SURFACE WALL MOUNT LUMINAIRE: FL300 INSTALLATION

INSTALLATION OPERATION INSTRUCTIONS
PREPARING THE LUMINAIRE
SURFACE WALL MOUNT LUMINAIRE: FL300
2x 8-32 Screw
(Provided)
J-Box Mounting Bracket
(Provided)
Step 1
2x Set Screw
(Provided)
2x 8-32 Hex Nut
(Provided)
Lens Enclosure
(Provided)
SAVE THIS INSTRUCTIONS
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE
INSTALLATION. IF YOU ARE NOT FAMILIAR WITH THE
NATIONAL ELECTRICAL CODE (NEC), CONTACT A
QUALIFIED ELECTRICIAN TO INSTALL THIS LUMINAIRE.
WARNING.- Before installing this luminaire or doing any
Lamp Enclosure
(Provided)
Mounting Plate
(Provided)
J-Box Mounting Plate
(Provided)
Step 1 - Disassemble Luminaire Parts for easy Installation:
a.- Remove Mounting Plates and Lens Enclosure if need to install Lamp.
2x 8-32 Screw
(Provided)
Step 2
J-Box Mounting Bracket
(Provided)
maintenance, turn off the power supply at the circuit breaker or
fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
NOTE:
To re-lamp, replacement parts or additional information,
contact or visit manufacturer at www.lumux.net
Mounting Plate
(Provided)
Step 5
2x Set Screw
(Provided)
2x Lock Washer
(Provided)
Electrical Box
(By Others)
2x J-Box Screw
(By Others)
Lamp Enclosure
(Provided)
Step 2 - Install Mounting Bracket:
a.- Insert the two 8-32 Screws (provided) through the Slots,
use the Lock Washer to secure tight.
b.- Place the Bracket onto the Electrical Box and secure it using two
J-Box Screws (By others).
J-Box Mounting Bracket
(Provided)
2x Set Screw
(Provided)
Electrical Box
(By Others)
J-Box Mounting Plate
(Provided)
Step 5 - Install Lamp Enclosure:
a.- Place Lamp Enclosure onto the Mounting Plate secure using the two
Set Screws (provided).
Step 3
Step 6
2x 8-32 Hex Nut
(Provided)
Lamp
(By Others)
Lamp Enclosure
(Provided)
Electrical Box
(By Others)
Mounting Plate
(Provided)
J-Box Mounting Plate
(Provided)
Ground
White
Black
J-Box Mounting Plate
(Provided)
Step 6 - Install Lamp (Optional):
Ground
Supply
Wires
Lamp Enclosure
(Provided)
Electrical Box
(By Others)
Wire Diagram
a.- Install Lamp when applicable and replace Lens Enclosure by screw it
onto the Lamp Enclosure.
White
Black
FINAL INSTALLATION
Step 3 - Make Wiring Connections:
a.- Run the Electrical Wires through all the Parts and make
hard-wire connections, see Wire Diagram.
J-Box Mounting Bracket
(Provided)
2x Set Screw
(Provided)
2x 8-32 Hex Nut
(Provided)
Step 4
Lamp Enclosure
(Provided)
Electrical Box
(By Others)
Lens Enclosure
(Provided)
J-Box Mounting Plate
(Provided)
Mounting Plate
(Provided)
Step 4 - Install Mounting Plates:
a.- Place Mounting Plates allowing the Screws pass through the holes
and fasten using the Hex Nuts (provided).
LUMUX - ARCHITECTURAL LIGHTING COMPANY- Toll Free 877- 895-5552 www.Lumux.net
Step 7
Download PDF