5. Aim the remote control at the TV and press the POWER

5. Aim the remote control at the TV and press the POWER
This remote is already preprogrammed to control your Set Top Box (STB). The
instructions below will program this remote to control your TV. Please be sure that you
are within arms reach of your TV, so that the devices can communicate effectively.
1. Make sure your TV is on and that you see a picture.
2. On the remote control, press the TV button
once (top left side of the remote); it will blink
once.
3. Then press and hold SETUP for 3 seconds
until the TV button blinks twice.
4. Type 9 9 1. The TV button will blink twice.
5. Aim the remote control at the TV and press the
POWER button once.
The TV button will
light up.
6. Press and release the CH+ key continuously,
until the TV turns off. This may take two
minutes or more.
7. Press POWER.
The TV should turn on.
Note: If the TV does not turn on during step 7,
slowly press and release the CH– key until the TV
turns on.
8. Press SETUP once to lock in the code. The TV
button will blink twice to indicate that the
code is saved.
9. Check to see if the volume and mute buttons are
working.
To program this remote to control your other devices,
repeat steps 1 through 8, but substitute the appropriate
key (VCR, DVD, AUD) for the device you wish to program.
PAGE 1
After you have completed the instructions on the reverse side, you
can program your remote control to turn your Set Top Box (STB) and
TV on and off simultaneously, also known as Master Power. Having
Master Power set will eliminate the need to hit more than one
button when turning your TV off and on.
1. Make sure your TV is on and you can see a picture.
2. Press the STB button (located on the top right side of
the remote). The STB button will flash once when you
press it.
3. Press and hold the SETUP button
STB button blinks twice.
for 3 seconds until the
4. Press 9 9 5. The STB button will blink twice after you hit the 5
button.
5. Aim the remote at the TV and press the POWER
button once. The STB button will blink once.
6. Press the TV button.
Press the STB button.
(The TV and STB buttons will light up when pressed.)
7. Press and hold the SETUP
STB button blinks twice.
button for 3 seconds, until the
The Master Power is now set.
PAGE 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement