Acer | SO.SA000.A00 | Datasheet | Acer Altos Array G540 SAS controller

2
How To add the SAS controller
The first thing to do is to check the position of the jumper JP3. It must
be short pins 2-3, as shown in the picture below.
3
Plug the first SAS Cage cable into the bottom
connector.
Plug the card into the horizontal white connector, close to the
Green PCI-X slot and then secure it to the mainboard with a
screw.
4
Please download the latest firmware and bios
from the Acer support website and upgrade
the card.
http://support.acer-euro.com
All the How To guides can be found on http://support.acer-euro.com/documents/howto/
SO.SA000.A00 - Altos Array G540 SAS controller, SAS 8 ports. Support RAID 0,1, Daughterboard
plus cables, does not take PCI slots
46.SA000.A01
1
Download PDF

advertising