iConverter
®
iConverter NMM2
Network Management Module
The iConverter NMM2 provides comprehensive remote
monitoring, configuration and alarm notification functions for all
iConverter managed media converters and Network Interface
Devices (NIDs). Installed in any slot of an iConverter chassis,
the NMM2 manages all other modules and power supplies
installed in the chassis through a high-speed management
backplane. Additionally, all remote NIDs linked to the managed
iConverter chassis can be managed by the installed NMM2
through a secure IP-less management channel.
Through the 10/100 RJ-45 Ethernet port, the NMM2 can
be remotely accessed by IP-based management protocols,
including SNMPv1/2c/3, TELNET and FTP. The serial
console port provides local access and initial configuration
from an RS-232 terminal. Management is accessed either via
NetOutlook®, Omnitron’s SNMP Management Software, or
by any third party SNMP management software. An intuitive
Command Line Interface (CLI) can be accessed either via the
serial port or TELNET.
The NMM2 provides real-time management, continuously
collecting system status and module information. It reports the
collected status to the network management applications and
displays LED alarms for chassis power supplies. The NMM2
also provides comprehensive provisioning support for all local
and remote iConverter modules, including port settings, VLANs
and rate limiting. Network alarms are forwarded as traps to
multiple trap hosts and recorded in a persistent system log.
In the event of a power outage, the NMM2 supports dying
gasp SNMP trap notification when installed in a 1-Module or
2-Module chassis with dying gasp support.
The NMM2 manages remote NIDs connected to the managed
chassis via an IP-less management channel. Utilizing IEEE
802.3ah extensions, an NMM2 in a chassis at the network core
can use a single IP address to manage up to 18 iConverter
Network Interface Devices (NIDs) at different edge locations.
This capability simplifies IP address management, improves
network security and conserves the use of IP addresses.
KEY FEATURES
■■ Provides real-time management, trap notification and
remote configuration
■■ Supports SNMPv1, SNMPv2c, SNMPv3 and Telnet
protocols
■■ SNMP management via Omnitron’s NetOutlook®
management software, or third-party SNMP
management software
■■ Password protected to prevent unauthorized access
■■ Utilizes IEEE 802.3ah OAM extensions and Omnitron’s
Secure OAM for IP-Less management
■■ Management access available through the RJ-45
Ethernet port, serial port or from an adjacent module
across the Ethernet backplane
■■ 10/100Mbps RJ-45 port supports auto or manual
negotiation and auto-crossover
■■ Commercial (0 to 50°C), wide (-40 to 60°C) and
extended (-40 to 75°C) temperature ranges
■■ LED displays for immediate visual status of each port
■■ Hot-swappable in 19-Module, 5-Module, or 2-Module
chassis
■■ Lifetime Warranty and free 24/7 Technical Support
SPECIFICATIONS
Description
Standard
Compliances
MANAGEMENT
iConverter NMM2
Network Management Module
IEEE 802.3
RFC1155, RFC1156, RFC1157, RFC1212, RFC1213, OST MIB
MEF 9, 14, 21
Management
Telnet, SNMPv1, SNMPv2c, SNMPv3, Serial Console
Regulatory
Compliances
UL, CE, FCC Class A, NEBS Level 3, RoHS2 (6/6), WEEE,
REACH
Frame Size
Up to 2,048 bytes
Copper:
Port Types
Serial:
10/100BASE-T (RJ-45)
RS-232 (Mini DIN-6 female)
Mini DIN-6 to DB-9 adapter included
Copper:
Cable Types
Serial:
DC Power
Requirements
DC Input:
(Backplane)
EIA/TIA 568 A/B, Category 5 and higher
RS-232, 22 to 24 AWG, 12 to 50 pF/ft
3.3VDC, 0.9A @ 3.3VDC
Dimensions
W: 0.85” x D: 4.5” x H: 2.8”
L: 21.6 mm x B: 114.3 mm x H: 71.1 mm
Weight
8 oz.; 226.8 grams
Commercial:
Wide:
Extended:
Storage:
Temperature
0 to 50°C
-40 to 60°C
-40 to 75°C
-40 to 80°C
Humidity
5% to 95% (non-condensing)
Altitude
-100m to 4,000m
MTBF (hours)
600,000
Warranty
Lifetime warranty and 24/7/365 free Technical Support
Active Controls
■■ Link Propagate/Link Segment
■■ Remote Fault Detection
■■ Module Name
■■ Chassis Name and Number
■■ IP Address
■■ 802.3ah OAM Enable
■■ Secure IP-less OAM Enable
■■ Subnet Mask
■■ Gateway
■■ Management Port Disable
■■ Alarm Threshold Setting
■■ Software updates via FTP
■■ Telnet
■■ Trap IPs
■■ FTP Enable
■■ Password Selection
■■ Soft Switch Reload
Alarms / Traps
■■ Warm Start
■■ Link Up/Down
■■ Chassis Insertion/Removal
■■ Authentication Failure
■■ Configuration Change
■■ Temperature Out-of-Range
■■ Power Supply Out-of-Range
■■ Power Supply Insertion/Removal
■■ Module Reset
■■
■■
■■
■■
■■
■■
Module Reset
Module Insertion/Removal
Port Link State Change
FTP Session Open/Close
Telnet Session Open/Close
Dying Gasp (Power Loss
Trap)
Chassis Status
■■ Power Status
■■ Power Output Voltage
■■ Chassis Temperature
Module Status
■■ Module Power
■■ Link Status
■■ Diagnostic Status
■■ Management
Module Information
■■ Module Type
■■ Slot Occupied
■■ Part Number
■■ Serial Number
■■ Configuration
■■ Revision
■■ Ports on Module
■■ User-defined Identifier
APPLICATION EXAMPLE
ORDERING INFORMATION
Model Number
8000N-0
In this application example, iConverter 10/100M2 plug-in
modules are installed in the 19-Module chassis, and connected
via the fiber link to a standalone 10/100M2 Network Interface
Device (NID). With an NNM2 installed in the 19-Module
chassis, an IP-less management channel between the
10/100M2 link partners is established. The IP address resides
only at the network core (NMM2), and does not exist on the
customer network.
Description
iConverter NMM2 Module
For wide temperature (-40 to 60°C), add a “W” to the end of the model number.
For extended temperature (-40 to 75°C), add a “Z” to the end of the model number.
Contact Omnitron for RoHS (5/6) compliant models.
Accessories
Model Number
Description
8081-3
NMM2 Serial Cable (DB-9 Male to Female - 3ft.)
8082-0
NMM2 DIN-6 to DB-9 Female Adapter Cable
© 2016 Omnitron Systems Technology, Inc. All rights reserved. iConverter and NetOutlook are Registered Trademarks of Omnitron Systems
Technology, Inc. Trademarks are owned by their respective companies. Specifications are subject to change without notice.
091-8000N-001E
5/16
800-675-8410 • 949-250-6510 • www.omnitron-systems.com • info@omnitron-systems.com • 38 Tesla, Irvine, CA 92618
iConverter NMM2
Page2
Download PDF