Star Track SRT 2016 Decoder - Installation Instructions

Star Track SRT 2016 Decoder - Installation Instructions
Amazing Discoveries Ministries Africa
Mobile: +27 72 500 3934
Fax: +27 86 573 3934
Email: media@amazingdiscoveries.co.za
Web: www.amazingdiscoveries.co.za
Star Track SRT 2016 Decoder - Installation Instructions:
1. Connect the decoder to the TV by using the “DV-OUT” connector or the red/white/yellow
RCA connectors
2. Connect the cable from the sattelite dish to the “LNB IN” connector
3. Connect the power cable to an 220v outlet
4. Switch on the decoder at the back next to the power cable
PLEASE NOTE - All channels should be working as this decoder was scanned and tested and ALL
channels were saved.
NB!!!!! - ONLY follow the steps below if the following message is displayed:
“NO SIGNAL”
On the remote control:
1. Press “MENU” (Middle Left)
2. Use right arrow once to move to “Utility” menu
3. Use down arrow once to sellect “Factory Reset” and press “OK”
4. Enter the following password – 0000 – and press “OK”
5. Use left arrow once to return to “Installation” menu
6. Press “OK” on “Antenna Setting”
7. On the top line called “Satellite”, use the right arrow and change “(1/84) Intelsat 7/10K” to
“(7/84) Intelsat 7/10K”
8. Use the down arrow and move to the last line labelled “Start Search”
9. On this last line use the right arrow to change “Satellite” to “Blind”
10. Press OK
11. Use the up arrow and move to the line called “FTA Only”
12. Use the right arrow to change “NO” to “YES”
13. Press “OK”
14. The decoder will scan for about 5-10 minutes
15. Press “OK” to Save all channels and then “EXIT” until back to normal TV screen.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising