USB to Serial Cable User Manual

USB to Serial Cable User Manual
USB to Serial Cable
User Manual
Ver. 1.00
All brand names and trademarks are properties of their respective owners.
Apr/04
1
MNPL2303X001
Overview
The USB to Serial Cable provides a simple and easy way to connect Universal Serial Bus and Serial Port interface. With the USB
properties of plug and play & hot swap, end users can easily connect any serial devices to computer via the cable. It is the most
convenient way to connect cellular phone, modems, ISDN terminal adapter and other serial peripherals. The software driver is well
written that most serial peripherals can be configured as if they were connected to the conventional serial ports without any firmware
or hardware changes.
Features
y
Chipset:
PL2303X
y
Connectors:
1 x USB Type A Connector
1 x DB9 Male Connector
y
Length:
1.5m (end-to-end)
y
Bandwidth:
over 1Mbps transfer rate
y
Fully compliant with Universal Serial Bus Specification Version 1.1
y
Supports RS232 serial interface
y
Supports remote wake-up and power management
y
Supports automatic handshake mode
y
Bus Powered from either USB port
y
File synchronization
y
Supports Windows 98SE, Windows ME, Windows 2000 & Windows XP, Linux Kernel V2.4 and later
Driver Installation
Windows XP
1. Locate the F:\PL2303X
and double click
Setup.exe (Where F is CD-ROM)
Apr/04
2
MNPL2303X001
2.
3.
Select Next
to continue installation.
Click Finish.
4. If the driver is installed successfully, you will
see the
following devices under Device
Manager:
Uninstalling the Device Driver
It is easy to uninstall the USB to Serial device driver. You have three selections uninstall the PL-2303 driver:
♦ Run the InstallShield Setup “PL-2303 Driver Installer.exe” program again
♦ Run Start
Programs
PL-2303 USB-Serial Driver
Uninstaller
♦ Control Panel
Add or Remove Programs
PL-2303 USB-to-Serial
Apr/04
3
MNPL2303X001
1. The InstallShield Wizard will appear and will
let you choose if you want to reinstall the driver,
uninstall the driver or exit the wizard. Select to
Uninstall driver, and then click Next to continue.
2.
Click Finish to restart the computer.
Windows 9x
The path of the driver is F:\PL2303X\Setup.exe
Windows 2000
The path of the driver is F:\PL2303X\Setup.exe
Windows ME
The path of the driver is F:\PL2303X\Setup.exe
Apr/04
4
MNPL2303X001
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising