CAUTION
WARNING
CLASS 1 LASER PRODUCT
CLASS 1 LASER PRODUCT
APPAREIL Á LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a low power laser device.
Warning: Do not touch the lens.
DO NOT THROW BATTERIES IN FIRE !
PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT
• Do not use the unit in places which are extremely hot, cold, dusty, or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in a place with poor air flow, by covering it with a cloth, or by placing it on a carpet.
ON SAFETY
• When connecting and disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may damage it
and create hazard.
• When you are not going to use the unit for a long period of time, disconnect the AC power cord.
ON AC VOLTAGE
• Before use, check that the rated voltage of your unit matches your local voltage.
ON CONDENSATION
• When left in a heated room where it is warm and damp, water droplets or condensation may form inside the CD player.
• When there is condensation inside the unit, the unit may not function normally.
• Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use.
* Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation.
* Ensure that the ventilation is not impeded by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc..
* Do not place naked flame sources, such as lighted candles on the apparatus.
* Take attention to the environmental aspects of battery disposal.
* Use the apparatus only in moderate climates (not in tropical climates).
* Do not expose the apparatus to dripping or splashing.
* Do not place objects filled with liquids, such as vases, on the apparatus.
•
Mains plug is used as the disconnect device. It shall remain readily operable and should not be obstructed during
intended use. To be completely disconnected the apparatus from supply mains, the mains plug of the apparatus shall
be disconnected from the mains socket outlet completely.
* Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
* The mains plug of apparatus should not be obstructed OR should be easily accessed during intended use.
Should any trouble occur, disconnect the AC power cord and refer servicing to qualified personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightening flash
with arrowhead symbol
within the triangle is a
warning sign alerting
the user of "dangerous
voltage" inside the unit.
ATTENTION : To reduce the risk
of electric shock, do not remove the
cover. There are no user serviceable
parts inside the unit. Refer all servicing
to qualified personnel.
The exclamation point within
the triangle is a warning sign
alerting the user of important
instructions accompanying
the product.
In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting it from mains supply.
THE MARKING PLATE IS LOCATED AT THE BACK OF ENCLOSURE OF THE APPARATUS.
LOCATION OF CONTROLS
1.
VOLUME CONTROL
2.
FUNCTION SWITCH
3.
CARRYING HANDLE
4.
CASSETTE PAUSE
5.
CASSETTE STOP/EJECT
6.
CASSETTE F.FWD
7.
CD OPEN BUTTON
8.
CD DOOR
9.
CASSETTE REWIND
10. CASSETTE PLAY
11. FM STEREO INDICATOR
12. MODE SWITCH
13. TUNING CONTROL
14. LCD DISPLAY
15. SPEAKER
16. CD PLAY / PAUSE BUTTON
17. CD NEXT BUTTON
18. CD BACK BUTTON
19. CASSETTE DOOR
20. CD PLAY MODE BUTTON
21. CD PROGRAM/CLOCK ADJ. BUTTON
22. CD STOP
BUTTON
23. STANDBY BUTTON
24. PHONES JACK
25. TELESCOPIC ANTENNA
26. BATTERY COMPARTMENT
27. AC SOCKET
POWER SUPPLY
USING HOUSE CURRENT
Before use, check that the rated voltage
of your unit matches your local voltage.
To AC socket
Note: Plug is used as the disconnect device.
The disconnect device shall remain readily
operable.
To AC outlet
USING BATTERIES
Disconnect the AC power cord from the AC inlet of the
unit. Battery power is cut automatically by the cord while
it is connected.
When the volume decrease, or the sound distorts, replace
all of the batteries with new ones.
Insert eight UM-2
(size C) batteries.
battery door
ADJUSTING THE SOUND
TO ADJUST THE VOLUME
VOLUME
MIN.
VOLUME
MAX.
WHEN RECORDING
The VOLUME control may be adjusted with no effect on
the recorded signal.
FOR PRIVATE LISTENING
Plug in headphones (ø3.5 mm stereo mini-plug) to the
PHONES jack.
When headphones are plugged in, the speakers are
automatically disconnected.
GB 1
TURN ON / OFF THE SYSTEM
Press the STANDBY button to turn the audio on.
To change the audio mode between CD, RADIO AND TAPE ,
set the FUNCTION switch while the power is on.
The audio mode is displayed.
Turn off the unit by pressing the STANDBY button and
the current time is shown on the display.
standby
CLOCK ADJUSTMENT
The clock is displayed �������������������������������
on LCD display at standby mode.
program/
1. Press the PROGRAM / CLOCK-ADJ. button,
CLOCK-ADJ.
2. Press the
or
to select 12 hours or 24 hours display.
3. Press the PROGRAM / CLOCK-ADJ. button, ���������������������
the hour digit flash.
4. Press the or to adjust hour digit.
5. Press the PROGRAM / CLOCK-ADJ. button, the minute digit flash.
6. Press the or to adjust minute digit.
7. Press the PROGRAM / CLOCK-ADJ. button again, the correct time is shown on display.
LCD display
LISTENING TO THE RADIO
1 . Turn on the unit by
press STANDBY
button.
2 . Set to RADIO
4 . Tune to the desired radio station by using TUNING
knob and frequency is displayed.
TUNING
FUNCTION
RADIO
5 . Adjust the sound.
VOLUME
3 . Select a MODE.
MODE
FM ST.
FM MONO
MIN.
MAX.
VOLUME
FOR BETTER RECEPTION
FM
NOTE : 1. FM stereo LED indicator lights if receive FM stereo broadcast and the MODE switch set on "FM STEREO".
2. When too much noise is heard during FM STEREO reception, set MODE switch to FM mono.
AFTER LISTENING
Press the STANDBY
button.
GB 2
COMPACT DISC PLAYBACK
1 . Press the STANDBY
2 . Set to CD
button.
5. Close the CD door.
The disc will rotate and the total tracks of the disc will show on the display.
FUNCTION
CD
6. 3 . Open the disc holder by pushing the CD door
open button.
Press the PLAY/PAUSE
button.
Track number "01" ," CD "& the symbol "
" will
be shown during normal compact disc playback.
CD display
4. Insert a disc with the label side facing up.
TO INTERRUPT PLAYBACK
Press the Play/Pause
button and the symbol
" " will flash. Press the button again to
resume playback.
TO STOP PLAYBACK
Press the STOP
button and the display shows
the total tracks of the disc.
CD display
TO SKIP TO THE BEGINNING OF A TRACK
•
Press either one of the skip buttons according to the desired skip direction.
•
Play/back resumes from the selected track.
•
When the button is pressed once during play, the previous track starts again.
•
When the button is pressed once during play, the next track plays.
SEARCHING FOR A PASSAGE WITHIN A TRACK
•
Keep the or button pressed during playback,
and release the button as soon as you recognise the desired
passage. Then normal CD playback will resume from this point.
IMPORTANT NOTICE
Automatic standby mode
To comply with the ErP2 directive, the unit automatically switches to standby after approx. 30 minutes without a
signal. (For instance in CD-Stop mode). To switch the unit on again, please follow the instructions mentioned in
instruction manual.
GB 3
REPEAT , REPEAT ALL AND MIX PLAYBACK
Press PLAY MODE button during CD playback.
CD plays with a single track repeat,
all tracks repeat or randomly.
PLAY MODE
FOR NORMAL COMPACT DISC PLAYBACK
Mode sequence REPEAT >> REPEAT ALL >> MIX >> CLEAR.
During Repeat 1 mode,
display shows
During Repeat 2 mode,
display shows
During Mix mode,
display shows
CD display
Note on CD-R/RW discs
- Because of non-standardized format definition/
production of CD-R/RW,
playback quality and performance are not guaranteed.
- Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions,
such as PC performance, writing software, media ability, etc.
- Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction.
- It is recommended to record only audio files on CD-R/RW discs for easy reading.
PROGRAM PLAYBACK
FOR NORMAL COMPACT DISC PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order.
Up to 20 tracks can be programmed.
1.
Press the “ PROGRAM/CLOCK-ADJ. “ button.
2.
Press the
skip buttons to select the desired track number.
3.
Press “ PROGRAM/CLOCK-ADJ. “ button again to memorize the track.
4.
Repeat steps 2 and 3 until all desired tracks are programmed.
5.
Press the “ PLAY/PAUSE “ button to start. “ PROGRAM “ is shown on the CD display.
6.
Press “ STOP “ button to stop programmed playback.
7.
Press “ PROGRAM/CLOCK-ADJ. “ and “ PLAY/PAUSE “ buttons to resume
programmed playback.
8.
Open the CD door, turn off the CD player or press the "STOP" button twice
to clear the programmed memory.
Note :
Programming can only be made when the player is in stop mode.
GB 4
CD display
TAPE PLAYBACK
1 . Set to TAPE
TO STOP PLAYBACK
Press the STOP / EJECT button.
FUNCTION
TAPE
TO INTERRUPT PLAYBACK
Press the PAUSE button.
To resume play, press the PAUSE button again.
TO FAST WIND
Press the REWIND or F.FWD button. Press the
STOP/EJECT button to stop winding at the desired
position.
2 . Insert the cassette.
3 . Press the
PLAY button.
PLAY
MAINTENANCE
CLEANING CD
If the CD skips or will not play , the disc may need cleaning
. Before playing, wipe the disc from the centre out with a
cleaning cloth. After playing, store the disc in its case.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly
wiping with a soft cloth.
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the
brush. Finger prints may be removed with a cotton swab
moistened with alcohol.
WARNING
Should the CD door be opened before the reading of the
CD completed, a jamming noise may occur. This is resolved
by closing the CD door.
IMPORTANT NOTE
If an abnormal display indication or an operating problem
occurs, disconnect the AC power cord and remove the
batteries. Wait at least 5 seconds, then reconnect the AC
power cord or reinstall the batteries.
GB 5
SPECIFICATIONS
CASSETTE SECTION
Track format:
Tape speed:
F.F. & REW time:
Frequency response:
2 track stereo
4.75 cm / sec.
170 sec. (F-60 tapes)
125 Hz - 8000 Hz (Normal tape)
CD SECTION
Channels:
S / N ratio:
Wow & Flutter: Sampling frequency:
Quantization:
Pick up light source: Pick up wave length
2 channels
60 dB
undetectable
44.1 kHz 8 x over sampling
1 bit DA converter
Semi - conductor laser
790 nm
RADIO SECTION
Tuning ranges:
Antennas:
FM 87.5 - 108.5 MHz
FM Rod antenna
GENERAL
Output power:
1W + 1W (RMS)
Power consumption:
9 .5 W
Speaker: 3" 8 OHM
Phones jack:
3.5MM
Power source: AC : 230V ~ 50Hz
DC : 12V ( 8 x 1.5V LR14/ "C"/UM2 )
Dimensions:
288(L) x 242(D) x 155(H)mm
Weight
1.9 KGS
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range
of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to
the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause
discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
If at any time in the future you should need to dispose of this product please note that: Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
GB 6
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement