advertisement
COMPRESSION DRIVER HORN SPEAKER
H30LT
H30LT-G Compression Driver Horn Speaker
The H30LT-G is a powerfull weatherproof industrial horn loudspeaker with compression driver.
This hornspeaker offers you a high sound pressure ideally suited for speech and the reproduction of alarm signals. Ideal for long-distance and outdoor use.
The H30LT-G is made out of high impact ABS, supplied with a stainless steel bracket to avoid corrosion.The loudspeaker is equipped with a high quality 100 volt transformer with several power taps, and can be used in 8 ohm systems as well.
The APart technology avoids any overload of your amplifi er by controlling the impedance with the unique IMC protection device inside.
Mounting the loudspeaker
A stainless steel mounting bracket for mounting is included in the packing.The bracket allows you to rotate the speaker over a range of more than 180 degrees. Securely mount the bracket to a wall or other solid surface.
Connect the speaker line with the included speaker wire and make sure that all connections are weather proof.
The desired power can be selected with the rotary switch at the back of the unit. After setting the power selector at the rear, remember to put the supplied sealing plug back in place.
Power Tappings
SETTING
1
2
3
4
5
6
POWER
3.75 WATTS
7.5 WATTS
15 WATTS
30 WATTS
OFF
30 WATTS
100 Volt Technology
IMPEDANCE
2K6 Ω
1K3 Ω
666 Ω
333 Ω
OFF
8 Ω
Technical Specifications
●
Type : Compression driver horn speaker
●
Material : high impact ABS
●
Standard colour : light gray RAL7035
●
Rated power RMS : 30 Watts / 100 volt
●
Music power RMS : 45 Watts / 100 volt
●
Transformer power taps by rotary switch :
3.75 / 7.5 / 15 / 30 Watts @ 100volt
●
Rated power RMS : 30 W / 8 ohm
●
Music power RMS : 45 W / 8 ohm (lo-cut)
●
Impedance: 100 volt / 8 ohm
●
SPL 1W/1m : 109 dB, max 123dB
●
Frequency range: 320 - 9000 Hz
●
Dispersion (H x V): 90° x 130°
●
IP Rating: 66
●
Cable length : approx. 40 cm
●
Dim. Outside (mm) H x W x L : 208 x 285 x 290
●
Weight including bracket : 2.05 Kg
●
Mounting holes : 3 x Ø10 mm, 51 mm spacing
112.5 Watts = 30 + 30 + 15 + 15 + 7.5
+ + +
120Watt Amplifi er
Amplifi er power must be higher than total power of all speakers.
Het versterkervermogen moet hoger zijn dan de som van de vermogens van de luidsprekers.
La puissance de l’amplifi cateur doit etre plus élevée que la puissance totale des haut parleurs.
WWW.APART-AUDIO.COM
[email protected]
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project