reasons to buy a JBC station
TOP 10
reasons to buy
a JBC station
The key to successful hand soldering in lead free era
1. Low Temperature Soldering:
6. Ergonomic Design:
High Power / mass ration tips and integrated
heater / thermocouple delivers the best thermal
recovery and lower soldering temperatures.
The JBC soldering iron are currently the lightest,
smallest and most ergonomic handpiece
available. Offering the shortest tip-to-grip
distance and a higher working performance.
2. Read & Feed:
We use one wire buried deep in the tip of the
copper to “read & feed.” Our thermocouple
and heating element are one in the same and
are microprocessor driven over a sensor at 60
hertz (60x a second) utilizing up to 140 watt
transformer. This is why our thermal performance
cannot be matched.
3. Initial Heat Up:
A conventional station takes between 10 to 90
seconds to reach 350° C. Any JBC station with
a T210 hand piece reaches this temperature in
only two seconds.
4. Outstanding Tip Life:
Lasting up to 5 times longer as soon as
the soldering iron is left in the stand, the tip
temperature automatically drops to 180°C,
decreasing oxidation and wear. When the
soldering iron is taken out of the stand again,
the working temperature is instantaneously
reached.
NOTE: It varies by tip geometry, temperature
settings, solder, flux, and the operator ability.
5. Quick Change Over Tips:
No tools needed to change the tip. Just place in
holder, pull and insert the new tip. Reduces your
idle time while increasing operator safety.
7. Process Control:
Regain control of your process! Set temperatures
limits, read counters, block the station with PIN
or block the keypad.
8. Intelligent Heat Management:
Extend tip life by reducing temperature and
reduce energy usage to 10 watts during sleep
and 4 watts when hibernating.
9. Easy Calibration:
Since JBC technology is microprocessor driven,
it not necessary to recalibrate any of the JBC
stations but, if required, calibration of the
soldering tip can easily be done by using our
Thermometer and the temperature adjustment
of the station’s menu.
10. Improved Productivity:
The JBC technology gives an 80% improvement
over the performance of the best soldering
station available in the market.
In the following graphs, based on practical test,
we show this superiority.
2
seconds
HEAT UP
TOP 10
reasons to buy
a JBC station
The key to successful hand soldering in lead free era
TIME TO REACH 350° C
The graph shows responsiveness of a
standard station compared to a JBC
station.
A standard station needs between 10
and 90 seconds to reach 350ºC,
while any JBC station equipped with
a T210 handpiece reaches the same
temperature in only 2 seconds.
Difference in thermal r esponse: 8 sec.
The superior responsiveness of the JBC
system could not be clearer.
2
4
6
8
10
Conclusion:
JBC tools have the fastest thermal response in the market
PROCESS FOR 3 SOLDER JOINTS
This graph shows the same tool,
performing a series of 3 solder joints.
Because of the lacking thermal
response of the competing (grey)
tool, the temperature drops 70° C
compared to 30° C for the JBC tool.
This difference gets bigger as the
solder job gets more demanding.
Time exceed
5,5 sec.
2
4
6
8
10
JBC tools can solder efficiently at 350°C,
competitor’s tools can’t.
www.jbctools.com
0009480/0712
Conclusion:
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement