Ecoxgear Portable Audio User Manual

Quick Start USER GUIDE
ECOXBT Models: GDI-EGBT500-510
Features & Operation
ECOXBT Control Buttons
LED Status Indicators:
POWER, BATTERY, Bluetooth
Diagram 1
Contol Buttons & LED’s
ON/OFF
Bluetooth
SPEAKER VOLUME
TRACK SELECTION
PLAY / PAUSE /
ANSWER
BATTERY
INDICATOR
How to pair your Smartphone
with your ECOXBT
ON/OFF
PRESS button
once to Power
ON / OFF
Bluetooth
STEP 1. Find & enable
Bluetooth on your
Smartphone/
SmartDevice
Green LED turns STEP 2. PRESS button
ON & unit
once on ECOXBT to
beeps within
initiate Bluetooth.
2-4 seconds
BLUE LED will blink
indicating
rapidly indicating ready
power fully
to pair.
initiated and
set ON
STEP 3. Find
“ECOXGEAR” on your
Smartphone as a pairing
selection & select
“ECOXGEAR” to pair
with ECOXBT
STEP 4. Select & play
your music!
Quick Start USER GUIDE
SPEAKER VOLUME
TRACK SELECTION
PRESS & hold button
to decrease ( -)
or increase ( + )
SPEAKER VOLUME
PRESS button once
to select PREVIOUS
SONG track &
NEXT SONG track
NOTE: set your
SMARTPHONE to
maximum volume
level for best audio
performance
NOTE: 1 short beep
tone will sound when
max. volume setting is
reached on the
ECOXBT
PLAY / PAUSE /
ANSWER
BATTERY
INDICATOR
PRESS button once
to PAUSE & PLAY a
song track and to
ANSWER Mobile
CALLS
(MUST be paired
with Bluetooth)
Connect USB to
power source.
LED indicates
charging status.
RED: charge in
process
GREEN: full charge
complete
PRESS button to
answer incoming
calls from your
SMARTPHONE.
Listen to the caller
over ECOXBT
speakers & talk
over the built-in
Microphone on the
front of the unit
NOTE: LED will blink
2 times every 30
seconds to indicate
approximately 30
minutes of play
time remains
Quick Start USER GUIDE
USB & AUX-IN CONNECTIONS
CAP, USB POWER & AUX-IN CONNECTIONS
 Pull tab on the cap to open the back panel
compartment for access to AUX-IN & USB
CHARGING connections
 AUX-IN can be used as an optional connection
to play an audio device using a 3.5mm audio
cable connection.
 Connect USB to computer or power outlet
using a USB to AC power adapter
Diagram 2
USB CONNECTION & CHARGING
 Charge the built-in rechargeable battery via USB cord (included) connected to your computer OR via a USB-toAC power adapter.
 When connected to a power source via the USB connection on the back panel, the Battery LED on the front
panel (refer to Diagram 1.) will indicate the power status. IF not connected to the charging cable, the LED will
NOT indicate the power status.
 RED LED indicates charging is in progress. A GREEN LED indicates the battery is fully charged.
 The Power LED will flash 2 times quickly every 30 seconds when approx. 30 minutes of playtime remain.
NOTE:
ECOXBT can charge while playing audio
Quick Start USER GUIDE
BACK PANEL & CAP
Diagram 3.1.
Diagram 3.2.
back panel cap line
gray rubber
cap gasket
IMPORTANT:
IF the cap is not securely closed the unit is NOT watertight & waterproof. To ensure the unit is
watertight, the back panel CAP MUST be closed securely.
To securely close the back panel CAP, the CAP MUST be inserted so that the lines on the CAP align with
the back panel lines and the top of the CAP is pushed flush with the back surface of the unit .
The gray rubber gasket around the edge of the cap cannot be seen.
Quick Start USER GUIDE
TIP: Bluetooth PAIRING once paired, should you wish to connect to an alternate device, open the Bluetooth Section within
Gracedigital
the device currently connected to the ECOXBT and remove the Bluetooth connection. The ECOXBT will then be available to pair
& connect to an alternate Bluetooth enabled Smartphone / Audio Device
FRONT PANEL
Diagram 4.1
SIDE PANEL
Diagram 4.2.
SPECIFICATIONS
Output Power:
Frequency Range:
Power Source:
Playtime:
Charging Options:
Charging Time:
Bluetooth:
RMS 6W (3 Watt x2 speakers /4 ohms)
135Hz-17,000Hz
Lithium Ion 3.7V 1800mAh Battery
10 + hours from full charge
USB to AC adapter or Computer
Approximately 2 ½ hours
Bluetooth® 2.1 + EDR
S/N Ratio:
Unit Size:
Unit Weight:
Storage Battery Temp.:
Operating Temperature:
Waterproof Rating:
88db +/- 3dB
2.8” x 9.0” x 4.0“
1.5 lbs
14°F to 131°F
23°F to 104°F
IPX7 & IPX8
IN THE BOX
ECOXBT Unit
User Guide
USB Cable
Carabiner Clip
USB-AC Power Adapter (for use with the USB Cable)
Lanyard (for use with the back panel Cap)
Quick Start USER GUIDE
FCC Compliance Statement & Warning: This device has been tested & found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. The device generates, uses & can radiate radio frequency energy & if not installed & used in accordance with
instructions may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a
particular installation IF this device causes interference to radio or television reception try one of these measures: reorient or relocate
the receiving antenna, increase separation between device & receiver, connect the device into an outlet on a circuit different from that
to which the receiver is connected, consult a dealer or experienced radio / TV technician for assistance. Changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to operate the device and/or void the
manufacturer’s limited warranty.
SAFETY ADVISORY & WARNING:
Follow all instructions. Use only as intended.
ATTENTION: Do NOT charge while the unit is wet.
Towel dry the unit AND make sure all connections
are dry BEFORE plugging in the charging connector
CAUTION:
Do NOT open to repair. A qualified technician must carry out repair work.
WARNING:
This product may contain chemicals listed in Proposition 65
WARNING:
WARNING:
ECOXBT has a built-in Lithium Ion battery. The battery must NOT be used in or near an open source or excessive heat
Danger of explosion if batter is incorrectly replaced. Replace only with the same or equivalent type.
ATTENTION:
AC adaptor is a device forming a part of the main plug therefore the AC adaptor can always be readily disconnected from
AC socket-outlet.
CARE, MAINTENANCE & PRECAUTIONS
1. The unit is waterproof when the RUBBER CAP is properly closed.
2. Close the CAP properly before use, see ‘diagram 4’ for reference. If the unit is placed in water
without the cap properly closed, water may enter into the unit and void your warranty.
3. Dry unit completely before opening the cap. Do NOT open the cap if wet or in a wet environment.
4. Do NOT apply excessive force to any surfaces of the unit when wet or in a wet environment.
5. Do NOT use or store the unit in places with high temperature.
6. AVOID prolonged exposure to ultraviolet radiation (UV sunlight) and strong magnetic fields.
7. Periodically check the rubber seal for premature wear.
Quick Start USER GUIDE
8. Periodically clean the rubber with a soft moist cloth and ensure no objects such as dirt,
hair, sand are on the rubber seal ring. Do NOT use any oily solvent or chemicals for cleaning.
9. Rinse off the unit with tap water after use in salt water or swimming pool.
10. Power and/or charge the built-in rechargeable battery for portable use by connecting the USB cord
to a computer USB connection or to an AC outlet using the AC-to-USB cord power adapter.
11. Noise and audio distortion may occur when the batteries are nearing end of charge.
12. Do NOT remove the built-in battery. Do NOT remove the grill covers.
Ecoxgear radios
Portable audio
Download PDF