Lenco Watchradio+CD CR-2400 CD

Lenco Watchradio+CD CR-2400 CD
DELUXE ALARM CLOCK
STEREO RADIO
COMPACT DISC PLAYER
CR-2400 CD
INSTRUCTION MANUAL
INTRODUCTION
Thank you for purchasing our product. You now possess a stylishly designed quality deluxe
stereo Compact Disc Player/Alarm Clock Radio.
Used carefully and in accordance with the instructions set out below your stereo Compact Disc
Player/Alarm Clock Radio should give you many years of trouble free service.
Please read the instructions carefully to obtain the best results from your purchase.
THE PROPER USE OF THIS UNIT
To ensure proper and safe use of this unit, please pay your special attention to these DOs &
DON'Ts.
This unit has been designed and manufactured to meet the highest International standards,
but, like any electrical apparatus, care must be taken if best results and safety are to be
assured.
DO read the operating instructions carefully before you attempt to use this unit.
DO Ensure that all electrical connections, including the mains plug and extension leads
used, are properly made and in accordance with the manufacturers instructions.
DON'T operate this unit if you have any doubt about it working normally, or if it is damaged in
any way; disconnect from the AC Mains and consult a qualified engineer.
DO always ask the advice of a qualified engineer if you are ever in doubt about the operation
or safety of this unit. He/She is the best person to advise you.
DON'T expose this unit to rain or moisture to prevent fire or electric shock hazards.
DON'T continue to operate this unit if you have any doubt about it working normally, or it is
damaged in any way, withdraw the mains plug and consult a qualified engineer.
DON'T remove any fixed cover unless you are qualified to do so, and even then, disconnect
from AC mains before you start.
DON'T obstruct any of the ventilation slots in this equipment, or stand it close to curtains or on
soft furnishings such as carpets. Obstructing these ventilation slots may cause overheating
and shorten the life of the unit.
ABOVE ALL
Never let children push anything into holes or slots in the cabinet or casing this could result in
an electric shock! Never guess or take a chance with this unit it is better to be safe than
sorry!
CAUTION: THIS APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR
SPLASHING!!!
IDENTIFICATION OF CONTROLS
1. AUTO/ALARM SWITCH
2. CD PROGRAM BUTTON
3. CD SKIP BACKWARD BUTTON
4. CD SKIP FORWARD BUTTON
5. CD STOP BUTTON
6. BAND SELECTOR
7. TUNING CONTROL
8. CD DOOR OPEN/CLOSE
9. CD PLAY/PAUSE BUTTON
10.CD REPEAT BUTTON
11. POWER ON/OFF BUTTON
12.
HOUR SET BUTTON
13. RADIO/CD MODE BUTTON
14. MINUTE SET BUTTON
15. VOLUME DOWN BUTTON
16. VOLUME UP BUTTON
17. SLEEP BUTTON
18. TIME SET BUTTON
19. ALARM SET BUTTON
20. PHONES JACK
21. AC VOLTAGE SELECTOR( For dual
voltage)
22. LCD DISPLAY
23. SNOOZE BUTTON
24. FM ANTENNA
25. BATTERY COMPARTMENT
POWER SOURCES
MAINS POWER
Plug the AC MAINS POWER PLUG into the standard household AC receptacle. The L CD
display will show 0:00.
Warning: Before insert the MAINS POWER PLUG into the household receptacle,
please make sure the AC VOLTAGE SELECTOR MUST be set to your local
voltage.(optional)
BATTERY STANDBY
Connect a 9V battery (note: not supplied) into the BATTERY COMPARTMENT to keep the
clock
Running and memorizing when the mains power is disconnected.
RADIO OPERATION
1.
2.
3.
4.
5.
6.
Press POWER ON/OFF button to turn on the unit.
Press RADIO/CD function switch to set the unit to radio play mode.
Set the BAND SELECTOR to the desired band.
Tune in to the desired station by turning the ROTARY TUNING CONTROL, the LCD
display will show the frequency you are receiving.
Adjust the volume level via the electronic VOLUME UP/DOWN CONTROL.
Extend the FM WIRE ANTENNA or adjust the direction and position of the whole unit
to obtain the best possible radio reception.
HEADPHONE SOCKET
This is a facility specially provided for private listening. Connect a 3.5mm Headphone Jack
Plug of your Headphones/Earphones (note: not supplied) into the PHONES SOCKET, and
adjust the electronic VOLUME UP/DOWN CONTROL to a comfortable level. During the use of
headphones/earphones, the built in speakers are automatically disconnected.
TIME SETTING
Depress the TIME SET BUTTON with one hand, and press the HOUR SET BUTTON and the
MINUTE SET BUTTON to correct hour and minute with another hand. Release the buttons
when time setting finished.
You may also press and hold the HOUR SET BUTTON and the MINUTE SET BUTTON to skip
to correct time continuously.
ALARM TIME SETTING
Depress the ALARM SET BUTTON with one hand, and press the HOUR SET BUTTON to
desired hour; Press the MINUTE SET BUTTON to desired minutes with another hand.
Release the buttons when alarm time setting finished. ALARM SETTING
Set the desired alarm time as ALARM TIME SETTING described, slide the ALARM/AUTO
switch to ALARM, press ALARM SET button until
appears on the LCD display..
To the set alarm time, alarm(buzz) will sound automatically. To pause the alarm temporarily
and sleep another 9 minutes, press the SNOOZE BUTTON, the buzz stops and resume in 9
minutes.
Press POWER button to stop the alarm, and turn off the unit.
SLEEP (AUTO-STOP) FUNCTION
To switch off the CD or RADIO playing automatically in 90/60/30/10 minutes before you fall
asleep, start RADIO or CD playback, press the SLEEP BUTTON, each time you press, the
LCD display will show 90/60/30/10 sequently, then slide the ALARM/AUTO selector to AUTO.
After 90/60/30/10 minutes, the playback will stop automatically.
To resume playing, press SLEEP BUTTON once again.
WAKE UP TO MUSIC (CD or radio)
1. Set the alarm time as ALARM TIME SETTING described.
2. Press CD/RADIO to switch the unit to RADIO or CD mode.
3. Tune to desired broadcasting programme follow steps of RADIO OPERATION. Or
Start CD playing follow steps in CD OPERATION.
4. Set the ALARM/AUTO selector to AUTO.
5. Press ALARM SET button until
appears on the LCD display.
To the pre-set alarm time, RADIO or CD turns on automatically. To pause the music
temporarily and sleep another 9 minutes, press the SNOOZE BUTTON.
6. Press POWER button to turn off the unit.
CD OPERATION
HANDLING A DISC
Although built to withstand a certain amount of the effects from dust, soil and scratches, discs
should be treated with the care normally accorded to conventional analog discs (records).
Always protect a disc against scratches, soil and dust etc. We recommend that during non-use
periods the discs should be stored in the original case.
Bear in mind the following points, since any dirt, scratches or
warping of the disc can cause broken or intermittent sound and also
noise.
When holding the discs, take care not to touch the playing
surface.
Store the discs in their cases. Return them to their cases
with the label surface facing up and push down lightly on
the label surface.
Do not place discs in the following locations:
Near a heating device or a place where the temperature is high
or in dusty areas.
Do not write on the label surface using a ballpoint pen and
do not stick labels on the CD.
Wipe away any fingerprints or dust on the playing surface of a
disc using a soft cloth.
Bear in mind the following points:
Always wipe from the inside toward the outside of the disc.
Never in a circular motion.
Do not use conventional record cleaners, anti-static agents,
benzene, thinner or other solvents.
Note:
CDs which can be played on this unit must have the following mark on them:
This unit is compatible with CD-Rs/CD-RWs based on audio data.
USING THE CD
LOADING A DISC
1. Set the FUNCTION switch to CD position.
2. Open the CD door.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door.
The total number of tracks will appear on the display.
5. To remove the CD, press OPEN to open CD compartment lid, grasp the CD by its edge, and
carefully take it out.
Note:
To ensure good system performance; wait until the disc tray completely reads the disc
before proceeding.
If no disc loaded into the compartment, or the disc is unreadable, the display will show 00.
PLAYING A DISC
1.
2.
Press PLAY/PAUSE button to start playback.
The playback starts from track 1,
appears on the display.
To pause, press PLAY/PAUSE button.
flashes on and off on the display.
To resume playback, press PLAY/PAUSE button again, PLAY become steady on the
display.
To stop playback, press STOP button, The total number of tracks appears on the
display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press SKIP FORWARD(NEXT)/BACKWARD button repeatedly in stop mode or during
playing until the desired track appears on the display.
Press PLAY/PAUSE button to start play.
To search for a particular passage during playback( track scanning at high
speed)
Press and hold SKIP BACKWARD/FORWARD button to scan the current playing track at high
speed until desired point(passage), then release the button.
Playback will start again from this point.
PROGRAM TRACKS
Program tracks of disc are possible when playback is stopped. Up to 20 tracks can be stored
in the memory in any order.
1.
In stop mode, press PROG button to enter program setting, the
flashes on and off on the display.
2. Press FORWARD SKIP button to select the first desired track to be programmed.
3. Press PROG button to enter. The display shows
flashing for programming the next
track.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
5. Press PLAY/PAUSE button to start playback from the first programmed track. The display
will show
6. Press
STOP button to stop program playback.
To Erase the Memory(Program)
To clear the program, you may have two ways:
1. Press STOP button when the disc stopped, or
2. Open the CD compartment lid, program will be erased.
REPEAT
You can play one track or all tracks on the disc repeatedly.
To Repeat a Single Track
1. Press REPEAT button once in play, "REPEAT" shows flashing on the display. The current
track will be played over and over again till you press STOP button.
2. To cancel repeat play, press REPEAT button twice. "REPEAT" goes off from display.
To repeat all the Tracks
1. Press REPEAT button twice in play, "REPEAT" shows steady on the display, all tracks on
the disc will be played over and over again till you press STOP button.
2. To cancel repeat play, press REPEAT button once. "REPEAT" goes off from display.
Note: Repeat function also can be done in stop mode.
SPECIFICATIONS
Power Requirement .................................................AC110 / 220V (Selectable) or
120/ 220V (Selectable) or
120 / 230V (Selectable) or
127 / 220V (Selectable) or
110V or 220V or 230V or 240V
(YOUR EXACT AC POWER CAN
BE CHECKED FROM THE BACK
PLATE OF UNIT)
Power consumption .................................................AC 13 Watts
Operation temperature............................................ +5 o C +35 o C
RECEIVER SECTION
Receiving Bands.....................................................AM/FM
Tuning Range ........................................................ AM
530 - 1600 KHz
FM
88
- 108 MHz
COMPACT DISC SECTION
Optical Pickup.........................................................3-Beam Laser
Frequency Response...............................................100Hz - 16KH z
AUDIO SECTION
Power output ........................................................ .Maximum 1.2 Wattx 2
Headphone Impedance ...........................................4 ~ 32 Ohms
ACCESSORIES
Instruction Booklet........................................................................1
Specifications are subject to change for performance improvement without notice.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement