RADIO RECEIVER RHRFSP20 FCC ID: This device complies with

RADIO RECEIVER RHRFSP20 FCC ID: This device complies with
Select
Engineered
Systems, Inc.
RADIO RECEIVER
RHRFSP20
GENERAL INFORMATION
BUTTON SELECT
The RHRFSP20 is a 54 bit rolling code receiver and decoder.
It is capable of storing up to 200 different rolling code
transmitters. When a matching rolling code transmitter
is received with the proper button select, the internal
form “C” relay will operate.
The button select switch matches the transmitter
button pressed with the jumper installed. The left
button on the transmitter is select button 1 and the
right button on the transmitter is select button 2.
TECHNICAL SPECIFICATIONS
Button 1
Power supply
Power consumption
Receiver type
Reception frequency
Frequency stability
Receiver sensitivity
Code received
Output
Output type
Signal
Button select number
Operating temperature
Storage temperature
This figure shows button 1 enabled for this receiver
: 12/24 Volts ac or dc
: 22 mA / 40 mA
: Super-Heterodyne
: 433.920 MHz
:+- 100 kHz
: < 1.5 uV
: 54 bits rolling code
: 1 Form “C” relay, .5A @ 24V
: Mono-stable or Bi-stable
: Red LED
: One
: -10C to +55C
: -40C to +85C
3
4
5
6
7
8
9
1 2 3 4 5 6 7 8 9
1
2
3
4
5
6
7
8
9
NO COM NC NU AS ANT
RELAY
+24 ac/dc
PSC power supply common
+12 ac/dc
NO normally open relay contacts
COM Relay
NC normally closed relay contacts
NU Not used
AS Antenna Shield
ANT Antenna core
Programming LED
PROGRAMMING one or more transmitters into receiver.
3.
4.
5.
+ +
24 PSC 12
Button 4
Relay output select
ON = Mono-stable
OFF = Bi-stable
CONNECTIONS
2
Button 3
Programming button “P”
1.
2.
1
Button 2
6.
Press button “P” the LED will light solid.
Press button on transmitter to be programmed.
Programming LED will flash. When LED stops flashing
transmitter number has been programmed in receiver.
Press button on next transmitter to be programmed.
Follow the sequence in step 2.
Continue until all transmitters have been programmed.
When finished programming all transmitters, press button
“P” to exit programming mode.
If no transmitters are received within any 10 second
period the receiver will automatically exit the program
mode.
ERASING all transmitter numbers fro m receiver.
1.
2.
3.
Press and hold button “P” until programming LED starts
flashing, then release button “P“.
Press button “P” within 6 seconds to confirm erasing all
transmitters from memory.
Programming LED will flash faster when memory is
erased.
FCC ID:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesirable operation
• 7991 West 26th Avenue • Hialeah, Florida 33016
1 (800) 342-5737 • (305) 823-5410 • Fax: (305) 823-5215
E mail [email protected] * web site www.selectses.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement