Supported Firewire Cards for KODAK Scanners

Supported Firewire (IEEE1394) cards for Kodak Scanners
Kodak Alaris has tested the following two firewire cards for use with Kodak document scanners. Other cards may not work
reliably with Kodak iSeries scanners.
Option #1 (for PCs with PCI slot)
Option #2 (for PCs with PCIe slot)
This is a custom PCI card built for Kodak by Koutech
Inc. and marked with “KEC 1582T”. It has been
shipped with Kodak scanners since May 2004 and is
not available on the open market. This custom card
has the fuses for the 5V power removed to prevent
damage to the scanners if the firewire cable is
plugged into the scanner upside down.
This PCIe card was not included with any Kodak
scanners, but is available as an accessory for
Kodak firewire scanners. The card will be
marked with “SIIG” and “v2.0”. It uses a PCIe 1x
slot within the host PC. This card includes a low
profile bracket. The included on board power
connector is not required for Kodak Scanners.
This card uses a PCI slot within the host PC.
This card uses a PCIe slot within the host PC.
PCI card can be purchased as a replacement part
through Kodak Alaris Service and Support.
Part #: 4F5114
PCIe card can be purchased as an accessory
through Kodak Alaris Service and Support.
Catalog #: 156 7684
(Note: Prior to May 2004 a diffe rent “Smart Modular” firewire card
was shipped with Kodak Scanners. This ca rd has not been tested on
modern PCs.)
Coverage
Service
Contract
No Service
Contract
Firewire Card
Part or Catalog#
Is this card covered?
PCI
Part# 4f5114
This card is covered under Service Contract
PCI e
Cat# 1567684
This card can be purchased
PCI
Part# 4f5114
This card can be purchased
PCI e
Cat# 1567684
This card can be purchased
Download PDF