered
with a protective layer, it is still advisable to treat
the disc carefully. Always pick up discs by the edge
and put them back in their holders immediately after
use.
IMPORTANT NOTICES:
• Should the CD door be opened before the reading of the CD is
completed, a jamming noise may occur. This can be resolved by
closing the CD door and then sliding the FUNCTION switch
temporarily to OFF.
• If an abnormal display indication or an operating problem occurs,
disconnect the AC power cord and remove the batteries. Wait at
least 5 seconds, then reconnect the AC power cord or reinstall the
batteries.
TROUBLE SHOOTING TIPS
CD
Solutions
• Make sure AC power plug is secure in
the outlet and inlet has power.
• Batteries may be dead. Install new
batteries.
• Make sure the FUNCTION switch is set
to CD position.
• Make sure disc is clean and undamaged.
• Make sure printed side of disc is facing
up.
• Make sure PAUSE mode is not activated.
• Make sure the unit is on a secure spot.
Vibration or jarring can cause the disc
to skip.
RADIO
Problems
Poor FM reception
Solutions
• Electrical interference in your home
can cause poor reception. Move the
unit away from them (especially those
with motors and transformers).
Poor AM(MW) reception • Reposition or turn the unit for better
reception.
SPECIFICATIONS
GENERAL
Power consumption: 14 W
Power source:
AC 120V~60 Hz (USA and Canada)
AC 220V ~50Hz (China)
AC 220V ~60Hz (Korea)
AC 230V~50 Hz (Europe and Hong Kong)
AC 240V~50 Hz (Australia)
AC 110-120V/220-240V~50/60Hz (Others)
DC 9V (6 x "C" size or UM-2 batteries)
Specifications subject to change without notice.
OPERATING INSTRUCTION
Laser lens
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly wiping with
a soft cloth.
Problems
System does not turn on
Disc in place but unit
won't play
PORTABLE CD SYSTEM
The lightning flash
and
arrowhead
within the triangle is
a warning sign
alerting you of
"dangerous voltage"
inside the product.
WARNING: TO REDUCE THE
RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR
BACK) NO USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The
exclamation
point within the
triangle is a warning
sign alerting you of
important instructions
accompanying the
product.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
CLASS 1 LASER PRODUCT
CLASS 1 LASER
PRODUCT
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a low power laser device.
SAFETY PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
• Do not use the unit in places which are extremely hot, cold, dusty or
humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in a place with
poor air flow, by covering it with a cloth, or by placing it on a carpet.
ON SAFETY
• When connecting and disconnecting the AC cord, grip the plug and
not the cord itself. Pulling the cord may damage it and create a
hazard.
• When you are not going to use the unit for a long period of time,
disconnect the AC power cord.
ON AC VOLTAGE
• Before use, check that the rated voltage of your unit matches your
local voltage.
• When there is condensation inside the unit, the unit may not function
normally.
• Let it stand for 1 to 2 hours before turning the power on, or gradually
heat the room up and dry the unit before use.
FCC INFORMATION (for USA)
This device complies with part 15 of FCC Rules. Operations are subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesirable operations.
Should any trouble occur, disconnect the AC power cord and refer
servicing to qualified personnel.
RATING PLATE LOCATION
The rating plate location is on the bottom of product.
811-136191-011
Printed in China
NAMES OF CONTROLS
ADJUSTING
THE SOUND
J
VOLUME
Adjust the VOLUME control of the stereo system to a desired level.
1
FOR PRIVATE LISTENING
Connect headphones (Ø3.5 mm stereo mini-plug) to the PHONES
jack.
When headphones are connected, speakers automatically
disconnected.
2
6
7
8
3
4
RADIO OPERATION
5
9
You can listen to your favourite radio stations by sliding the FUNCTION
switch to RADIO, and then
10
1. Slide the BAND switch to choose AM(MW) or FM.
2. Using the TUNING control to choose a desired station.
11
12
13
•
Adjust the VOLUME.
AM(MW)/FM
• Repositioning the unit to get better AM(MW)/FM reception.
14
1.
2.
3.
4.
5.
Handle
CD door
STOP button
PLAY / PAUSE
CD display
button
Track number
Play " " indicator
Pause "
" indicator
Repeat all " " indicator
Repeat one "
" indicator
6. SKIP
button
7. SKIP
button
8. REPEAT
button
9. Tuning control
10. BAND switch
11. PHONES
jack
12. VOLUME control
13. FUNCTION switch
14. AC socket
USING THE CD PLAYER
1. Slide the FUNCTION switch to CD. "
" is shown in the display.
2. Open the CD door. Place a disc in the centre with the label side
up and then close the CD door gently. The total number of tracks
will show in the display.
3. Press the PLAY/PAUSE
button to start play. The PLAY "
"
indicator will light.
• Adjust the VOLUME.
TO STOP PLAYBACK
• Press the CD STOP button to stop disc play.
POWERING UP
AC POWER
You can power your portable stereo system by plugging the detachable AC power cord into the AC inlet on the back of the unit and into a
wall AC power outlet.
Check that the rated voltage of your unit
matches your local voltage. Make sure
that the AC power cord is fully inserted
To AC inlet
into the unit.
Caution: (for North America)
To prevent electrical shock, match wide
blade of plug to wide slot, fully insert.
Note
After listening, slide the FUNCTION switch to OFF.
To wall AC outlet
Note : When not being used on mains the AC cord should be unplugged
from the unit.
TO INTERRUPT PLAYBACK
• Press the PLAY/PAUSE
button while a CD is playing to pause
play (the PAUSE "
" indicator will blink).
• Press the PLAY/PAUSE
button again to resume play.
TO SKIP TO THE BEGINNING OF A TRACK
• Press either one of the SKIP
or
button according to the desired
direction. Each press skips one track. During play, the first press on
the skip backwards
button to the beginning of the current track.
• Playback resumes from the selected track.
TO SEARCH THROUGH TRACKS
• Keep either one of the SKIP
or
button pressed, according to
the desired direction, and release at the desired point.
BATTERY POWER
Insert "C" size batteries in the battery compartment. Be sure that the
batteries are inserted correctly to avoid damage to the unit.
• Always remove the batteries when unit will not be used for a long
period of time, as this will cause leakage of the batteries and
subsequently damage to your unit.
• Playback will automatically come to a stop when the batteries have
no more power. Replace all the batteries with new ones.
• Do not mix old and new batteries. Do not mix ALKALINE, standard
(CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries.
REPEAT PLAY -- in play modes
This function allows one track or all tracks on a disc to be played
repeatedly.
TO REPEAT THE SAME TRACK
• Press the REPEAT button once during playback, the REPEAT ONE
"
" indicator will blink.
TO REPEAT THE WHOLE DISC
• Press the REPEAT button a second time to repeat all tracks, the
REPEAT ALL " " indicator will light.
TO CANCEL REPEAT PLAY
• Press the REPEAT button until the REPEAT indicator is turned off.
Note
Repeat play can only be done when the unit is in the play mode.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement